Notices
 
Search: Posts Made By: SolScifen
Showing results 1 to 25 of 377
Search took 0.60 seconds.
Forum: Acura Integra
03-17-2014, 05:13 PM
Replies: 8
Views: 792
Posted By SolScifen

Re: New head gasket and my car is burning oil help guy please

did you torque the head down in the right sequence? middle to outside?

have you looked to see if theres any noticeable place where oil is leaking on the outside of the engine? it could be from...
Forum: Acura Integra
03-17-2014, 05:06 PM
Replies: 13
Views: 1,552
Posted By SolScifen

Re: High idle @2000RPM- already replaced IACV

fast idle valve stuck open?
Forum: Acura Integra
03-17-2014, 05:02 PM
Replies: 19
Views: 7,761
Posted By SolScifen

Re: Possible TPS and MAP sensor Code causes??

are the plugs on the sensors loose? maybe a bad connection?

does it actually run bad, or just throw the codes?
Forum: Acura Integra
08-29-2013, 03:30 PM
Replies: 3
Views: 951
Posted By SolScifen

Re: Where can I buy a "jdm" engine?

You can try jdmtechmotors, they're out of Orlando, FL. I bought a b20 from them with no problems at all.
Forum: Acura Integra
08-29-2013, 03:24 PM
Replies: 1
Views: 1,906
Posted By SolScifen

Re: PLEASE HELP!

Have you tried bleeding the system?
Forum: Acura Integra
08-05-2013, 05:27 AM
Replies: 4
Views: 1,100
Posted By SolScifen

Re: 98 integra ls, starter doesnt spin, power to everything

Wow, so after rechecking grounds and wires in engine bay, I go to check the ignition switch, as I'm taking apart the pieces under the dash I notice all this plastic at the top of my floormat.
It...
Forum: Acura Integra
08-04-2013, 01:40 PM
Replies: 4
Views: 1,100
Posted By SolScifen

98 integra ls, starter doesnt spin, power to everything

I bought a 98 ls about a week ago, all stock, and everything worked perfectly. Yesterday I went to start it and got nothing at onII, like as if the battery was dead.
Battery is good and have tested...
Forum: Acura Integra
07-02-2013, 05:32 PM
Replies: 2
Views: 637
Posted By SolScifen

Re: Ground control's with KYB AGX's ? G3 teg.

See what they came off of, I'm pretty sure I seen they have different sleeves for kyb and some other shocks vs koni
Forum: Acura Integra
06-18-2013, 12:45 PM
Replies: 11
Views: 1,130
Posted By SolScifen

Re: need help with my 92 gsr no vetch

^exactly, are you sure its a good sensor you got?

Vtec will not engage if the cel is on.
Forum: Tech / Misc
06-17-2013, 05:15 AM
Replies: 1
Views: 695
Posted By SolScifen

Re: skunk 2 cams noisy

Valve lash set to what skunk2 reccomends?
Forum: Acura Integra
06-17-2013, 05:06 AM
Replies: 4
Views: 1,136
Posted By SolScifen

Re: 3000-3200 RPM CAR ACTS CRAZY HELP !!!

Not saying it is, but i had a problem similar to this and it ended up being the ecu.
Forum: Tech / Misc
06-13-2013, 11:56 AM
Replies: 4
Views: 843
Posted By SolScifen

Re: 97 hatch fuel pump won't prime

The cel will stay on if there's no fuel pressure.
It could be wiring or a bad ecu.
Forum: Tech / Misc
06-13-2013, 11:51 AM
Replies: 5
Views: 1,836
Posted By SolScifen

Re: no start after 10 minutes

Get your icm tested. They can fail with heat.
Forum: Acura Integra
06-13-2013, 11:19 AM
Replies: 9
Views: 1,094
Posted By SolScifen

Re: Oil INSIDE dizzy cap+burnt rotor.

I would assume any b series distributor have the same seal.

On a side note, do you have a gsr motor? If you keep throwing code 9 and having problems (and if I'm understanding right that you have...
Forum: Acura Integra
06-12-2013, 10:54 AM
Replies: 5
Views: 1,517
Posted By SolScifen

Re: B20 for the newbie

A lil mix of everything you thought. Its just a cheap motor choice thats semi powerful out the box.
Forum: Acura Integra
06-12-2013, 10:47 AM
Replies: 12
Views: 1,864
Posted By SolScifen

Re: 92 integra won't hold steady RPM, bogging

If I'm thinking of the same green plug as you, i forget what its for but I have it disconnected with no problems
Forum: Acura Integra
06-11-2013, 04:53 PM
Replies: 9
Views: 1,094
Posted By SolScifen

Re: Oil INSIDE dizzy cap+burnt rotor.

Well I learned something new today, I thought that was the only one that dealt with oil.
Its one of these then. http://www.partstrain.com/store/?N=0&src=search&Ntt=distributor+o-ring
According to...
Forum: Acura Integra
06-11-2013, 04:33 PM
Replies: 12
Views: 1,864
Posted By SolScifen

Re: 92 integra won't hold steady RPM, bogging

Tps should be at .5v closed and 4.5v at wot. At 5.5 its out of spec and will cause problems.
Forum: Acura Integra
06-11-2013, 04:27 PM
Replies: 9
Views: 1,094
Posted By SolScifen

Re: Oil INSIDE dizzy cap+burnt rotor.

#7 in the diagram would be the culprit. Its what seals where the distributor goes through the head and into your cam.
Forum: Acura Integra
06-11-2013, 04:21 PM
Replies: 0
Views: 925
Posted By SolScifen

92 wiper switch/motor

My wipers only work if I hold the lever to spray fluid. Turning the switch for different speeds does nothing.
Am I right assuming the actual wiper motor is fine and its just a problem with the...
Forum: Acura Integra
06-07-2013, 08:32 AM
Replies: 12
Views: 1,267
Posted By SolScifen

Re: Body Kits for 2000 Acura Integra

Check andysautosport, and have fun doin your car the way you want.
Forum: Acura Integra
06-03-2013, 12:35 PM
Replies: 4
Views: 1,308
Posted By SolScifen

Re: Integra ls Harness issues

So do you have automatic tranny with engine? Or manual?
The automatic engine harness should work, in my teg (92) I just had extra plugs that wernt needed for evap.
But if you have auto tranny you...
Forum: Acura Integra
06-03-2013, 04:27 AM
Replies: 1
Views: 629
Posted By SolScifen

Re: rear sway bar install

Look at the hole for the endlink on the lca, is there thread in it or no? Answer solved.
I wanna say aftermarket are not threaded so you'll need a nut and bolt.
Forum: Acura Integra
06-02-2013, 08:58 PM
Replies: 6
Views: 1,261
Posted By SolScifen

Re: 1990 integra bogs and bad idle (HELP)

Well the dropping rpms from idle makes it sound like timing or a fuel delivery problem, whens last time fuel filter was replaced? I assume your running injectors from a previous motor so they should...
Forum: Acura Integra
06-01-2013, 09:22 PM
Replies: 6
Views: 1,261
Posted By SolScifen

Re: 1990 integra bogs and bad idle (HELP)

You are running the obd0 distributor? Checked there's spark and fuel in each cylinder?
By bogging do you mean its missing? If so is it like that at idle?
Is it throwing any codes?

Doesn't the...
Showing results 1 to 25 of 377
 


 
Forum Jump


All times are GMT -8. The time now is 03:13 AM.