crx electrical maelstrom
#1
Honda-Tech Member
Thread Starter
Join Date: Feb 2006
Location: Richmond, Va, United States
Posts: 46
Likes: 0
Received 0 Likes
on
0 Posts
crx electrical maelstrom
ok my 91 si with a b20/b16 trans is arcing electricity grime the starter to the trans when I use a starter gun, if I try just using the ignition switch it just clicks, all the grounds are there, valve cover/trans/thermo housing, the lights work, the fuel pump primes, there is fuel, no cel's, all the sensors are connected I at my wits end anybody have any ideas of what it could be?
#3
Honda-Tech Member
Thread Starter
Join Date: Feb 2006
Location: Richmond, Va, United States
Posts: 46
Likes: 0
Received 0 Likes
on
0 Posts
Re: crx electrical maelstrom
i though about it but i didn't try it ill have to do it, Im not near the car at the moment, ill do that as soon a i get to it, would that be from the starter not being ground that it could possible cause this problem?
#4
Keyboard Humorist
Join Date: May 2002
Location: Granada Hills, Ca, USA
Posts: 9,814
Likes: 0
Received 9 Likes
on
7 Posts
Re: crx electrical maelstrom
I think maybe so?
"trans is arcing electricity grime the starter to the trans "
I found this pretty confusing, but I am assuming you are seeing arcing from the starter to the the trans housing.
"trans is arcing electricity grime the starter to the trans "
I found this pretty confusing, but I am assuming you are seeing arcing from the starter to the the trans housing.
#5
Honda-Tech Member
Thread Starter
Join Date: Feb 2006
Location: Richmond, Va, United States
Posts: 46
Likes: 0
Received 0 Likes
on
0 Posts
Re: crx electrical maelstrom
when i say arching there's literary electrify flowing from the stater to the trans, it dose it when i use the starter gun, the starter dose not crank when you use the key
#7
Honda-Tech Member
Thread Starter
Join Date: Feb 2006
Location: Richmond, Va, United States
Posts: 46
Likes: 0
Received 0 Likes
on
0 Posts
Re: crx electrical maelstrom
thanks 4dr ill check it out when I get to my car, its getting old just seeing it sit on Jack stands, ill post up the results and hopefully it fixes this problem
Thread
Thread Starter
Forum
Replies
Last Post