Notices
 
Search: Posts Made By: B18B1-Crx
Showing results 1 to 25 of 199
Search took 0.64 seconds.
03-14-2012, 10:39 PM
Replies: 597
Views: 74,079
Posted By B18B1-Crx

Re: My 90 EF Shell build thread

This is what happens when a BMW owner works on Hondas.
03-14-2012, 10:05 PM
Replies: 1
Views: 3,793
Posted By B18B1-Crx

Launch Control Help?

SO, i tapped into my Neutral safety switch so that when i let out of the clutch
the Rev limit is disabled. I have a Msd 6AL With Soft touch rev control. I have purchased the Rev control Box with a...
12-10-2011, 09:20 AM
Replies: 3
Views: 618
Posted By B18B1-Crx

Distributor harness fast question

I swapped over to a a6 multi port non vtec harness
i swapped over to a pm6 ecu
i have the stock d15b1 dizzy"daul point" junk NOT USED>
AND i have what i believe to be a multi port dizzy
it has 7...
12-04-2011, 07:37 PM
Replies: 3
Views: 1,391
Posted By B18B1-Crx

Re: mini swap Water pump? timing belt

Never mind sorry i got
12-04-2011, 02:36 PM
Replies: 3
Views: 1,391
Posted By B18B1-Crx

Re: mini swap Water pump? timing belt

bump hurry please parts stores about to close
12-04-2011, 02:23 PM
Replies: 3
Views: 1,391
Posted By B18B1-Crx

mini swap Water pump? timing belt

Okay were almost done im pretty sure we have to get another water
pump

Right now we have the stock d15b1 19 tooth water pump
we have a d16y8 and a d15b1 timing belt

The d15b1 timing belt is...
12-02-2011, 08:44 PM
Replies: 6
Views: 1,369
Posted By B18B1-Crx

Re: Mini me y8 fast question???

Yea thats what it seems to appear to be.

but were
12-02-2011, 08:17 PM
12-02-2011, 07:59 PM
Replies: 6
Views: 1,369
Posted By B18B1-Crx

Mini me y8 fast question???

Okay we have the head swapped and we need to know whether or not to use the d15b1 head studs or the y8 head studs,

the y8 appear too short
and we are torquing them 60ish
09-26-2011, 08:10 PM
Replies: 24
Views: 9,641
Posted By B18B1-Crx

Re: ls/vtec crx will not stay running... need help fast!!!

not trying to be a dick but sounds like your out of gas? bad fuel
sending unit?

think of the moment it went into limp mode? engine load temp speed etc

Doesn't the ecu ground...
09-23-2011, 01:09 PM
Replies: 20
Views: 61,266
Posted By B18B1-Crx

Re: Hesitation - Power loss while driving

yea my b18 crx has been doing the same exact thing lately

however Im pretty sure i have a distributor issue. Its brand newish.?

When i try to accel under load or clutch out harder than normal...
08-27-2011, 03:26 PM
Replies: 16
Views: 28,240
Posted By B18B1-Crx

Re: Anyone try putting

yea if you think about it the stock honda setup for this is really stupid and it needs to be recalled.
08-26-2011, 12:15 PM
Replies: 7
Views: 1,096
Posted By B18B1-Crx

Re: gas gauge off by little bit

you could top off all the way to the filler neck and siled the needle until it stops and force it to torque on its shaft and it will raise or offset the needle to the propper level.

i used to be...
08-26-2011, 12:07 PM
Replies: 16
Views: 28,240
Posted By B18B1-Crx

Re: Anyone try putting

i stuck a bold with a small head and screwed it down with the propper nut, and adjusted the switch to the extra mm of the bolt head.

Has been workign perfectly for about 3 months now.
08-25-2011, 07:11 PM
Replies: 2
Views: 459
Posted By B18B1-Crx

Re: Electrical issue in my 90 civic Dx hatch

sounds like you need to do some probing to find a short or a device that is shorted out itself.

Im not sure as to why it keeps popping. maybe someone else has had the same results.
But without a...
08-24-2011, 07:41 PM
Replies: 5
Views: 753
Posted By B18B1-Crx

Re: sidemarkers wont work!!!?!?

First Check the Fuse that is Relevant to that circuit
Second If Fuse is blown Do not replace it
The would most likely be caused by the mini wire tuck causing a Short
Prob the wiring/circuit for...
08-24-2011, 07:35 PM
Replies: 3
Views: 2,995
Posted By B18B1-Crx

Re: replacing steering rack boots on 90 CRX Si

10w30. Lol

I would Guess something thick since its not that hot and hard/fast of a moving part
08-24-2011, 07:26 PM
Replies: 51
Views: 4,744
Posted By B18B1-Crx

08-24-2011, 07:25 PM
Replies: 7
Views: 5,623
Posted By B18B1-Crx

Re: 1991 civic DX hb cold start problems

and if thats not the problem. Do a tune up make sure you have good gas, good voltages good grounds. Good fuel filter, Etc Check you Codes that you could be throwing and that
will lead you to the...
08-24-2011, 07:24 PM
Replies: 7
Views: 5,623
Posted By B18B1-Crx

Re: 1991 civic DX hb cold start problems

this is off a b series but your most likely shares commons
08-24-2011, 07:21 PM
Replies: 7
Views: 5,623
Posted By B18B1-Crx

Re: 1991 civic DX hb cold start problems

Check the AICV -air idle control valve
its basically the electronic choke that is enabled when the engine is not at operating
temp it works off of coolant temp make sure you have a full amount of...
08-24-2011, 07:07 PM
Replies: 3
Views: 2,675
Posted By B18B1-Crx

Re: 85 CRX hazard light issue

not too sure however i believe i had the same problem and my tailight where not working as well and it was a fuse thats in the engine bay that the same circuit ran the hazards?

Either Its...
08-23-2011, 05:40 AM
Replies: 4
Views: 1,149
Posted By B18B1-Crx

Re: Fresh Z6 smoking a lot

your turbo can burn the oil, Make sure you have a oil reducer or whatever they call
it because a turbo doesn't need 45-100psi of oil pressure of it will bleed right threw the
seal
Showing results 1 to 25 of 199
 


 
Forum Jump


All times are GMT -8. The time now is 03:43 AM.