D16Cowboy

Okay, these are the fold-down type seats in the hatchback. Much different than the 4-door type that just comes right out. I removed the black plastic spacers on the sides of the seats and they will not slide out. I'm tryin not to damage the paneling (which is what I'm going for to put in my car). These seats will not come out. What am I not doing? There are no bolts, screws or keepers that I can see. Do I need any specific tools?

EF001282

nope no special tools, just remove the two black plastic "C/E" clips and spread the two halves apart in the middle and the top back rests should come out then take off the 12mm bolt and that's it.
remove this "E/C" clip

now it removed

push the seat to the side

then remove

then do the other side, after that remove this bolt and you should be good




Modified by EF001282 at 12:36 AM 4/29/2007

h8tred

Good job EF001282, not very often that you see a single response post that's helpful.

D16Cowboy

Thanks so very much... I'm going to get it done right now

EF001282

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by D16Cowboy &raquo;</TD></TR><TR><TD CLASS="quote">Thanks so very much... I'm going to get it done right now </TD></TR></TABLE>
sure no prob, I was bored last night so I felt like helping.

Zoliphiite

I fought with these things for an hour last night and gave up for the night. Woke up, found this super helpful info and in seconds had them out. Thanks man

rallypoint_1

Something Facebook can't do! We need to keep these threads to help others in the future.