DarkBB4

Hey i just isntalled my tachomter and for some reason its not accurate at all... Like when its at 2k rpms (stock tach) its up to lik 4K rpms on the autometer tach....

now, the instructions say to clip the Brown and Orange Wire on the back of the tach.. but On mine.. theress only a brown and a blue?? WTF? I tried clipping one, and it was the same.. then i clipped the other and Nothing changed... It's wierd because it seems as tho i could pull those wires out if i wanted (they feel loose)...

I tried every combination of the wires and its off every time

This thing was "new"... waht could be wrong

I tihnk i wired it right cause the RPM's DO read, but they're too high

UJLSMoFo

were are you pulling your signal from. try the blue wire next to the hood prop. it should be black tap to the harness

DarkBB4

from the ECU.. is that wrong?

UJLSMoFo

no, perfect

DarkBB4

wtf this is soo fricken messed up..

any ideas?

UJLSMoFo

dude, its hard to say, you should only have to cut the to wires for 4cylinder. some times the tach has to been calibrated for a specfic car.

DarkBB4

well the instructions like didn't hav ethe correct colors or anything....

I clipped both the wires and its Still messed up


Will resetting hte ecu? hae anythin to do with it.. (just disocnnect the battery)


after i clipped them , is there any other Prepping i have to do... just set the shift light?

i read somewher that ur supposed to like Hold in the top button and turn the car on, then it should read 2k and then go up 1 K per 2 seconds... (without revving or anything)... Then u shoul set it at 2k.... wtf


this is pissing me off

PrettyLude

try putting the blue wire together, and make sure to check all ur connections

DarkBB4

called automter.. i know what the problem is.. htanks

PrettyLude

what was the problem