Honda-Tech - Honda Forum Discussion

Notices
 
Page 1 of 3
1
2
3
Search: Posts Made By: edogmb
Showing results 1 to 25 of 72
Search took 0.23 seconds.
Forum: Honda Accord (1990 - 2002)
10-03-2012, 06:03 PM
Replies: 9
Views: 5,941
Posted By edogmb

Re: opinions on cv joint replacement

just an update...today I replaced my passenger side cv axle. It took about two hours at a very relaxed pace. My car (unexpectedly) already seems to be handling much better. I only got up to about...
Forum: Honda Accord (1990 - 2002)
10-02-2012, 05:39 AM
Replies: 9
Views: 5,941
Posted By edogmb

Re: opinions on cv joint replacement

That's very good info...thank you. And yes, my car is auto. I think I will have to do just that and replace both sides, as it is not too expensive. Not to beat a dead horse, but my car is not only...
Forum: Honda Accord (1990 - 2002)
10-02-2012, 04:39 AM
Replies: 9
Views: 5,941
Posted By edogmb

Re: opinions on cv joint replacement

good pic...and I understand better what you were saying. My 92 axle does not bolt into the block though. The setup looks a bit different. My axle has an inboard and outboard joint, and is only held...
Forum: Honda Accord (1990 - 2002)
10-01-2012, 04:01 AM
Replies: 9
Views: 5,941
Posted By edogmb

Re: opinions on cv joint replacement

thanx for the input dglass.....i already did the reverse test with wheel locked in both directions. There was no clicking or indication to speak of. I have heard of a carrier bearing, but have never...
Forum: Honda Accord (1990 - 2002)
09-30-2012, 08:10 AM
Replies: 9
Views: 5,941
Posted By edogmb

opinions on cv joint replacement

I have recently replaced most of my front end. Within past few months, I've done my:
~rotors
~pads
~LCA's
~shocks/struts
~new tires
~hub and bearing assemblies
~sway bar links
~tie rod ends...
Forum: Honda Accord (1990 - 2002)
07-07-2012, 10:40 AM
Replies: 6
Views: 1,155
Posted By edogmb

Re: Messy stearing: Bad control arm bushings, what's the best way to go?

I just replaced my LCA's with cheap parts from rock auto...the bushings themselves seem a little softer than I would like. I am looking at buying Moog from here on, and there are lots of places that...
Forum: Honda Accord (1990 - 2002)
07-07-2012, 10:30 AM
Replies: 1
Views: 888
Posted By edogmb

Re: d4 light dims when accellerating, and not your typical TCM issue

:bump:
I know my last post was loooong winded, but just wanted to see if anyone with my gen accord (92) has had this issue. My D4 light is still dimming when i hit the gas, and then coming on very...
Forum: Honda Accord (1990 - 2002)
07-07-2012, 04:15 AM
Replies: 8
Views: 4,165
Posted By edogmb

Re: bad new lower control arm bushings?

Moog....I already bought a few moog chassis parts like stabalizer arm bushings and sway bar bushings. so far so good here too....thanx
Forum: Honda Accord (1990 - 2002)
07-04-2012, 09:28 AM
Replies: 12
Views: 1,728
Posted By edogmb

Re: starting problem i haven't seen before

ok. that seems more normal to me the way you describe it. I was assuming when you pressed the gas down hard it tried to stall upon pressing. The way you describe it seems more like a throttle...
Forum: Honda Accord (1990 - 2002)
07-04-2012, 03:49 AM
Replies: 8
Views: 4,165
Posted By edogmb

Re: bad new lower control arm bushings?

Did u install the entire LCA or just the bushings? The LCAs i got were Dorman parts, but I also got them from rock auto parts. I'm thinking about getting some poly bushings and starting to replace...
Forum: Honda Accord (1990 - 2002)
07-03-2012, 02:30 PM
Replies: 8
Views: 4,165
Posted By edogmb

Re: bad new lower control arm bushings?

If it IS because of the cheap quality, do you have any recommendations on any preferred bushings that I could install in my old LCA's to reinstall?
Forum: Honda Accord (1990 - 2002)
07-03-2012, 02:27 PM
Replies: 8
Views: 4,165
Posted By edogmb

Re: bad new lower control arm bushings?

They aren't exactly "loose", but I can move my damper fork a little back and forth simply by grabbing it with my hand and tugging on it. And yes, they are torqued down now...there is just a little...
Forum: Honda Accord (1990 - 2002)
07-03-2012, 02:24 PM
Replies: 11
Views: 11,263
Posted By edogmb

Re: 2000 Honda Accord V6 Intermittent Immediate Stall Upon Start

A bad MAP sensor can cause your car to run like poo... I have used seafoam plenty of times, and with good results so far. It is just not to be used too often, especially with high milage cars. I dont...
Forum: Honda Accord (1990 - 2002)
07-03-2012, 02:13 PM
Replies: 12
Views: 1,728
Posted By edogmb

Re: starting problem i haven't seen before

I would take it for a few laps around the block or up and down the street to start with. Also, I would check all of your fluids to make sure everything looks normal before letting it run. It could be...
Forum: Honda Accord (1990 - 2002)
07-03-2012, 01:44 PM
Replies: 12
Views: 1,728
Posted By edogmb

Re: starting problem i haven't seen before

the car staring up in neutral better than park is a mystery.....to me at least....sorry :shrug:
As for the wetness under the muffler, it is probably water escaping the muffler through the weephole,...
Forum: Honda Accord (1990 - 2002)
07-03-2012, 01:32 PM
Replies: 8
Views: 4,165
Posted By edogmb

bad new lower control arm bushings?

I recently replaced my lower control arms with new aftermarket ones. My bushings were cracked and worn and I thought it would be easier to buy the whole LCA's and install them rather than trying to...
Forum: Honda Accord (1990 - 2002)
07-02-2012, 10:39 AM
Replies: 1
Views: 888
Posted By edogmb

d4 light dims when accellerating, and not your typical TCM issue

Hello all. I have been searching this issue and have not found a whole lot of useful info pertaining to my particular problem. Bear with me as I will describe things the best i can.

I have a 92...
Forum: Honda Accord (1990 - 2002)
05-15-2012, 12:39 PM
Replies: 5
Views: 7,515
Posted By edogmb

Re: Should i get motor mounts from a dealer or a auto parts store

I would say it depends on exactly how bad they are, but i dnt think I would say "dangerous"...maybe "unadvisable". You can do further damage to your car (axles and such) so if it is absolutely...
Forum: Honda Accord (1990 - 2002)
05-15-2012, 12:26 PM
Replies: 5
Views: 15,713
Posted By edogmb

Re: slams into gear when warm???

...thanks for the input...
I have tried cleaning out the solenoids a couple of times but the screens themselves seemed pretty good. The one thing I will mention is that the last time I tested the...
Forum: Honda Accord (1990 - 2002)
05-15-2012, 08:12 AM
Replies: 5
Views: 15,713
Posted By edogmb

Re: slams into gear when warm???

Ok...so I'm not so concerned about the speedo or tach anymore since a bad vss should set off a CEL, and the dist and ICM are new.
I am concerned about the car slamming roughly into gear though. It...
Forum: Honda Accord (1990 - 2002)
05-15-2012, 07:54 AM
Replies: 23
Views: 6,516
Posted By edogmb

Re: Valve Adjustment Issue! Please Help!

I know its more time-consuming...but I find it easier to adjust the valve clearance on each individual valve when the lowest part of the cam lobe is at the arm. That way is fail-safe....and even if...
Forum: Honda Accord (1990 - 2002)
05-14-2012, 12:38 PM
Replies: 5
Views: 15,713
Posted By edogmb

slams into gear when warm???

I noticed a while back that my transmission was shifting harshly out of park, but only when warm. When I back up out of my driveway and get going in the morning its fine, but once it heats up to...
Forum: Honda Accord (1990 - 2002)
05-14-2012, 11:58 AM
Replies: 23
Views: 6,516
Posted By edogmb

Re: Valve Adjustment Issue! Please Help!

I would say to keep on with the sensor replacement...knock, O2, and IACV can be the difference between a lousy ride and a smooth one. Also, since oil was all over your engine I would definitely check...
Forum: Honda Accord (1990 - 2002)
05-13-2012, 01:30 PM
Replies: 8
Views: 27,687
Posted By edogmb

Re: 1994 honda accord lx..how many quarts of auto tranny fluid? (Overmind22)

It is not recommended to put ANYTHING other than Honda ATF into your transmission!!! I'm not speaking from personal experience here (as I have always used Honda ATF)....but there seems to be a very...
Forum: Honda Accord (1990 - 2002)
05-13-2012, 08:34 AM
Replies: 4
Views: 5,527
Posted By edogmb

Re: IACV hummmmm...

I do not have any codes showing up, and my ecu seems to work. It lights up briefly after i turn the ignition "on"...and when I disconnect my ICAV it shows the right code...
Showing results 1 to 25 of 72
 
Page 1 of 3
1
2
3


 
Forum Jump


All times are GMT -8. The time now is 08:52 PM.