Notices
 
Search: Posts Made By: MONEY888
Showing results 1 to 25 of 30
Search took 0.20 seconds.
12-23-2010, 07:23 PM
Replies: 30
Views: 64,238
Posted By MONEY888

Re: Engine flooded with fuel and now won't start

Change out that oil cause its fouled from the fuel and get yourself a good fuel pressureregulator and a fuel gage too go along with it .
12-23-2010, 07:13 PM
Replies: 11
Views: 1,150
Posted By MONEY888

Re: drove to work, at lunch wont start

Hey guy did you check for spark if you dont have spark the engine wont fire up and if you dont have spark it might be the internal coil inside the distributor too check if you got spark i dont know...
12-23-2010, 07:00 PM
Replies: 6
Views: 1,763
Posted By MONEY888

Re: few questions about ef replacement harness

Heres a quick tiP Guy........Just get a harness out of a 92 and up civic eg and get the harness of a car that is complete stock if you can and begin the process lable every plug so ull know where it...
12-23-2010, 06:48 PM
Replies: 14
Views: 3,234
Posted By MONEY888

Re: engine vibrates at idle unless heater is on

Do a Voltage drop first too determine if you have an overload.
12-23-2010, 09:06 AM
Replies: 20
Views: 21,213
Posted By MONEY888

Re: Engine Failure second one-3.5

Sounds like operator fault maybe you didnt keep up with oil changes and filter changes you should split open the oilfilter too see if u got particles in the filter then u can inpoint what happened...
Forum: Acura Integra
12-23-2010, 08:58 AM
Replies: 10
Views: 1,414
Posted By MONEY888

Re: how many head studs do i need?

Just use the factory ones Arp are good but for street use u dont need them if ur on a budget pluss its not like your producing major hp.
Forum: Tech / Misc
12-23-2010, 08:55 AM
Replies: 4
Views: 941
Posted By MONEY888

Re: 95 ex coupe fuel pump doesn't purge

Hey wutS crackin I see you have problems ,heres one thing too check on the drivers side engine harness in the engine compartment there is a three plugs and one of them has a blockoff meanning there...
Forum: Honda / Acura
12-23-2010, 08:44 AM
Replies: 113
Views: 15,776
Posted By MONEY888

Re: It sucks to roll hard..

Id just like too say your car LooKS SIIIIIIIIIIIIIICK thats how we Roll in L.A. and the BIG S.G.V....keep on rolliN Hoomie.Represent and dont let no hater hate u got a nice ride turbo it so itll be...
12-23-2010, 08:30 AM
Replies: 9
Views: 11,106
Posted By MONEY888

Re: Diagnose lower ball joints? 1995 honda civic ex

I agree with what hommie just posted about that ball joint If I were you id jack the car up and separate the lower control arm and spindle and check it by hand youll know if its really bad and if the...
12-23-2010, 08:23 AM
Replies: 21
Views: 1,201
Posted By MONEY888

Re: over heating problem

it might be the coolent temp sensor going bad ,also did you Bleed out the air out the system try that guy .Good LucK.
12-20-2010, 06:34 AM
Replies: 11
Views: 1,170
Posted By MONEY888

Re: Gsr Build Questions

Hey guy word of advice get all new rods and use factory gsr bearings get everything balanced fly wheel ,crank pulleywith bolt and washer, pressureplate, also for the head get it pressurechecked and...
12-20-2010, 06:25 AM
Replies: 93
Views: 26,428
Posted By MONEY888

Re: b16 or b20vtec

Hey dude , id go b20 its 2.0 stock if you can rebuild it using real gsr crankshaft bearings and get everything balanced if u got the cash punch it out too 96 mm and use a gsr head with a square port...
12-20-2010, 06:18 AM
Replies: 9
Views: 5,158
Posted By MONEY888

Re: all motor GSR block B16 head questions...

Id go with the GSR head and go high compression all motor if i was you boost is more maintenance and more money the gsr head is the way too go, look at the combustion chamber its quenched which is...
Forum: Acura Integra
12-20-2010, 06:13 AM
Replies: 2
Views: 792
Posted By MONEY888

Re: would a crankshaft gear off of a b20z fit a b18a1?

Yes itll fit but I wouldnt interchange them cause itll throw the balance off its like all these guys think getting a light crankpulley is cool well at first till you start throwing hiogh revs and...
12-20-2010, 06:07 AM
Replies: 34
Views: 18,719
Posted By MONEY888

Re: need help what to install on d17 for more power im new to this

The fast way too gain more power is NOS if your down with it or simply get a K series if you got the cash in hand fixing up that little motor is a no nO , step it up and K series it .
12-20-2010, 06:04 AM
Replies: 10
Views: 4,921
Posted By MONEY888

Re: Car dies after warming up

or you might have a slightly blown head gasket and maybe there is coolant entering the cylinder causing your engine too die out .Do a compression test look at the plugs also .
12-20-2010, 06:02 AM
Replies: 10
Views: 4,921
Posted By MONEY888

Re: Car dies after warming up

Hey wuts up have youve done a compression test if u havent try doing one it might be your valves are not seating right .
Forum: Tech / Misc
12-20-2010, 05:25 AM
Replies: 8
Views: 18,481
Posted By MONEY888

Re: Timing tensioner bolt hole stripped

Hey wuts up here is the fastest way do what u said on the post if you can helicoil it or better yet if you can get a Timesert that is stronger and if you putting a timesert add some jb weld on the...
12-20-2010, 05:19 AM
Replies: 29
Views: 7,984
Posted By MONEY888

Re: How much is this helmet worth?

I like that Gambler helmet you should try posting it on craigslist in in tw. right now what city u stay in im out of arcadia and isntthat an xl i need a medium hit me up if its that size.
Forum: Honda S2000
12-20-2010, 05:14 AM
Replies: 4
Views: 11,348
Posted By MONEY888

Re: show me a pix of ground wire to engine block?

Hey guy there is three grounds one off the valvecover that goes grounded too the from core support and the second one should be off the tranny too the chassis of the car and the third one is where...
12-19-2010, 10:49 AM
Replies: 9
Views: 1,903
Posted By MONEY888

Re: ignition timing probs

Lesson learned and if you buy a timming light buy a snap on with adjustable retard and advance.
12-19-2010, 10:42 AM
Replies: 21
Views: 18,894
Posted By MONEY888

Re: Dead miss on cylinder one, no fire to injector.

if you have a dead cylinder try doing a compression test on all 4 cylinders see if you see a difference in the readings also when checking out the spark plugs look at them closely and it will tell u...
Forum: Honda Prelude
12-19-2010, 10:30 AM
Replies: 35
Views: 2,720
Posted By MONEY888

Re: OVERHEATING

you might have a blown head gasket or a small leak youve overlooked , check your fans fuse and make sure too purge any a out the system.
Forum: Tech / Misc
12-18-2010, 09:23 PM
Replies: 3
Views: 1,841
Posted By MONEY888

Re: JDM B18C Didnt Pass Emissions

sounds like your ecm its jdm u said right, also have you given it a tune up sparkplugs and also check that your gas cap is good , also ur cat and before you go retest drive the car for about a hour...
Forum: Tech / Misc
12-18-2010, 09:17 PM
Replies: 8
Views: 1,812
Posted By MONEY888

Re: Valve Spring Tech

Call the dealer or do a spring rate check look in the book too see what the spring rate is.
Showing results 1 to 25 of 30
 


 
Forum Jump


All times are GMT -8. The time now is 05:38 PM.