Notices
Search: Posts Made By: Alpha Q
Showing results 1 to 16 of 16
Search took 0.13 seconds.
03-26-2012, 10:16 AM
Replies: 12
Views: 33,213
Posted By Alpha Q

03-26-2012, 08:22 AM
Replies: 12
Views: 33,213
Posted By Alpha Q

Re: y7 y8 mini me swap!!

I have had the same build. I also added boost. With out boost I really didn't notice any difference in power then my stock z6. What misinformation are you talking about. I have first hand experience...
03-26-2012, 12:19 AM
Replies: 3
Views: 1,783
Posted By Alpha Q

Re: b16 ek hatch idle problems

I know you said you tested the alternator but swap it out with a new one.
just because it test good don't always mean its good..

I had same problem, tested and replaced everything... ended up...
03-26-2012, 12:05 AM
Replies: 16
Views: 7,001
Posted By Alpha Q

Re: LS swap crank no start

So when you swapped dizzy's it works??
03-26-2012, 12:00 AM
Replies: 21
Views: 19,073
Posted By Alpha Q

Re: 95 civic w/ d15b7 stalling, fuel odor out of exhaust and low MPG's...suggestions?

Its just a matter of testing everything you have listed.

Random loss of power suggest TPS, MAP and/or distributor

Fuel odor out of exhaust and low MPG suggest bad o2

If it were a sensor you...
03-25-2012, 11:50 PM
Replies: 12
Views: 33,213
Posted By Alpha Q

Re: y7 y8 mini me swap!!

ok maybe 10 15 more HP then a stock z6..
z6 is a vtec motor.
higher compression is only good if you are doing a all motor build...
single cam all motor is point less... cost too much to for...
03-25-2012, 11:16 PM
Replies: 6
Views: 5,283
Posted By Alpha Q

Re: Brake Pedal Goes Straight to the Floor

X2 air may be in the line...
03-25-2012, 10:10 PM
Replies: 12
Views: 33,213
Posted By Alpha Q

Re: y7 y8 mini me swap!!

For what reason are you doing a y7 y8 mini me swap.

You wont get any more power.

Go full z6 OBD-1.. better head and can get more power it modded....
03-25-2012, 10:07 PM
Replies: 13
Views: 29,045
Posted By Alpha Q

Re: how to identify rear disc swap? and proportioning valve

Post picture...

I did a swap and did not use the 40/40 proportioning valve.. It stops on a dime.. Just make sure you have the right brake booster
03-25-2012, 10:03 PM
Replies: 14
Views: 10,419
Posted By Alpha Q

Re: 96 y8 head / 2000 y7 block, what ECU do i use?

P2P is a OBD-2 VTEC ECU.
This is the one you want to use!!

P28 is a OBD-1 VTEC no Knock and no 3 wire IACV
03-25-2012, 09:54 PM
Replies: 4
Views: 4,074
Posted By Alpha Q

Re: [Help] Horn problem after wiring car alarm to the stock horn

I'm guessing the alarm does not give enough power to the horn.
Wire it to the horn wire in the steering wheel.
03-25-2012, 09:51 PM
Replies: 10
Views: 3,286
Posted By Alpha Q

Re: Super Loud Clunking Noise from Axle after Knuckle Replacement

Your lower ball joint is tight with out a nut... but if you hit a bump it will fall out....

same scenario

It may be tight, but when you drive the car you are talking about a lot of force on the...
03-25-2012, 09:46 PM
Replies: 18
Views: 13,623
Posted By Alpha Q

Re: Are Sunroofs prone to leak?

Factory: NO
Aftermarket: YES
03-25-2012, 09:45 PM
Replies: 23
Views: 4,103
Posted By Alpha Q

Re: 97 del sol si. hard brake pedal, slow acceleration.

try bleeding your brakes... & check the vacuum line on the brake booster...
03-25-2012, 09:41 PM
Replies: 8
Views: 2,017
Posted By Alpha Q

Re: where buy one acl race series rod bearing for a d16z6?

good luck.... I don't think you can find just a single one...
They are shrink wrapped and boxed all together from the factory.
No store will sell them separate.
Like anything on a car, if you...
03-25-2012, 09:30 PM
Replies: 21
Views: 12,706
Posted By Alpha Q

Re: d16y7 head on jdm d15b block questions that I cannot find answers to

I Agree don't build a mini-me
build a full z6 or y8
you will spend more time working out all the crap on the mini-me for no real gains
Showing results 1 to 16 of 16


 
Forum Jump


All times are GMT -8. The time now is 09:42 PM.