91 Accord F22A1 Ignition Timing
#1
91 Accord F22A1 Ignition Timing
I am trying to set the Ignition timing on a 91 F22A1. Looks simple enough except when I open the plug the pointer is there but there are not any timing marks on the flywheel. On the front of the engine, pulley end, there is not a pointer or any grooves cut in the pulleys.
What am I missing?
What am I missing?
#2
Re: 91 Accord F22A1 Ignition Timing
It's on the flywheel. Sometimes if the flywheel is rusted the marks are harder to see. You can turn the wheels all the way to the left and get a wrench on the crank pulley bolt and with the tranmission in neutral you can have someone turn the bolt COUNTERCLOCKWISE until you can see the marks. Then use a black sharpie to make marks on the flywheel so you can see them better with the timing light on it.
#4
Re: 91 Accord F22A1 Ignition Timing
Ok, I turned the wheels out and turned the crank pulley nut CLOCKWISE and watched the flywheel. Still no marks. I took out the number 1 spark plug and watched as the piston started coming up. I turned very slowly and watched with a flashlight still no marks so I brought the number 1 cylinder around to the next iteration and did the same thing but still nothing. I took a rag and some brake cleaner and cleaned the flywheel surface to a clean silver color and tried again. Still nothing.
My Haynes manual shows a fairly noticeable mark and I don't even have a scratch.
Help.
My Haynes manual shows a fairly noticeable mark and I don't even have a scratch.
Help.
#5
Re: 91 Accord F22A1 Ignition Timing
It's there it's just kinda hard to see. It's more of a slight scratch than a clear mark. There will be two sets. You will want the set with more marks. It will have -15 degrees and one mark ahead and one mark behind it, like I said, more of a scratch. And remember, they are not on the teeth, they are to the right of it.
#6
Re: 91 Accord F22A1 Ignition Timing
Ok, I checked again and there just are not any marks. I am wondering if some changed the flywheel and used one that was not marked.
Is there any way to mark the flywheel short of replacing it? Does anyone have pictures of a flywheel with the marks that I can use to mark mine closest enough to get through emissions?
Is there any way to mark the flywheel short of replacing it? Does anyone have pictures of a flywheel with the marks that I can use to mark mine closest enough to get through emissions?
Thread
Thread Starter
Forum
Replies
Last Post
ayavner
Honda Accord (1990 - 2002)
5
05-28-2008 03:07 PM
dallandra
Honda Prelude
9
04-13-2002 07:00 PM