zduncan1

I need some help figuring out what these plugs/wires go to.
One pics is two wires, a green w/ white stripe, and a red w/ yellow stripe. These wires are bundled together, and were in the the loom with the injector harness.
The other pic is of a two wire with connector. Black wire w/ yellow stripe, and blue wire. This connector is with the oil pressure switch, alternator wires.
The final wires are a single connector wire, and a single wire. I assume they go together, but unsure. The yellow with green stripe wire with the connector was in the black boot. The boot has two areas for wires, so I assume the yellow with red stripe wire just got the connector cut off of it? Thanks for any and all help.

Harness is from a 1990 Honda Hatch SI, previous owner was using it as obd1 some things got hacked, so just trying to clean it up a little bit lol

1991civiclx13

First pic with the Green/White and Red/Yellow should be you TA sensor.
Second pic with the Yellow/Green would be coolant temperature switch, and the Yellow/Red I'm not sure... MAP sensor?
Third pic would be the Purge Cut-Off Solenoid Valve

zduncan1

I think if I remember correctly the map sensor plug comes off the cars harness since the map is mounted on the firewall on these cars if I remember correctly

10psiLsEf2

That square connector goes connected somewere around the master cylinder from fsctory its mounted on the booster. Idk exactly what its for doe

zduncan1

And are you sure the yellow with green stripe with is coolant temp? Because I have a yellow with green stripe wire already in the loom that goes to the bottom of the head, this other wire was in the loom behind the block/alternator area

zduncan1

This is what I have so far. I have those blank wires, in addition to these connectors. If anyone can chime in on what else is missing, or the wire that has no connector, or how to add in the wires I need to add, it would help. lol I know Im missing the reverse light wiring, that the map wiring is in the chassis wiring, and o2 wiring.