korndog

as the title says wat is the best way to remove the bolts without snapping them.
I have heard all kind of different methods from letting the car run for a little while to the bolts are hot. Some say wait untill the car is cold. Some say soak the bolts everyday for a week strait with wd40

Whats the best way what has worked for everyone else successfully?

Thanks

gsr dood

I only take em out when that car is warm. This is because the aluminum is a little less stressed around the bolt when its warm. Spray some wd40 the night before.....run it hot and just loosen the bolt....never had a problem with that.

denraweb

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by gsr dood &raquo;</TD></TR><TR><TD CLASS="quote">I only take em out when that car is warm. This is because the aluminum is a little less stressed around the bolt when its warm. Spray some wd40 the night before.....run it hot and just loosen the bolt....never had a problem with that.</TD></TR></TABLE>

I agree with this to a certain extent...problem with the bolts/nuts being warm when removing is that if the bolts are even a little over tightened, the bolt will easily snap completely off and basically when that happens, you're effed...even if only one bolt snaps, you still will have a major exhaust leak. So be careful...

gsr dood

its not as bad as many ppl think.... if the bolt breaks just get a right angle drill and drill a hole in the bolt and get an extractor.... easier said than done.... but it still not gunna ruin ur life

all-mtr-teg

I use PB Blaster

Jabinya

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by all-mtr-teg &raquo;</TD></TR><TR><TD CLASS="quote">I use PB Blaster </TD></TR></TABLE>

X2

WD40 has nothing on PB Blaster

63HMOOB

the best way is to wait for the engine to cool down so you don't strip bolts. just use a socket and a long ratchet or a pole around it for leverage. some bolts you might need a wrench to get to. make sure you spray some kind of rust penetrate. GL

blueDA9

I actually never had any problem with mine...

kuja

i broke my lower left stud before, it was great. extractors usually suck *****, but by some miracle and almost royally f'ing the hole, i got it out with one of the craftsman extractors. Anyway, with my ramhorn, i'm able to use an offset wrench on mine.

Ciddogg

just be gentle and you should have no problem and if it dose break weld a smaller bolt to it and then take it out that way. just another idea for you

98GSRDC2

i never had a problem with mine. just used wd40 the day before and let the car warm just to be safe

mach0

X3

jr408

ummmm...do it softly

korndog

well surprisingly i managed to find pb blaster on this island. so i will soak the bolts warm the car and give it a try