Auto harness w/ manual
#1
Honda-Tech Member
Thread Starter
Auto harness w/ manual
Ok my old wiring harness took a dump on me, so im replacing it with a new one.
My old wiring harness was a 98 LS obd2a that i ran with my ITR swap. I picked up a 98 LS harness but it is out of a auto. My dizzy plug is the same which was my main concern. Now my next question is I've been trolling through wiring diagrams bust **** is starting to mesh togather.
Will this harness work with my manual or are their wires I am going to have to swap around? Any repining? Am i able to just remove the wires for the auto sensors?
My old wiring harness was a 98 LS obd2a that i ran with my ITR swap. I picked up a 98 LS harness but it is out of a auto. My dizzy plug is the same which was my main concern. Now my next question is I've been trolling through wiring diagrams bust **** is starting to mesh togather.
Will this harness work with my manual or are their wires I am going to have to swap around? Any repining? Am i able to just remove the wires for the auto sensors?
#2
Honda-Tech Member
Thread Starter
Re: Auto harness w/ manual
Nobody eh.
Well for future referances, After looking at wiring diagrams forever, The harness appears it should work. So im going to remove the auto wires and connector completly
Well for future referances, After looking at wiring diagrams forever, The harness appears it should work. So im going to remove the auto wires and connector completly
#5
Honda-Tech Member
Thread Starter
Re: Auto harness w/ manual
So the engine started and run rough but thats to be expected it has sat for about 6 months.
My tach is inop though. So anybody have any insight as to what i have to switch
My tach is inop though. So anybody have any insight as to what i have to switch
Thread
Thread Starter
Forum
Replies
Last Post
eebaker
Honda CRX / EF Civic (1988 - 1991)
4
11-19-2017 04:47 AM
turboed4life
Honda Civic / Del Sol (1992 - 2000)
3
12-13-2004 04:20 PM
DevinW
Tech / Misc
3
03-21-2003 05:22 AM