Shikaido2004

I have just fired up my b16 for the first time its running a little on the rough side Im not sure why it possibly could be anything....has anyone faced this type of problem and what did you do to fix it? Im using the obd0 sir 88-91 b16a.....

stevew84

make sure all the engine/tranny mounts are tight.

savage91turtle

i have the exact same problem i need help as well with that problem

sanimalp

are you throwing any codes?

fireant

I'd start by double checking whether the timing belt is exactly right on the correct tooth, and whether it is properly tensioned.

Shikaido2004

On timing do the up arrows face vertically up or toward each other, Im not sure how to check timing? I have adjusted the Throttle position sensor and its running alot better, only problem is its idling about 1300rpm should i adjust it a little more or what could be cuasing the higher idle? I did idle at 1900rpm but it went down after the car ran for 5min to 1300rpm...

(760)doogie

the up on the cam gears should point up at top ded center, but you look at the little lines at like 9 o'clock on the cam gears, you should line up the cam gears using those, use a ruler os some sort of straight edge , the little lines should line up with the botls too. i could be wrong though but im pretty sure im right

EFSiR

are your ignition wires connected properly with the corresponding # plugs???