Notices
 
Search: Posts Made By: scott757
Showing results 1 to 25 of 27
Search took 0.17 seconds.
12-03-2013, 08:09 AM
Replies: 15
Views: 1,214
Posted By scott757

I will be doing headgasket again along with...

I will be doing headgasket again along with rebuilding head here soon so we will find out with more pics . I'm pretty sure they are forged tho
Forum: Tech / Misc
11-27-2013, 11:21 AM
Replies: 5
Views: 912
Posted By scott757

got it started by sanding down terminals on rotor...

got it started by sanding down terminals on rotor cap still bogs and only starts at wot
Forum: Tech / Misc
11-27-2013, 11:20 AM
Replies: 5
Views: 912
Posted By scott757

could a bad icm or coil cause motor bogging at...

could a bad icm or coil cause motor bogging at certain loads ? or would that be due to an improperly calibrated tps
11-27-2013, 11:15 AM
Replies: 15
Views: 1,214
Posted By scott757

is the carbon excessive ? detailing any immediant...

is the carbon excessive ? detailing any immediant problems ? sorry quite new to motor work
11-27-2013, 10:56 AM
Replies: 15
Views: 1,214
Posted By scott757

also it's a b18c1

also it's a b18c1
11-27-2013, 10:56 AM
Replies: 15
Views: 1,214
Posted By scott757

damn only pics I have. was told it's 12 : 5...

damn only pics I have. was told it's 12 : 5 high comp will be doing headgasket again with new head studs this time will probably drop pan and snap more pics
Forum: Tech / Misc
11-25-2013, 09:44 AM
Replies: 5
Views: 912
Posted By scott757

I have timed the motor again this morning still...

I have timed the motor again this morning still to no avail waiting for cap and rotor to come in
Forum: Tech / Misc
11-25-2013, 09:29 AM
Replies: 5
Views: 912
Posted By scott757

need help with no start condition

my b18c motor has been bogging down lately so I replaced fuel filter , did oil change , new fuel pump , spark plugs and wires also replaced my grounds . after that it ran for a little (bogging less )...
Forum: Tech / Misc
09-06-2013, 05:02 PM
Replies: 7
Views: 800
Posted By scott757

Re: oil on spark plugs

so piston rings ? I was told it could also be valve seals
Forum: Tech / Misc
09-06-2013, 05:50 AM
Replies: 7
Views: 800
Posted By scott757

oil on spark plugs

Hey guys , got a 93 civic gsr motor w/ bolt ons . Lately car has been bogging down on light acceleration so I pulled the spark plugs and they were covered in oil . The spark plug wires also had a...
Forum: Tech / Misc
09-06-2013, 05:48 AM
Replies: 6
Views: 956
Posted By scott757

Re: Speed problems

try checking connectors at back of cluster as well as VSS , (variable speed sensor) don't just jump to a new ECU
Forum: Tech / Misc
09-06-2013, 05:37 AM
Replies: 5
Views: 1,105
Posted By scott757

Re: car bogs on light accel and dies at idle ,vacuum leak ?!

fixed idle problem due to cracked vaccum hose yet it still bogs , have a brand new walbro 255 lph as of last month , now I pulled the plugs yesterday and they were saturated in oil as well as they...
Forum: Tech / Misc
09-02-2013, 05:32 AM
Replies: 5
Views: 1,105
Posted By scott757

car bogs on light accel and dies at idle ,vacuum leak ?!

for starters my setup is 93 coupe with a gsr swap and bolt ons . recently I have noticed the car likes to bog down horribly on light trottle but normal to heavy load no bogging . it also likes to...
Forum: Tech / Misc
03-21-2013, 05:30 PM
Replies: 5
Views: 1,075
Posted By scott757

Re: Need help car won't start , cranks but wont turn

Turns out timing was the problem , got her fired up tonight .. Appreciate all the good advice
Forum: Tech / Misc
03-20-2013, 09:46 AM
Replies: 5
Views: 1,075
Posted By scott757

Re: Need help car won't start , cranks but wont turn

I replaced the spark plugs this morning and cranked still the same , checked the timing and it was off 2 teeth , if it started before and ran fine could that still cause the no start ? Or do you...
Forum: Tech / Misc
03-20-2013, 04:15 AM
Replies: 5
Views: 1,075
Posted By scott757

Need help car won't start , cranks but wont turn

Ok so for starters my setup is a 1993 gsr swapped ej1 with bolt ons . I was doing a vacuum test on my car at school and I needed to rev to 2000 rpm , well magically when I needed to don that my vss...
07-12-2012, 09:13 AM
Replies: 7
Views: 1,372
Posted By scott757

Re: Ej1 build thread

My car actually flooded yesterday, ecu fried , Crome chipped p28 .. Now I got it running on a p06 got a phearable.net ecu otw as well as hondata s300. Pictures will be up soon
07-10-2012, 09:32 AM
Replies: 7
Views: 1,372
Posted By scott757

Re: Ej1 build thread

http://m1156.photobucket.com/albumview/albums/scott12757/image.jpg.html?o=1&newest=1
07-10-2012, 07:55 AM
Replies: 7
Views: 1,372
Posted By scott757

Re: Ej1 build thread

http://http://m1156.photobucket.com/albumview/albums/scott12757/image.jpg.html?o=1&newest=1
07-10-2012, 07:53 AM
Replies: 7
Views: 1,372
Posted By scott757

Ej1 build thread

So I've been in the game about 2 years now and this is my 4th Honda , I totaled my em2 I had plans on swapping a k20 in so I used insurance and went and got this ej1 for 2500 , when I bought it had...
07-02-2012, 12:05 PM
Replies: 27
Views: 17,358
Posted By scott757

Re: Best size turbo for daily gsr

Thanks guys , will take it all into consideration
06-26-2012, 07:00 AM
Replies: 27
Views: 17,358
Posted By scott757

06-26-2012, 03:33 AM
Replies: 27
Views: 17,358
Posted By scott757

Re: Best size turbo for daily gsr

yes yes , 1000 is the budget for the turbo only .. I have an ACT stage 3 clutch and skunk2 short throw shifter, not really stressin money right now , already putting somewhere in the area of 200 hp...
06-25-2012, 05:58 AM
Replies: 27
Views: 17,358
Posted By scott757

Re: Best size turbo for daily gsr

Budget is 1,000 and I know a couple people who can tune
Showing results 1 to 25 of 27
 


 
Forum Jump


All times are GMT -8. The time now is 12:48 AM.