Timing belt cover for a b20 vtec.
#1
Timing belt cover for a b20 vtec.
Can anyone share from what motor timing belt covers can be use on a b20vtec with a b16 head. I have been looking around and I hear different comments. Can I use all gsr covers. Or b20 bottom and both b16 upper covers.
#2
Honda-Tech Member
Re: Timing belt cover for a b20 vtec.
Any year b20 block cover and any year vtec b-series upper
#3
Honda-Tech Member
Re: Timing belt cover for a b20 vtec.
any obd2 lower cover (if using pump with ckf sensor provisions). GSR/ITR upper covers. You will have to shave some off the back of the inner cover if you want that to fit.
#4
Re: Timing belt cover for a b20 vtec.
the bottom block is jdm. what if I use a the upper covers from a 2000 si. do I have to shave the back to make it fit.
#5
Re: Timing belt cover for a b20 vtec.
Here's the facts:
There is very little effort to make the complete timing set work and fit excellent. The pictures show a tiny little tab that gets removed from the block rear cover and a tiny slot made for a rib on the motor as shown. Afterwards it will fit excellent and allign almost perfect with the upper cover except for a very small, nearly unnoticable gap on the rear where they are meeting with the water pump. Not a gap really, just spread apart slightly, but fits with all the hardware fine.
There is very little effort to make the complete timing set work and fit excellent. The pictures show a tiny little tab that gets removed from the block rear cover and a tiny slot made for a rib on the motor as shown. Afterwards it will fit excellent and allign almost perfect with the upper cover except for a very small, nearly unnoticable gap on the rear where they are meeting with the water pump. Not a gap really, just spread apart slightly, but fits with all the hardware fine.
Thread
Thread Starter
Forum
Replies
Last Post
akira712
Hybrid / Engine Swaps
1
12-07-2006 06:45 PM