H22A Oil Pressure
#1
Honda-Tech Member
Thread Starter
Join Date: Nov 2009
Location: MCB Quantico, VA
Posts: 184
Likes: 0
Received 0 Likes
on
0 Posts
H22A Oil Pressure
I am curious what my oil pressure should be. Once its warmed up it sits around 30psi. But, under a load (WOT) it goes from 75psi and up. My autometer gauge stops at 100psi and it sits pretty close to it when at WOT.
The oil I use is 5w20 RP and a Mobil1 filter. My sending unit is on the sandwich plate between the filter and the block, maybe that is why the high numbers?
The engine has roughly 100k miles on it and is internally stock. The oil level is right below the full mark. The oil pan has a small dent to make room for the traction bar install, the car is a CRX (previous owner).
Any info would be great but I think this is normal, just making sure.
The oil I use is 5w20 RP and a Mobil1 filter. My sending unit is on the sandwich plate between the filter and the block, maybe that is why the high numbers?
The engine has roughly 100k miles on it and is internally stock. The oil level is right below the full mark. The oil pan has a small dent to make room for the traction bar install, the car is a CRX (previous owner).
Any info would be great but I think this is normal, just making sure.
#2
Join Date: Jul 2000
Location: Snohomish county, WA, USA
Posts: 2,392
Likes: 0
Received 0 Likes
on
0 Posts
Re: H22A Oil Pressure
Mine idles at ~20psi when fully warm with Mobil1 5w30. My Autometer Oil Pressure sending unit is tapped with a T fitting off of the stock oil pressure sensor location. At WOT, my oil pressure seems to be ~85 psi.
Thread
Thread Starter
Forum
Replies
Last Post