How do you remove the brake rotor on these POS TLs?
04-22-2014, 02:48 PM
#1
How do you remove the brake rotor on these POS TLs?
I have a 96 tl 2.5 that is rediculously over engineered to to the point of stupidity. I got all the bolts off the hub area but the rotor is sandwiched inbetween the spindle assembly arm and the hub. here is a pic. Is this rusted on or something? Just another way acura can stick it in your ***. Thank you.
Last edited by notnilc20; 04-22-2014 at 10:15 PM. Reason: Felt like it
04-22-2014, 10:13 PM
#3
Re: How do you remove the brake rotor on these POS TLs?
Ok here is a couple videos i found on it.
http://youtu.be/5xIUAMl-oRQ
http://youtu.be/UirzXEmnxVc
The design is known as captive rotors and It is much more involved than your typical sensible design. I guess honda/acura did this so you would be more inclined to take it to the dealer to get new rotors. I don't see any performance benefit other than to make the weekend mechanics job that much more frustrating. Anyway, for the next guy hope this vid helps.
http://youtu.be/5xIUAMl-oRQ
http://youtu.be/UirzXEmnxVc
The design is known as captive rotors and It is much more involved than your typical sensible design. I guess honda/acura did this so you would be more inclined to take it to the dealer to get new rotors. I don't see any performance benefit other than to make the weekend mechanics job that much more frustrating. Anyway, for the next guy hope this vid helps.
04-29-2014, 03:16 PM
#4
Re: How do you remove the brake rotor on these POS TLs?
I replaced my Rotors on my 96 TL 2.5 with a Tool called GDT5. And you can get one on EBAY.This Tool Separates the Hub from the Rotor. Rotors are Easy to Replace with this Tool.
Thread
Thread Starter
Forum
Replies
Last Post
bryan0
Honda Accord (1990 - 2002)
11
03-25-2014 10:57 PM
