blox turbo mani shaving problems
#1
Honda-Tech Member
Thread Starter
Join Date: May 2004
Location: Uden, Holland
Posts: 390
Likes: 0
Received 0 Likes
on
0 Posts
blox turbo mani shaving problems
is it almost impossible to fit a t3t4oe and a blox with a tial38 to a b16 without shaving? i read a lot of post but i dont know if annybody had unfixable problems with it
thanks!
thanks!
#2
Re: blox turbo mani shaving problems (dnbruut)
blox is kinda like the revhard you wil have to shave a lil bit of the webbing of the block... if you use a t3/t04B or a stright t3 you do not need to shave anything but if your using t3/t4e or t3/to4S you will need to trim it down
#3
Honda-Tech Member
Join Date: Sep 2003
Location: Skmotoring.com
Posts: 2,438
Likes: 0
Received 0 Likes
on
0 Posts
Re: blox turbo mani shaving problems (Camp1320motorsports)
are you talkin about shaving the block or the head for the wastegate? Because the tial is gonna be a tight fit.
#4
Guest
Posts: n/a
Re: blox turbo mani shaving problems (jdmhonda)
Why these companys dont think of this **** beforehand is beyond me. It just makes it that much less appealing to get. Especially when the Blox manifold is like 400 brand new. You are pretty close to being able to just get a EL mani.
#5
Honda-Tech Member
Thread Starter
Join Date: May 2004
Location: Uden, Holland
Posts: 390
Likes: 0
Received 0 Likes
on
0 Posts
Re: blox turbo mani shaving problems (95GSRTT)
annybody tried to use more than one gaskets to make it work?
btw whats going to be the problem? the tial hitting the head or the t3to4e hitting the block?
thanks!
btw whats going to be the problem? the tial hitting the head or the t3to4e hitting the block?
thanks!
#6
Honda-Tech Member
Join Date: Jan 2003
Location: Tamworth, England, England
Posts: 455
Likes: 0
Received 0 Likes
on
0 Posts
Re: blox turbo mani shaving problems (dnbruut)
I test fitted my Blox to my JDM Teg last night
NO problems with bolting to head, no grinding needed. However the WG flange mating face is deffo tilted towards the camcover.
Im trying to get a T3/t04B if this fits withough grinding w00t.
NO problems with bolting to head, no grinding needed. However the WG flange mating face is deffo tilted towards the camcover.
Im trying to get a T3/t04B if this fits withough grinding w00t.
Thread
Thread Starter
Forum
Replies
Last Post
hatchinprogress
Forced Induction
3
01-24-2006 04:11 PM