Blox valve spring and skunk2 pro 2 cams
#1
Blox valve spring and skunk2 pro 2 cams
I have blox dual springs and ti retainers. I'm about to upgrade to skunk2 pro 2 cams. Will the blox springs be able to handle these cams?
#3
#4
Re: Blox valve spring and skunk2 pro 2 cams
Supertech had suggested their SPR-H100DR for use with Pro2 cams when I contacted them. Hope that helps
Or you can run Skunk2 Pro series valve train....
Or you can run Skunk2 Pro series valve train....
#5
Honda-Tech Member
Re: Blox valve spring and skunk2 pro 2 cams
#6
Honda-Tech Member
Join Date: Aug 2009
Location: Baton Rouge,Louisiana
Posts: 7,635
Likes: 0
Received 3 Likes
on
3 Posts
Re: Blox valve spring and skunk2 pro 2 cams
The pro series VT has a 62lbs seat pressure, i'm believe the tuner vt is lower, thus making the blox vt lower.
I would also, run ST.
#7
Re: Blox valve spring and skunk2 pro 2 cams
Trending Topics
#11
Honda-Tech Member
Join Date: Aug 2009
Location: Baton Rouge,Louisiana
Posts: 7,635
Likes: 0
Received 3 Likes
on
3 Posts
Re: Blox valve spring and skunk2 pro 2 cams
The guy that does all of my machining as well as the machine work for my customers and business does all of this. This is what he measured with the springs i sent him.
Now that I think about it, maybe i was talking about retainer height and had a brain fart. *shrugs* In anycase, 62lbs is the seat pressure for pro series springs and is the "minimal" required by sk2. I'm "assuming" by uncle dave saying what does your head have, means whats the actual pressure of the springs.. its also very possible that due to it being so hot, that i'm working on half a brain. Either or.
I believe i have a pic of my spring seat pressure measurements and retainer height measured as well floating around here.
Now that I think about it, maybe i was talking about retainer height and had a brain fart. *shrugs* In anycase, 62lbs is the seat pressure for pro series springs and is the "minimal" required by sk2. I'm "assuming" by uncle dave saying what does your head have, means whats the actual pressure of the springs.. its also very possible that due to it being so hot, that i'm working on half a brain. Either or.
I believe i have a pic of my spring seat pressure measurements and retainer height measured as well floating around here.
Last edited by DDTECH; 06-12-2013 at 11:38 AM.
#12
Re: Blox valve spring and skunk2 pro 2 cams
I see what you are getting at. The springs need to be tested as if they are installed in the head, i.e. with the retainer and spring seat, which is how I measure them.
Thread
Thread Starter
Forum
Replies
Last Post
Brandeezy1
All Motor / Naturally Aspirated
11
02-11-2014 02:59 AM
FusionEg6
For Sale
4
09-11-2003 10:23 PM