check engine light is on and wont go over 3000 rpm
i recently changed my tranny, and everything worked fine until about 2 mins after its on the check engine light comes on and it runs like crap(wont go over 3000 rpm), i made sure all of my connections are plugged in about 50 times. a buddy of mine says it could be my map sensor and i called a couple of mechanics and they all said the same thing. and i also heard that theres a way to jump some wire to give me a code to tell me exactaly whats wrong with it, but i dont know how to do that either, can anyone give me advice???
Re: check engine light is on and wont go over 3000 rpm (BRAWDY03)
Check your grounds especially, the one on the thermostat housing. I have seen this many times before. Also pull up your carpet and see which code it is throwing. Make sure if you do find a loose or disconnected ground that you reset your ECU
Re: check engine light is on and wont go over 3000 rpm
ok.. i got the same problem.. 2006 civic si.. the car was on a mini accident.. i fixed it.. changed the intake because the stock 1 was messed up... i had to buy the MAF sensor.. so i put it in... now it wont go over 3000 rpm with out the sensor connected.. when i connect the sensor the cars goes over 3000.. but shuts off... it wont stay on for more than 10 secs... i too it to auto zone.. the codes say the MAF and IAT is bad.. thats all.. but i bout the MAF brand new at the dealer.. what else could it be??
Honda and the Honda marquee are registered trademarks of the American Honda Motor Company, Inc. Neither American Honda Motor Company nor its subsidiaries or affiliates shall bear any responsibility for Honda-Tech.com content, comments, or advertising. Honda-Tech.com is not affiliated with American Honda Motor Company in any way. American Honda Motor Company does not sponsor, support, or endorse Honda-Tech.com in any way.
Copyright/trademark/sales mark infringements are not intended or implied.