Rocker arm adjustment.
#1
B*a*n*n*e*d
Thread Starter
Rocker arm adjustment.
SO my rocker arms make a ton of noise on my d16y8 when i get around 3k RPM. It gets annoying after a while. Is there any way to adjust them?
#5
for the op, to do a valve lash adlustment. Take the v/c off and at the end of the rocker arm will be a lock nut and lash adjuster that goes does to the valve. Loosen the lock nut with a 8 or 10mm wrench, use a feeler gauge between the valve and adjuster and adjust the aduster to spec. I think the inake is .008" and the exhaust is .012"..i tihnk but go look your up and make sure
Thread
Thread Starter
Forum
Replies
Last Post
W.O.P.
Acura Integra
57
03-09-2004 10:06 PM