Ek pinchweld probloms !!!
#1
Ek pinchweld probloms !!!
F course if you have an ek u have that dreaded pinch weld directly above your tire
Was wondering if anyone has done anything to fix or improve so car can go lower and not pop on weld ??help would be appreciated
Was wondering if anyone has done anything to fix or improve so car can go lower and not pop on weld ??help would be appreciated
#6
Honda-Tech Member
Join Date: Jan 2014
Location: Ohio
Posts: 159
Likes: 0
Received 0 Likes
on
0 Posts
Re: Ek pinchweld probloms !!!
Don't cut it at all, simply pound it up starting front to rear and work your way to the middle. Heating it just enough to stretch the joint might not be a bad idea either, just to keep the steel from ripping.
#7
Honda-Tech Member
iTrader: (2)
Join Date: Oct 2003
Location: Hickory, NC, USA
Posts: 136
Likes: 0
Received 0 Likes
on
0 Posts
Re: Ek pinchweld probloms !!!
I cut slits in it and then pounded it flat, and then for good measure since i own a welder and know how to weld I welded a piece of steel plate over the pinch weld for reenforcement, was it needed no, does it look good after I recoated the wheel well in por-15 yes and I will never have to worry about pinch welds again
Thread
Thread Starter
Forum
Replies
Last Post