vafc wiring
#2
Honda-Tech Member
iTrader: (1)
Join Date: Mar 2005
Location: kapolei, hawaii
Posts: 1,302
Likes: 0
Received 0 Likes
on
0 Posts
its in the FAQ up top.
but here you go
V-AFC VTEC controller -------> ECU PIN location
Red & Orange wire splice/connect to A15 (yellow/black)
Green wire RPM signal splice/connect to B15 (white1)
Pink wire VTEC signal output to VTEC solenoid (green/yellow)
Purple wire VTEC signal input not used on PM6 ecu
Blue wire VTM signal not used on PM6 ecu
Gray wire Throttle signal splice/connect to C7 (red/blue wire)
Yellow wire Pressure signal output cut/connect to C11 ECU side harness
Si/Hf = white1 , DX = orange
White wire Pressure signal input cut/connect to C11 ENGINE side harness
Si/Hf = white1 , DX = orange
Black wire Ground splice/connect to A16 (brown/black wire)Engine side harness
Brown wire Ground splice/connect to A16 (brown/black wire)has to be connected closer to the ECU
but here you go
V-AFC VTEC controller -------> ECU PIN location
Red & Orange wire splice/connect to A15 (yellow/black)
Green wire RPM signal splice/connect to B15 (white1)
Pink wire VTEC signal output to VTEC solenoid (green/yellow)
Purple wire VTEC signal input not used on PM6 ecu
Blue wire VTM signal not used on PM6 ecu
Gray wire Throttle signal splice/connect to C7 (red/blue wire)
Yellow wire Pressure signal output cut/connect to C11 ECU side harness
Si/Hf = white1 , DX = orange
White wire Pressure signal input cut/connect to C11 ENGINE side harness
Si/Hf = white1 , DX = orange
Black wire Ground splice/connect to A16 (brown/black wire)Engine side harness
Brown wire Ground splice/connect to A16 (brown/black wire)has to be connected closer to the ECU
#4
Thread Starter
Join Date: Apr 2007
Location: oceanside, ca, us
Posts: 193
Likes: 0
Received 0 Likes
on
0 Posts
Re: (***$nyper)
just finished up the wiring thanks, im gunna go crome once my project hatchey is running, im just hooking up the vafc ii if i need to go wide open throttle, becuz im just gunna baby it until i break in the motor so itll just be running off the o2 sensor that i just convert to 4 wire
Thread
Thread Starter
Forum
Replies
Last Post