You are currently viewing our forums as a guest, which gives you limited access to view most discussions and access our other features. By joining our community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join the Honda-Tech community today!
I recently Bought a y8 head and y8 Intake manifold (for a manual tranny), With a p2p (for a manual tranny) I think outta a 98 ex. I do have the knock sensor installed and running to my ecu as well as the vtec pressure switch and solenoid, according to the DIY diagram for vtec wiring p2p ecu's IAVC is hooked up correctly as well as map and tps sensor. And everything is TDC. Iv'e checked spark gap and all no clogs or leaks, But if I have someone roatate my dizzy some I can achieve above 7k rpm, but the bracket holes wont allow me to attach the dizzy. I have to be close...... car runs good close to 4k and above, but is hard to take off from 1st and 2nd. HELP MUCH NEEDed GlADLy APPRICIEATED!!!
Honda and the Honda marquee are registered trademarks of the American Honda Motor Company, Inc. Neither American Honda Motor Company nor its subsidiaries or affiliates shall bear any responsibility for Honda-Tech.com content, comments, or advertising. Honda-Tech.com is not affiliated with American Honda Motor Company in any way. American Honda Motor Company does not sponsor, support, or endorse Honda-Tech.com in any way.
Copyright/trademark/sales mark infringements are not intended or implied.