Honda-Tech - Honda Forum Discussion

Notices
 
Page 1 of 2
1
2
Search: Posts Made By: K1llaturtl3
Showing results 1 to 25 of 34
Search took 0.16 seconds.
Forum: Paint and Body
02-13-2012, 07:45 PM
Replies: 67
Views: 265,845
Posted By K1llaturtl3

Icon3 Re: ► FAQ: Honda Paint Code List 1983-2007, Acura Paint Codes List 1986-2007 ◄

http://www.automotivetouchup.com/choosecolor/choosecolor.aspx?year=1980&make=Honda&model=All%20Models

you can choose different makes and models of almost every car and they will almost always have...
Forum: Honda Accord (1990 - 2002)
01-06-2012, 07:57 PM
Replies: 10
Views: 4,292
Posted By K1llaturtl3

Re: F22b1 turbo Problems

its your throttle position sensor or MAP

same problem 2 months ago. not in limp mode or any other stupid response. that is what someone who has no idea what they are talking about would reply. I...
Forum: Honda Accord (1990 - 2002)
12-23-2011, 01:34 PM
Replies: 8
Views: 1,884
Posted By K1llaturtl3

Re: no fuel to rail 92 accord - 2.2 vtec f series

When I say go off I meant that it turns off after about 2 seconds lol. I can see how that would be confusing.
Forum: Honda Accord (1990 - 2002)
12-23-2011, 01:33 PM
Replies: 8
Views: 1,884
Posted By K1llaturtl3

Re: no fuel to rail 92 accord - 2.2 vtec f series

Ghost I too have read the manual, both for the 92 accord I have and the 97 vtec I swapped into it. Ironically, when I installed my new back seat I unplugged the power pin from my fuel pump. I...
Forum: Honda Accord (1990 - 2002)
12-19-2011, 09:09 PM
Replies: 8
Views: 1,884
Posted By K1llaturtl3

Re: no fuel to rail 92 accord - 2.2 vtec f series

Actually if you look through many threads you will notice that when the light will not go off the fuel pump won't primer. Also, you will notice that many threads will tell you that their c. e. l....
Forum: Honda Accord (1990 - 2002)
12-19-2011, 09:33 AM
Replies: 8
Views: 1,884
Posted By K1llaturtl3

no fuel to rail 92 accord - 2.2 vtec f series

So I swapped my stock f22a for an f22b vtec. It was running and fast, then I parked it and noticed that my glovebox light harness was not mounted. So I plugged it in. I turned the key over to prime...
Forum: Honda Accord (1990 - 2002)
12-19-2011, 09:25 AM
Replies: 4
Views: 3,708
Posted By K1llaturtl3

Re: Can,t pinpoint an oil leak.....96 2.2..

Try wiping it all clean and allowing the car to idle for 15-20 mins, then check again. but it may just be the gasket.
Forum: Honda Accord (1990 - 2002)
12-05-2011, 11:20 AM
Replies: 17
Views: 21,406
Posted By K1llaturtl3

Re: Vacuum Problems

no I was getting an o2 code. I replaced my o2 now but still in limp mode
Forum: Honda Accord (1990 - 2002)
12-04-2011, 09:09 PM
Replies: 17
Views: 21,406
Posted By K1llaturtl3

Re: Vacuum Problems

Yeah I will get pics tomorrow, and post them asap.





I used the ecu out of my 92 the POA, it is the same ecu found in the 94 with the vtec. I just had to run the vtec to two pins. (A4 - VTEC...
Forum: Honda Accord (1990 - 2002)
11-26-2011, 02:31 PM
Replies: 17
Views: 21,406
Posted By K1llaturtl3

Re: Vacuum Problems

I ran the hoses to the manifold, now I just need to know why I can not accelerate past 1500 rpm's. when I do not have a load on the engine it will redline; but when I shift to first gear and drive...
Forum: Honda Accord (1990 - 2002)
11-25-2011, 12:19 PM
Replies: 17
Views: 21,406
Posted By K1llaturtl3

Re: Vacuum Problems

No I have the complete Throttle body and Intake Manifold from the Vtec. The whole thing is there head is there with an after market header. The O2 sensor is ran to the front of the catalyst. My TPS...
Forum: Honda Accord (1990 - 2002)
11-24-2011, 09:58 AM
Replies: 17
Views: 21,406
Posted By K1llaturtl3

Re: Vacuum Problems

I used the original harness but on the 92 Accord the map sensor was on my throttle body. lol so yeah its hooked up. But the connection to the fuel pressure regulator comes off the manifold on the 97...
Forum: Honda Accord (1990 - 2002)
11-23-2011, 06:12 PM
Replies: 17
Views: 21,406
Posted By K1llaturtl3

Re: Vacuum Problems

ok so I went and looked a friends vtec and I ran the hoses as I seen, but I don't know where hoses 20 and 21 would run to. anyway now I just need to figure out how to make it look sexy lol
Forum: Honda Accord (1990 - 2002)
11-23-2011, 01:21 AM
Replies: 5
Views: 6,469
Posted By K1llaturtl3

Re: engine cuts out at 3500 rpms

the code is o2 sensor and I just went and bought a new one. and yeah I ran the two wires to A6 and D4 or visa versa.
Forum: Honda Accord (1990 - 2002)
11-23-2011, 01:18 AM
Replies: 17
Views: 21,406
Posted By K1llaturtl3

Re: Vacuum Problems

All of the wiring is ran correctly, the vacuum hoses are my problem. And I have searched it a million different ways lol
Forum: Honda Accord (1990 - 2002)
11-22-2011, 02:23 PM
Replies: 62
Views: 51,408
Posted By K1llaturtl3

Re: My complete cb7 progress thread, from na to n2o, to turbo

man thats a beautiful accord... You still have it and did you ever hit 300?
Forum: Honda Accord (1990 - 2002)
11-22-2011, 01:56 PM
Replies: 2
Views: 2,589
Posted By K1llaturtl3

Re: 96 accord bogging/throbbing, shifting rough, and idling

I had this problem in 90 accord and it cam out to be the coolant hose was ran wrong and the vacuum hoses were jumbled
Forum: Honda Accord (1990 - 2002)
11-22-2011, 12:50 PM
Replies: 17
Views: 21,406
Posted By K1llaturtl3

Vacuum Problems

242432

I have a 92 accord that I swapped the head out with a f22b1 v-tec. The car idles fine and has awesome acceleration; until it hits 2500 rpm's. At 2500 the car will stop accelerating and the...
Forum: Honda Accord (1990 - 2002)
11-22-2011, 12:06 PM
Replies: 5
Views: 6,469
Posted By K1llaturtl3

Re: engine cuts out at 3500 rpms

bump
Forum: Honda Accord (1990 - 2002)
11-16-2011, 11:39 AM
Replies: 5
Views: 6,469
Posted By K1llaturtl3

engine cuts out at 3500 rpms

I recently did a head swap on my 92 Accord. I swapped it for a f22b1 head. Now that I finally received the exhaust I can start it. It idles around 1000-1200 rpms but will only rev to 3500 and when I...
Forum: Honda Accord (1990 - 2002)
11-12-2011, 07:56 PM
Replies: 1
Views: 1,890
Posted By K1llaturtl3

Icon2 vtec bogging out at 3k

I recently did a head swap on my 92 Accord. I swapped it for a f22b1 head. Now that I finally received the exhaust I can start it. It idles around 1000-1200 rpms but will only rev to 3500 and when I...
Forum: Honda Accord (1990 - 2002)
10-25-2011, 05:18 PM
Replies: 3
Views: 8,361
Posted By K1llaturtl3

Re: 92 accord engine swap (vtech)

This first image is the engine.
238091


Lets start with the mole hills...


238092
The first problem I ran into was the relocation of the throttle hanger. As you can see in the image I...
Forum: Honda Accord (1990 - 2002)
10-25-2011, 04:53 PM
Replies: 3
Views: 8,361
Posted By K1llaturtl3

Re: 92 accord engine swap (vtech)

lol thanks
Showing results 1 to 25 of 34
 
Page 1 of 2
1
2


 
Forum Jump


All times are GMT -8. The time now is 04:56 AM.