ecko_3420

iTrader: (1)

I just got a benen tripod front strut bar and would like to know what size hole to drill and nuts and bolts to use? Ive searched and none of the thread specified the size to use.. Thanks...I have a 97 civic hatchback...

ecko_3420

iTrader: (1)

bump

mynameizstitch

should already have holes there. cuz on the eg6 there are holes there already and you will need a size 10 bolt. just take one of the bolt from your hood and go to a hardware store and buy the same bolt.

Meoshe

iTrader: (3)

Take it to the hardware store with you and browse their grade 8 bins for whatever fits. Then just use a drill bit that is right around the same size.

to stitch: 96-00 civics don't have the holes like earlier models.

ecko_3420

iTrader: (1)

grade 8? i read about that earlier...is there really a dif? how long should the bolts be?

Meoshe

iTrader: (3)

There is a difference in strength, I would say 1 inch is fine.

STOCK_SOHC_DX

What? Carbing bar bolted to my fire wall of my EK, I just had to take out the black plastic plugs.

Meoshe

iTrader: (3)

Yeah that's because it mounts to the tophat studs. Note: I think he is talking about the mounts at the shock tower. The benen mounts to the top of the shock towers like the ITR/CTR/SI/GSR ones.

STOCK_SOHC_DX

Oh that one, I remember I used the biggest ones that could fit the Mugen bar grade 8. On my friends car that we did wire tuck we got a body shop to actually order the whole SI shoulder and remove and replace that was gangster.

TheJGB3

Yes 'grade 8' hardware is for automotive applications (harder/stronger steel).

taggart_lumpy

watch how long the bolts are though
depending on how low you are they may hit you front upper control arm

hOnda_hiEn

stick the bolts up from under.. LoL..

sanegb16

iTrader: (2)

thats what i do haha

rick_rabies

...weld it