I did an engine swap on my 95 EG CX, jdm b16a sir2... When I turn the ignition ON all 4 injectors start pumping gas into the engine and the engine gets flooded... I try changing the MAP sensor but still... I have no idea where to start checking... Any ideas guys???
check all wiring from the P2 injector plug to the ecu. The computer controls injector pluse width on the ground side to the ecu. The reason this is done is because of voltage spikes and also if there was ever a short to ground before the injector the injector would be inoperative and throw a code. Unfortunely it sounds like you have a short to ground on the controlled side. I would check your ground side of the injector plug first.
I realize this is an old post. But it never had a resolution. So for those of you searching...this problem (for me at least) was caused by a fried ecu. I switched out the ecu and it fixed the problem. I am, however, still dealing with the effects of a flooded engine.
__________________ kill your local car thief ★Parts ★WTB 99-00 OEM hatch tail lights
ya bumb have a 97 dx switched ecu switched cold start map engine harness' its spitting sputterering at idle rev it up fine but rich as hell! done cam sensor coil every normal thing think off cleaned injectors everything stumped dd! need it running (normal)
Honda and the Honda marquee are registered trademarks of the American Honda Motor Company, Inc. Neither American Honda Motor Company nor its subsidiaries or affiliates shall bear any responsibility for Honda-Tech.com content, comments, or advertising. Honda-Tech.com is not affiliated with American Honda Motor Company in any way. American Honda Motor Company does not sponsor, support, or endorse Honda-Tech.com in any way.
Copyright/trademark/sales mark infringements are not intended or implied.