ABS modulator bleed procedure?
04-09-2024, 01:16 PM
#1
Honda-Tech Member
Thread Starter
Join Date: Mar 2024
Posts: 10
Likes: 0
Received 0 Likes
on
0 Posts
ABS modulator bleed procedure?
1994 honda accord DX (with antilock brake system)
What is the proper way to bleed the modulator? There is a bleed valve/screw on the top of the module itself. I am replacing every line in the vehicle and air will get into the module so I need to know proper bleed procedure. I noticed if I remove the signal wire (but keep ground connected) on the brake fluid reservoir level sensor, the abs pump cycles with KOEO
What is the proper way to bleed the modulator? There is a bleed valve/screw on the top of the module itself. I am replacing every line in the vehicle and air will get into the module so I need to know proper bleed procedure. I noticed if I remove the signal wire (but keep ground connected) on the brake fluid reservoir level sensor, the abs pump cycles with KOEO
04-12-2024, 05:41 PM
#3
Honda-Tech Member
Thread Starter
Join Date: Mar 2024
Posts: 10
Likes: 0
Received 0 Likes
on
0 Posts
Re: ABS modulator bleed procedure?
Yes ineed, thankyou so much for the reply! I am running all new brake lines and thought while I am at it might as well run the master cyl to modulator lines but I know I am gonna get air into the modulator, thanks so much!
Thread
Thread Starter
Forum
Replies
Last Post