Notices
 
Search: Posts Made By: nilleo
Showing results 1 to 25 of 42
Search took 0.22 seconds.
07-05-2011, 08:56 AM
Replies: 26
Views: 23,946
Posted By nilleo

Re: Viper SmartStart

or you could just connect it to one of the sensor port wires were sensors go?
04-04-2011, 04:11 PM
Replies: 6
Views: 3,741
Posted By nilleo

Re: viper alarm at best buy

I'd think twice about purchasing Viper/Clifford online.. there will be NO warranty at all.

As for purchasing the product at Best Buy without installation, you are not supposed to be able to, the...
04-04-2011, 04:01 PM
Replies: 11
Views: 2,442
Posted By nilleo

Re: Door trigger 96 hatch

ah, true on the if the green is also used for the relay coils! however, IIRC from experience and every install guide I can find for the 350HV states that the yellow ignition connection is the one set...
04-04-2011, 03:54 PM
Replies: 6
Views: 2,381
Posted By nilleo

Re: 508d defective?

try cutting power and ground off of the harness and connecting the 508D side straight to the same 12V power source as the alarm, and the ground to the GWA from the alarm. There are some cases where...
04-03-2011, 11:30 PM
Replies: 11
Views: 2,442
Posted By nilleo

Re: Door trigger 96 hatch

make sure that your yellow wire from the relay is connected to ignition, and not accessory. it should be a 12V source that comes on with the key and does not drop to >9V during crank. direction of...
04-02-2011, 07:56 AM
Replies: 5
Views: 3,188
Posted By nilleo

Re: Clifford Matrix 3.3x How to Adjust Alarm Noise

see attached file for the loop to cut. keep in mind this only increases your arm/disarm chirp. if you're full trigger volume is low, make sure your ground is clean and voltage drop free, and that the...
04-02-2011, 07:40 AM
Replies: 11
Views: 2,442
Posted By nilleo

Re: Door trigger 96 hatch

x2 easiest place to find it.
04-02-2011, 07:38 AM
Replies: 6
Views: 2,381
Posted By nilleo

Re: 508d defective?

make sure you're adjusting the full trigger zone first, then the warn away. I have mine under the center console and warns away if the windows are down and you come within a few inches of the window...
03-24-2011, 12:22 AM
Replies: 1
Views: 1,788
Posted By nilleo

Re: Viper 5901 H3/3, H3/6 & H3/9

If you're using it as alarm only, all you need is Pink from the H3.
02-18-2011, 09:17 PM
Replies: 3
Views: 3,299
Posted By nilleo

Re: need help with alarm/remote start

only other thing you need to do other than make the connection when it comes to the tach is to go through the tach learn procedure. Turn the car on with the key, and within 10 seconds press and hold...
02-18-2011, 09:06 PM
Replies: 5
Views: 23,723
Posted By nilleo

Re: Car alarm install at Best Buy?

Best Buy has several stores all over the world, but not all of them may have talent in the install bay. The lifetime nationwide warranty is a huge benefit, not to mention they're an authorized Viper...
02-18-2011, 08:54 PM
Replies: 3
Views: 3,299
Posted By nilleo

Re: need help with alarm/remote start

do not connect the GWA, unless you have an external relay that you're power with it. If all you're doing is starter kill, the purple and green wires will do that on their own when the system is...
11-05-2010, 11:14 AM
Replies: 10
Views: 8,796
Posted By nilleo

Re: Ignition Screws

With that switch and no other protection, yes you could still start the car, but you can't disable the ignition lock without turning or removing the tumbler. I totally understand your point, but even...
11-04-2010, 10:37 PM
Replies: 1
Views: 752
Posted By nilleo

Passed California Smog - 2000 HX some tips for others

Well my 2000 HX M/T finally passed smog the other day. It failed pretty bad on the NO the first time I smogged it after I bought it and I was told it was most likely a bad catalytic converter. For...
11-04-2010, 09:55 PM
Replies: 10
Views: 8,796
Posted By nilleo

Re: Ignition Screws

are you talking about for the back of the electronic switch? I looked for some at the local home depot and lowes, but didn't find any, pretty much gave up there as I lost interest. They have an...
11-04-2010, 09:52 PM
Replies: 21
Views: 25,979
Posted By nilleo

Re: Adding aux input on OEM Integra Radio.

You can usually open up a factory radio and solder directly onto the board at the internal amplifier's inputs, but you usually have to have either a blank noise CD playing or a dead FM station...
11-04-2010, 09:47 PM
11-04-2010, 09:38 PM
Replies: 11
Views: 7,286
Posted By nilleo

Re: Viper 5901 Manual Transmission

There's a simple solution. If you need to get something out of your car, remote start it, go to the car, disarm it, open the door, get whatever you need, close the door, arm it, and deactivate the...
11-04-2010, 09:33 PM
Replies: 9
Views: 960
Posted By nilleo

Re: Extremely quick installs...

nope, you never call, you let it sit a while longer, at least 30 minutes, maybe vacuum it, set the clock and presets :)
09-27-2010, 09:32 AM
Replies: 11
Views: 23,974
Posted By nilleo

Re: Help with anti-theft code for civic 2008

If you're the original owner go to https://radio-navicode.honda.com/ if you're not the original owner, try it anyway. You should also be able to call Honda of America for help.
09-21-2010, 10:40 AM
Replies: 63
Views: 40,310
Posted By nilleo

Re: Alarm/immobiliser issues with 2001 Civic type R

alternatively, you can continue using the voltage setting and place the red probe to a constant 12V source, and probe the wire you're testing for a ground with the black lead. If there is ground on...
09-19-2010, 02:04 AM
Replies: 137
Views: 14,090
Posted By nilleo

Re: My first build...EJ8!

Car is looking great!!! There's nothing wrong with fixing up the aesthetics, that's why you bought a car that hadn't been touched, so you don't have to fix it up as soon as you get it! Keep up the...
09-19-2010, 01:51 AM
Replies: 13
Views: 38,522
Posted By nilleo

Re: How do you replace an oil pan gasket on a 2000 civic?

did mine tonight, wasn't too fun. Now that I've done (and loosened all of the bolts/nuts) I could do it again a lot quicker, but I'd much rather not. :) FYI, if you plan on replacing the oil pan, go...
09-18-2010, 05:27 PM
Replies: 80
Views: 6,671
Posted By nilleo

Re: pretty sure someone made an attempt to steal my 99 si

If I were a thief, I'd stay the hell away from that car, I wouldn't even want people to think I was thinking about stealing it!
Showing results 1 to 25 of 42
 


 
Forum Jump


All times are GMT -8. The time now is 04:35 PM.