ekcoupeh22

iTrader: (2)

ok so I've been searching around for a parachute mount fir a while now with no such luck I want a removable setup I don't want it permeant I can't seem to find what I'm looking for I'm looking for one that bolts into the tube. Like this one would be perfect

2nd where is the most ideal location for the anchor line? Higher the better?

theidealone

https://swracecars.com/store/Parachu...OSCAR_364.aspx

Obviously too high could be a bad thing. I would think centerline of gravity would be optimal, but thats just my logical guess.

ekcoupeh22

iTrader: (2)

You know how many times I looked at that chut mount and never saw the bolt? Smh
Yeah I was thinking right above the license plate?

redboost10

That style looks like a trailer hitch. Believe it or not jegs has a nice kit that you can use or just make it yourself. Make the bottom tether section came out of the center of the bumper and make it removable. Then the parachute mount can be off the license plate section, so your trunk is still functional too

ineedavtec

I had one fabbed that looks pretty close to the one you have in the pic but the chute mount is up higher and the bar going to the chute mount itself is set back farther and bends twords the back of the car instead of away, kinda hard to explain, I dont have pics of it on the car on this comp, but I'll try to get one in a bit when I go down to work on it, if you think that might help. Only pic I have on photobucket is how the inside fab work looks that it goes into.

ineedavtec

I didn't look hard enough, found it lol

ekcoupeh22

iTrader: (2)

That's a nice setup but that would be way to high on my integra cause I have a drag wing for it

sohc95vtec-t

How mine was done. Boxed in the rear "frame rails" where the stock bumper bar bolted in, and ran a bar to each side. The chute is removable just like the one you showed

turbodano

The chute should be attached/anchored no higher or lower than 2 inches of the top of the tire.

nonvtecallmotor

Mine is done like the Del Sol. I didnt want monkey bars in my trunk..

wreckeddc4

Chute does not have to be tied into the cage?

redboost10

Nope. Mine is like the del sol as well. You can lift the car by it.

EJ1_Ex

iTrader: (1)

Im interested in a setup like this..

E Town DSM

I think the guys at nrg tech sell a bolt in kit for the mount and the handle

EJ1_Ex

iTrader: (1)

I'll check them out

ekcoupeh22

iTrader: (2)

[QUOTE=E Town DSM;48346398]I think the guys at nrg tech sell a bolt in kit for the mount and the

ekcoupeh22

iTrader: (2)

Anybody else know where I can get the one pictured?

MR.johnson

bump looking into different kits and chutes. what works good?

Steeve_Civic

I m interested for a bolt on kit, is there some others feedbacks?

DOHCarp

Here is something I found while I was looking for the same. Ended up fabing up something similar. I don't know the company or have ever purchased from them before.

http://www.turboelements.com/index.p...product_id=146

carbon fiber coupe

iTrader: (2)

chute0000 by 93 red ls, on Flickr

chute000 by 93 red ls, on Flickr

chute00 by 93 red ls, on Flickr

Ron Burgandy

iTrader: (1)

Where do these specs come from? Most chutes sit up where you describe, but almost all that I see have their anchor points well below that.