EAGLE RODS WONT FIT FOR TURBO SETUP...NEED HELP!!!
#1
Thread Starter
Join Date: Feb 2004
Location: Ottawa, Ont, Canada
Posts: 114
Likes: 0
Received 0 Likes
on
0 Posts
EAGLE RODS WONT FIT FOR TURBO SETUP...NEED HELP!!!
Just what it says, I bought a set of Eagle H-beam rods and they just wont fit. I pulled the motor and took out the crank, switched the bearings over, put the SRP pistons on and then put the crank back in. Now i put the rods down with pistons attached of course and once i put the rods together and try to spin the crank, it only goes halfway because the rods touch the wall, the very bottom of it.
What shold i do???
What shold i do???
#3
Honda-Tech Member
Re: EAGLE RODS WONT FIT FOR TURBO SETUP...NEED HELP!!! (slammedcoupe)
if this is a d series you must notch the bottom of the cylenders, do a search it a very comon thing with after market rods in a d series
Thread
Thread Starter
Forum
Replies
Last Post
slammedcoupe
Honda Civic / Del Sol (1992 - 2000)
3
07-18-2004 06:53 PM