Notices
 
Search: Posts Made By: m.glisson003
Showing results 1 to 25 of 87
Search took 0.19 seconds.
05-17-2013, 01:50 PM
Replies: 3
Views: 1,105
Posted By m.glisson003

Re: Stick moves when in gear

Thanks guys. I will look into getting that replaced.
05-13-2013, 05:46 PM
Replies: 3
Views: 1,105
Posted By m.glisson003

Stick moves when in gear

Working on a 1990 Acura Integra with B18 Non Vtec.

Firstly its really hard to get it into gear. You have to put alot of force onto the stick to get it into a gear.

My main concern is that when...
01-24-2013, 08:38 PM
Replies: 5
Views: 31,702
Posted By m.glisson003

Re: 93 Del Sol Turn signals and hazards stopped working

Alright so here is the scoop. After I read your reply above I went back and found the actual relay. Its behind the fuse panel to the left of the clutch. It actually had 9 wires going into it but it...
01-24-2013, 06:19 PM
Replies: 5
Views: 31,702
Posted By m.glisson003

Re: 93 Del Sol Turn signals and hazards stopped working

Yes I did check that fuse and that one was good too.
01-24-2013, 02:37 PM
Replies: 5
Views: 31,702
Posted By m.glisson003

93 Del Sol Turn signals and hazards stopped working

Okay so a couple days ago I started driving my car and all of a sudden the turn signals and the hazards aren't working anymore. They don't work outside and they don't work in the cluster either. When...
06-19-2012, 09:32 AM
Replies: 14
Views: 1,333
Posted By m.glisson003

Re: Crank but wont start, CEL stays lit. HELP please

How would I check my ECU? Just for kicks I plugged in my old ECU (D15B7) and it didnt start with that either.

I have not checked my main relay. I will have to do that.

Grounds should be good....
06-19-2012, 09:29 AM
Replies: 14
Views: 1,333
Posted By m.glisson003

Re: Crank but wont start, CEL stays lit. HELP please

Wires are in the correct firing order. And the timing is correct. Thanks for suggestions.
06-18-2012, 04:19 PM
Replies: 14
Views: 1,333
Posted By m.glisson003

Re: Crank but wont start, CEL stays lit. HELP please

I am having more issues. But they are different from the wire and hose location issues I was having before. Since these issues are from the same swap I can continue the other thread if you'd like?
06-18-2012, 03:53 PM
Replies: 14
Views: 1,333
Posted By m.glisson003

Re: Crank but wont start, CEL stays lit. HELP please

How is this relevant to the topic? Those issues from that thread were already resolved.
06-18-2012, 03:50 PM
Replies: 14
Views: 1,333
Posted By m.glisson003

Re: Crank but wont start, CEL stays lit. HELP please

Other than the ground coming off of the tranny, off of the valve cover, ground wire to the starter, thermostat ground, and of course negative battery cable is there anything else that is suppose to...
06-18-2012, 03:48 PM
Replies: 14
Views: 1,333
Posted By m.glisson003

Re: Crank but wont start, CEL stays lit. HELP please

Yes I did. I do have spark.

And no the car has never been ran.
06-18-2012, 03:25 PM
Replies: 14
Views: 1,333
Posted By m.glisson003

Crank but wont start, CEL stays lit. HELP please

Have a mini me with D15B7 bottom end and D16Z6 Head in a 93 Del sol.
Just put the engine in the car and hooked everything up and it wont start. When I jumped the connector to pull the CEL codes the...
06-18-2012, 09:21 AM
Replies: 7
Views: 18,487
Posted By m.glisson003

Re: D16Z6 mini me swap help

Alright so I have all of the hoses in the correct places according to the new diagram. There is only ONE hose left to question. Its obvious the hose I am holding in the picture goes to the port under...
06-17-2012, 09:04 PM
Replies: 7
Views: 18,487
Posted By m.glisson003

Re: D16Z6 mini me swap help

Alright so I believe I fixed the hoses so that they are according to the diagram. By the way thanks for that, it really helped alot.

In the first picture here I switched this hose so that it is...
06-17-2012, 02:52 PM
Replies: 7
Views: 18,487
Posted By m.glisson003

Re: D16Z6 mini me swap help

Here are some other things im not sure about...

In the first picture is a piece with 4 hoses. I know where all of the hoses go but one. As you can see in the pic one goes to the valve cover,...
06-17-2012, 02:42 PM
Replies: 7
Views: 18,487
Posted By m.glisson003

Re: D16Z6 mini me swap help

Thank you! You were right for all of them. The wire in the first pic did go to the sensor on the throttle body. The thermostat sensor did have the remains from an old plug from the other wiring...
06-17-2012, 12:42 PM
Replies: 7
Views: 18,487
Posted By m.glisson003

D16Z6 mini me swap help

Put a D16Z6 cylinder head on my D15B7 block. Also using a D16Z6 intake manifold. I put the engine in my car and started hooking up hoses and wires and there are some wires that I cant find a spot...
12-26-2011, 02:49 PM
Replies: 4
Views: 608
Posted By m.glisson003

What part of the headlight is this?

Its on a del sol headlight. Im painting the housing black and am not sure if shoud paint this black as well.
Forum: Honda / Acura
12-24-2011, 05:14 PM
Replies: 3,092
Views: 1,198,202
Posted By m.glisson003

Re: Post Your Interior!!! THREAD

The lighting isnt very good in the second picture. And I have a black w/ blue stitching shift boot in the car now.
12-21-2011, 11:27 PM
Replies: 19
Views: 2,254
Posted By m.glisson003

Re: Port on top left of valve cover

Perhaps. If I dont get an answer here then I will get it elsewhere. No big deal. Either way I get what I want.
12-21-2011, 12:06 PM
Replies: 19
Views: 2,254
Posted By m.glisson003

12-21-2011, 12:04 PM
Replies: 19
Views: 2,254
Posted By m.glisson003

12-21-2011, 12:03 PM
Replies: 19
Views: 2,254
Posted By m.glisson003

Re: Port on top left of valve cover

And do you know how hard it is to see pictures on a 2 x 1 1/2 inch screen? I chose what it easiest and most convinient for me. Im sorry that you have a problem with that.
12-21-2011, 12:01 PM
Replies: 19
Views: 2,254
Posted By m.glisson003

Re: Port on top left of valve cover

I appreciate your advice but I will do what I please. And if I choose to ask on honda-tech because I dont have access to my manuals at the moment then I will. Thanks.
12-21-2011, 11:30 AM
Replies: 19
Views: 2,254
Posted By m.glisson003

Re: Port on top left of valve cover

I have a few manuals. Its just easier for me to ask here than it is to look it up.
Showing results 1 to 25 of 87
 


 
Forum Jump


All times are GMT -8. The time now is 03:34 PM.