91 integra door panel
#1
Junior Member
Thread Starter
Join Date: Mar 2005
Location: Richmond, Va
Posts: 332
Likes: 0
Received 0 Likes
on
0 Posts
91 integra door panel
Hello,
I'm in the process of removing a door panel off of a 91 da Integra. I've gotten all of the retaining screws and clips off of the door panel but I'm having problems removing it from the top part of the door where the molding meets the door panel. In my DC2 the panel just pulls off of the door but in this car it wants to stay on the door. Unfortunately I don't have a manual. Can anyone shed some light on this?
Thanks!
J
I'm in the process of removing a door panel off of a 91 da Integra. I've gotten all of the retaining screws and clips off of the door panel but I'm having problems removing it from the top part of the door where the molding meets the door panel. In my DC2 the panel just pulls off of the door but in this car it wants to stay on the door. Unfortunately I don't have a manual. Can anyone shed some light on this?
Thanks!
J
#3
Re: 91 integra door panel (mr.beeks)
On my 92 DA, you pull the bottom of the door panel out a few inches, then pull the whole panel up and it should come right off without too much effort.
#5
Honda-Tech Member
Join Date: Dec 2004
Location: Chattanooga, TN, United States
Posts: 134
Likes: 0
Received 0 Likes
on
0 Posts
Re: 91 integra door panel
If you have all the screws out and the only thing holding it on is the top edge it sometimes helps to slide the panel towards the rear of the door slightly.
Thread
Thread Starter
Forum
Replies
Last Post
suhteevin
Honda Civic / Del Sol (1992 - 2000)
2
01-06-2009 09:04 PM