Honda-Tech - Honda Forum Discussion

Notices
 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: SiRCiviC94
Showing results 1 to 25 of 498
Search took 1.13 seconds.
Forum: Transmission & Drivetrain
02-17-2017, 09:35 PM
Replies: 1
Views: 345
Posted By SiRCiviC94

Check my itr 4.7 syncro

Hey it's been a while I got a trans as I often do with their fine stories of history. The said rebuilt trans I was able to identify some syncros that were not new and some that appeared to be.

I...
Forum: Forced Induction
05-30-2016, 03:44 AM
Replies: 4
Views: 509
Posted By SiRCiviC94

Re: S300 special wiring for VX

It's a p28
Forum: Forced Induction
05-30-2016, 03:43 AM
Replies: 4
Views: 509
Posted By SiRCiviC94

Re: S300 special wiring for VX

Figured id update , car works fine it's the only one in the world that shares that wire I have a joint a11 orignal wire , boost solenoid shared.

Clip damage, cars had the ecu in and out over 500...
Forum: Forced Induction
05-20-2016, 04:49 PM
Replies: 4
Views: 509
Posted By SiRCiviC94

S300 special wiring for VX

Wiring boost solenoid to vx ecu harness

I can't use A11 it's a main ecu ground on this harness, or can I and share it? Maybe?

Ideas ? There's other grounds but not sure I can eliminate any.
...
Forum: Drag Racing
06-30-2015, 12:03 PM
Replies: 2
Views: 924
Posted By SiRCiviC94

quick 23' to 24.5 Q

I have a 94 eg hb with a stock b16 turbo 57 trim best et on slicks 12.9 with a 1.9 60 foot.

the trans is b16a lsd

with the 23 I run 7.5 psi before burn out

with the 23 I run out of gear just...
Forum: Tech / Misc
02-23-2015, 06:10 AM
Replies: 8
Views: 2,803
Posted By SiRCiviC94

Re: Broken VTec pressure switch

Can't say for sure, it it's probably ripped out already and no thread left. Once the jb is off the block case has to be machined and cleaned lol

I'm happier with how it is at this time since it...
Forum: Tech / Misc
02-21-2015, 03:53 PM
Replies: 8
Views: 2,803
Posted By SiRCiviC94

Re: Broken VTec pressure switch

Looks like I'll sell it as running since no leaks. Sucks tho
Forum: Tech / Misc
02-21-2015, 01:56 PM
Replies: 8
Views: 2,803
Posted By SiRCiviC94

Re: Broken VTec pressure switch

My mistake yes the oil pressure sensor.

It's jb welded I am super skeptical of that
Forum: Tech / Misc
02-21-2015, 11:40 AM
Replies: 8
Views: 2,803
Posted By SiRCiviC94

Re: Broken VTec pressure switch

Sure bypass the wiring. But how hack is this jb weld is it under pressure? % chance it's going to ruin the engine at some point?

I'm really iffy. Also from a sale stand point is it for parts or...
Forum: Tech / Misc
02-21-2015, 09:49 AM
Replies: 8
Views: 2,803
Posted By SiRCiviC94

Broken VTec pressure switch

Got a block where the pressure switch broke off and was bj welded shut. Now what?

It's a usdm b18c1 Gsr engine

I may have to scrap the block I am a little curious what affect this would have?...
Forum: Forced Induction
02-01-2015, 05:31 AM
Replies: 24
Views: 5,191
Posted By SiRCiviC94

Re: Anyone running a catchcan can help?

My 2 cents I left the black box as it was with a new pcv.. It prob does nothing under boost. 2 -10 ports to catch can off the valve
Cover vent plenty and no oil build up cause it's on the front...
Forum: Honda Civic / Del Sol (1992 - 2000)
01-26-2015, 12:34 PM
Replies: 12
Views: 751
Posted By SiRCiviC94

Re: Eg rearquarter panel weird gap

Ok more effort into the ACTUAL PIC. Lol



tinypic wont upload today so we can just delete. I wanted to collect the car till I noticed the gap
Forum: Honda Civic / Del Sol (1992 - 2000)
01-26-2015, 12:32 PM
Replies: 12
Views: 751
Posted By SiRCiviC94

Eg rearquarter panel weird gap

I'm looking at an eg and there is a noticeable difference in height where the lower rear quarter and door line meet. Quarters were replaced. Maybe with bad fitment ones?

Picture the door mouldings...
Forum: Forced Induction
01-19-2015, 08:53 PM
Replies: 179
Views: 15,032
Posted By SiRCiviC94

Re: My new turbo b16a2 setup barely making 300hp after tune??

Something really wrong my bone stock b16 w 680cc injectors / 255lph makes over 300whp/220wtq. Tuner seems pretty new for 1. Fix the boost regulator issue so you can add and tune more boost. I'm at 10...
Forum: Forced Induction
11-29-2014, 12:31 PM
Replies: 9
Views: 3,572
Posted By SiRCiviC94

Re: Oil Squirters for Turbo??

Personally I'd rather have them. But there is many ls VTec set ups that have nothing there
Forum: Engine Management and Tuning
11-29-2014, 07:36 AM
Replies: 17
Views: 3,944
Posted By SiRCiviC94

Re: at what afr do you start to wash the rings

Some of the best tuners will say 11-12 is ok under light load if u gotta drive to see the tuner... Same for running 17+... Apparently not hurting anything short period of time.

Rich mixture def...
Forum: Engine Management and Tuning
11-29-2014, 07:35 AM
Replies: 17
Views: 3,944
Posted By SiRCiviC94

Re: at what afr do you start to wash the rings

My car starts at 14.7 hot or cold dunno what the tuner did hah
Forum: Forced Induction
11-22-2014, 05:21 AM
Replies: 9
Views: 13,737
Posted By SiRCiviC94

Re: B16B TYPE R BOOSTED SAFE WITH STOCK INTERNAL?

Better use octane booster 91 octane is border line
Forum: Forced Induction
11-20-2014, 08:57 PM
Replies: 17
Views: 1,002
Posted By SiRCiviC94

Re: OK GUYS I'm NEW TO THE HONDA GAME

Here you could do a b18c (own tools and labor ) for $1000 and a turbo set up $1500 clutch and tune 1000$ car and suspension 1-2000$ Better save up

New to the game this will cost a lot more...
Forum: Forced Induction
11-14-2014, 06:42 AM
Replies: 17
Views: 5,838
Posted By SiRCiviC94

Re: Why not oem pistons

Ring lands blow off around 350whp

I'm shooting for about 350-375 in spring with lots of tuning .... And it'll prob blow..

Then no more fkn around lol
Forum: Forced Induction
11-08-2014, 06:40 AM
Replies: 16
Views: 1,807
Posted By SiRCiviC94

Re: 98 Integra Built B18 T3/T4 on 10psi. 310hp What Clutch?

Act xtreme street disk combo and never look back

I have this and want a 6 puck only cause I like a really aggressive shift
Forum: Forced Induction
11-05-2014, 09:49 PM
Replies: 5,058
Views: 820,115
Posted By SiRCiviC94

re: ***The Official Nitrous Thread***

set it up. key on. press zex box. light red. push gas for 5 seconds. light goes green. i have the instructions can double check if no work
Forum: Forced Induction
08-27-2014, 02:16 PM
Replies: 59
Views: 11,575
Posted By SiRCiviC94

Re: oil temp too hot?

10w40 no issues
Forum: Honda Civic / Del Sol (1992 - 2000)
08-27-2014, 05:39 AM
Replies: 15
Views: 1,054
Posted By SiRCiviC94

Re: Stumped! Car runs rough no cel Jdm Gsr

Dizzy cap had a crack, removed it and there's a bolt inside with plastic shavings.

Now to see if the shady importers will honor their warranty
Forum: Honda Civic / Del Sol (1992 - 2000)
08-26-2014, 06:45 PM
Replies: 15
Views: 1,054
Posted By SiRCiviC94

Re: Stumped! Car runs rough no cel Jdm Gsr

So weird. Well it ran on 1 and 2 fine on its own and then ran on 3-4 on its own.

With it all hooked up my wideband just shows 18+ no fuel.

Weak spark eh? I'll be pissed !!! Lol update tmrw....
Showing results 1 to 25 of 498
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump


All times are GMT -8. The time now is 05:30 AM.