Honda-Tech - Honda Forum Discussion

Notices
 
Page 1 of 17
1
2
3
11
Last »
Search: Posts Made By: Emeraldbomber
Showing results 1 to 25 of 409
Search took 1.10 seconds.
Forum: Transmission & Drivetrain
09-04-2014, 08:24 PM
Replies: 3
Views: 556
Posted By Emeraldbomber

Did you readjust your clutch pedal after the...

Did you readjust your clutch pedal after the clutch replacement?
Forum: Transmission & Drivetrain
08-19-2014, 09:45 PM
Replies: 17
Views: 2,830
Posted By Emeraldbomber

I cannot tell from the picture.

I cannot tell from the picture.
Forum: Transmission & Drivetrain
08-18-2014, 07:52 PM
Replies: 2
Views: 1,165
Posted By Emeraldbomber

With higher capacity clutches it's not going to...

With higher capacity clutches it's not going to be nice and easy.
Try comp clutch. Stage 3 should cover round so I believe.

I have stage 2 and it's not difficult to drive.
Forum: Transmission & Drivetrain
08-18-2014, 07:46 PM
Replies: 17
Views: 2,830
Posted By Emeraldbomber

Replace both.

Replace both.
Forum: Transmission & Drivetrain
08-18-2014, 07:45 PM
Replies: 17
Views: 2,830
Posted By Emeraldbomber

Your reverse idler gear is rounded a bit but take...

Your reverse idler gear is rounded a bit but take a look at the 1-2 collar. That things rough.
Forum: Hybrid / Engine Swaps
08-06-2014, 03:17 PM
Replies: 3
Views: 959
Posted By Emeraldbomber

If you don't want to do anything else then the z6...

If you don't want to do anything else then the z6 will drop right in and work as long as you have the jumper from obd2-1, the ecu and the wiring harness.
Forum: Suspension & Brakes
07-30-2014, 08:54 AM
Replies: 3
Views: 950
Posted By Emeraldbomber

Hard race.

Hard race.
Forum: Drag Racing
07-29-2014, 03:12 PM
Replies: 556
Views: 92,266
Posted By Emeraldbomber

Good luck man! You are a much greater man than I....

Good luck man! You are a much greater man than I. Had it been me in this exact situation I'd probably be in prison on many charges lol.
Forum: Suspension & Brakes
07-28-2014, 11:24 AM
Replies: 14
Views: 3,136
Posted By Emeraldbomber

I ride progress csII's on a 94 ej1 450 up...

I ride progress csII's on a 94 ej1

450 up front
350 in rear.

Feels like I'm riding on a 2x4 an that's with roughly 11/2-2in drop. So there's that
Forum: Transmission & Drivetrain
07-28-2014, 08:58 AM
Replies: 8
Views: 8,037
Posted By Emeraldbomber

Honda mtf is thinner than synchromesh. IIRC I do...

Honda mtf is thinner than synchromesh. IIRC I do believe torco is not very good on our transmissions either.
Forum: Hybrid / Engine Swaps
07-21-2014, 12:29 PM
Replies: 9
Views: 1,263
Posted By Emeraldbomber

Your absolutely positive the wiring for the vss...

Your absolutely positive the wiring for the vss isn't freyed or broken and that the sensor was a working sensor?
Forum: Transmission & Drivetrain
07-17-2014, 07:58 PM
Replies: 8
Views: 1,087
Posted By Emeraldbomber

I've always used and had good luck with...

I've always used and had good luck with synchromesh. But your just prolonging the problem..... It's not gonna magically fix itself from fluid.
Forum: Transmission & Drivetrain
07-17-2014, 01:31 PM
Replies: 7
Views: 2,231
Posted By Emeraldbomber

Well yes there is a shim on top of the case. But...

Well yes there is a shim on top of the case. But the 2 washers are used as shims too no?
Forum: Hybrid / Engine Swaps
07-16-2014, 01:29 PM
Replies: 16
Views: 3,031
Posted By Emeraldbomber

I have an h swap in mine done by me. I had to cut...

I have an h swap in mine done by me. I had to cut the floor all to shit. I just rewelded panels back on the bottomside. Nothing to be replacing a shell over. Just get some thicker gauge sheet metal...
Forum: Transmission & Drivetrain
07-16-2014, 01:25 PM
Replies: 7
Views: 2,231
Posted By Emeraldbomber

Bottom of the mainshaft there is 2 washers that...

Bottom of the mainshaft there is 2 washers that shim it.
Forum: Suspension & Brakes
07-14-2014, 09:47 AM
Replies: 7
Views: 3,161
Posted By Emeraldbomber

No spring will save your ride if your that low....

No spring will save your ride if your that low. Your gonna bounce all over the place no matter what.

Raise the car

#endthread
Forum: Hybrid / Engine Swaps
07-13-2014, 06:04 PM
Replies: 5
Views: 2,009
Posted By Emeraldbomber

Then the trans can't be in neutral.

Then the trans can't be in neutral.
Forum: Hybrid / Engine Swaps
07-13-2014, 01:09 PM
Replies: 5
Views: 2,009
Posted By Emeraldbomber

The car won't roll at all when the trans is in...

The car won't roll at all when the trans is in neutral?
Forum: Hybrid / Engine Swaps
07-12-2014, 08:17 PM
Replies: 5
Views: 2,009
Posted By Emeraldbomber

Is the car hardwired to be in neutral or park?

Is the car hardwired to be in neutral or park?
Forum: Transmission & Drivetrain
07-08-2014, 09:58 AM
Replies: 4
Views: 776
Posted By Emeraldbomber

Either or. Doesn't matter

Either or. Doesn't matter
Forum: Transmission & Drivetrain
07-08-2014, 07:23 AM
Replies: 3
Views: 4,050
Posted By Emeraldbomber

You need the countershaft 5th and the mainshaft...

You need the countershaft 5th and the mainshaft 5th from the same trans. You can't mix and match different gears.
Forum: Transmission & Drivetrain
07-07-2014, 07:23 AM
Replies: 5
Views: 547
Posted By Emeraldbomber

Yep you got it. Should look like this.

Yep you got it.


Should look like this.
Forum: Engine Management and Tuning
06-23-2014, 07:57 PM
Replies: 9
Views: 671
Posted By Emeraldbomber

Yep. You can just plug it back in and fire it up

Yep. You can just plug it back in and fire it up
Forum: Hybrid / Engine Swaps
06-21-2014, 08:25 AM
Replies: 5
Views: 4,994
Posted By Emeraldbomber

All the same.

All the same.
Forum: Transmission & Drivetrain
06-20-2014, 07:26 PM
Replies: 7
Views: 1,076
Posted By Emeraldbomber

Nope. You forgot to keep all the gears in neutral...

Nope. You forgot to keep all the gears in neutral before slapping the case on. That or the case pushed the forks down.
Showing results 1 to 25 of 409
 
Page 1 of 17
1
2
3
11
Last »


 
Forum Jump


All times are GMT -8. The time now is 03:08 AM.