Notices
Search: Posts Made By: Slow HX
Showing results 1 to 12 of 12
Search took 0.19 seconds.
07-09-2011, 09:13 AM
Replies: 6,999
Views: 723,569
Posted By Slow HX

Re: *** Official What You did to your eg/ek today ***

Threw away my junk-ass skunk2 LCA's and put factory arms back on then aligned it. Made a new battery ground cable and added an extra one. Changed the oil and filter, Brad Penn and Honda. All that in...
06-14-2011, 09:30 AM
Replies: 6,999
Views: 723,569
Posted By Slow HX

Re: *** Official What You did to your eg/ek today ***

An intake and filter will give you the most noticable increase in power or put wheels on it cause nothing makes a ride look better than a set of hoops.:)
06-13-2011, 09:37 AM
Replies: 6,999
Views: 723,569
Posted By Slow HX

Re: *** Official What You did to your eg/ek today ***

Putting my interior back in. Headliner is back to new and trim is back to the right color. Dynamat on the roof and package tray is done. I did take it the track this weekend while all the inside was...
05-20-2011, 04:58 PM
Replies: 6
Views: 945
Posted By Slow HX

Re: ground control sleeves on skunk 2 struts?

Just put Tokico hp's on. Im on my second set (as of 2 months ago) after 7 years and 190,000 miles. Thats with Ground Controls and the top of my tires slightly tucked/even.
05-20-2011, 04:44 PM
Replies: 5
Views: 5,409
Posted By Slow HX

Re: motor mount studs too short on drivers side; B20 swap with avid mounts

measure the length you need and go to the hardware store and by grade 8 bolts and washers, use lock-tite. i had to do the same thing with my avid mounts
05-12-2011, 01:44 PM
Replies: 6,999
Views: 723,569
Posted By Slow HX

Re: *** Official What You did to your eg/ek today ***

Got my wheels back from the wheel guy and mounted back on. Lookin good. Also put new pads on the rear and did the new motors first oil change.
04-26-2011, 10:59 AM
Replies: 15
Views: 3,147
Posted By Slow HX

Re: b18c1 info?

Well if you put the B16 head on a GSR then it lowers the C/R. I just finished my motor, a GSR, and I went with the USDM B16 pistons, stock bore, un-milled head and block, ITR cams, ACL bearings. My...
04-23-2011, 10:47 PM
Replies: 22
Views: 10,688
Posted By Slow HX

Re: Help diagnosing AC electrical issue

The clutch is held on by one nut. Ive seen it a few times where its just broken off on a customers car. I would change the field coil, pulley and clutch before i went and bought a new compressor. The...
04-23-2011, 10:23 PM
Replies: 15
Views: 31,836
Posted By Slow HX

Re: Speedometer and Odometer NOT WORKING!!

Take the cluster out and see if the four screws that the hold the gauge to the body have come lose. Those screws also give the connection to the gauge. Hope that helps.
04-23-2011, 10:18 PM
Replies: 29
Views: 39,880
Posted By Slow HX

Re: Steering issue, car sways while cruising.

Ok so first off, you've changed settings without an alignment. This changes your toe and more importantly your thrust angle and total toe if it was done to the rear. Second, any play in your inner...
04-19-2011, 03:13 PM
Replies: 29
Views: 39,880
Posted By Slow HX

Re: Steering issue, car sways while cruising.

Id start by checking all the bushings and ball joints, don't forget the rear bushing as well. Also check the shocks, if they are covered in oil or if you push down on each corner of the car and it...
01-26-2011, 11:42 AM
Replies: 6,999
Views: 723,569
Posted By Slow HX

Re: *** Official What You did to your eg/ek today ***

nothing... but i did open it up on the Bush tollway today, 120 feels goooood, damn you speed limiter..
Showing results 1 to 12 of 12


 
Forum Jump


All times are GMT -8. The time now is 09:19 AM.