Chipped p28 and scan tool problem
04-17-2003, 07:42 PM
#1
Honda-Tech Member
Thread Starter
Join Date: Apr 2003
Location: Chicago, IL, USA
Posts: 141
Likes: 0
Received 0 Likes
on
0 Posts
Chipped p28 and scan tool problem
I just put in my jun chipped ecu in my integra ls before I do my vtec conversion to test out the ecu and the honda pgm scan tool can't communicate with it. I also noticed a poor idle and surging at low rpm, closed throttle deceleration. Will that go away with the vtec head? Is anyone able to use the Scan tool with thier chipped p28s? It does not have any trouble codes other than the vtec solenoid/pressure codes which were expected. Any help would be appreciated.
04-17-2003, 11:28 PM
#2
Member
Join Date: Sep 2002
Location: V8KO, One down. One to Go.
Posts: 3,624
Likes: 0
Received 0 Likes
on
0 Posts
Re: Chipped p28 and scan tool problem (tegmaniac)
I have a Kenji chipped P28 and it wouldn't work with a scan tool either. When I first started the car the idle was a little funky. My friend (honda mech) said let it idle for a few minutes and wahlah after about ten minutes it corrected itself and idles great.
Thread
Thread Starter
Forum
Replies
Last Post
SkoundrelUSA
Honda Civic / Del Sol (1992 - 2000)
29
11-10-2005 06:28 PM
willyboyK20
Honda Civic / Del Sol (1992 - 2000)
7
04-11-2005 04:43 PM
Combustion Contraption
Hybrid / Engine Swaps
13
04-04-2004 09:29 AM
