Changing studs??
#1
Honda-Tech Member
Thread Starter
Changing studs??
What is the best way to change the studs in the front of my integra some people say you have to remove the hub and I hear that you don't thanks for any advise
#3
Honda-Tech Member
Join Date: Jan 2007
Location: WOOGIE BOOGIE
Posts: 3,929
Likes: 0
Received 0 Likes
on
0 Posts
Re: Changing studs??
remove wheel
remove caliber
remove rotor
remove axle nut
insert slap hammer (pound away)
vise put hub tighten down
tighten lug loosely to stud smack it loose.
remove lug once loose and slip stud out. (so stud doesn't fly)
fyi put the stud in the freezer
air hammer
once done
slap hammer back on the studs
pound away again
put axle bolt back on to drawl in hub to wheel bearing.
once tight rotor and calibur and wheel.
*aftermarket stud* might have to grind down the stud so i doesn't rub.
remove caliber
remove rotor
remove axle nut
insert slap hammer (pound away)
vise put hub tighten down
tighten lug loosely to stud smack it loose.
remove lug once loose and slip stud out. (so stud doesn't fly)
fyi put the stud in the freezer
air hammer
once done
slap hammer back on the studs
pound away again
put axle bolt back on to drawl in hub to wheel bearing.
once tight rotor and calibur and wheel.
*aftermarket stud* might have to grind down the stud so i doesn't rub.
#5
Honda-Tech Member
Join Date: Jan 2007
Location: WOOGIE BOOGIE
Posts: 3,929
Likes: 0
Received 0 Likes
on
0 Posts
Re: Changing studs??
mildly slap it back on twist the hub around if it touches then grind it. the skunk2 extended on eg and dc you must grind the stud towards the hub. plus grease them
Thread
Thread Starter
Forum
Replies
Last Post
typeeg
Hybrid / Engine Swaps
8
07-20-2004 05:21 PM