Notices
 
Search: Posts Made By: Todhunter
Showing results 1 to 25 of 68
Search took 0.35 seconds.
02-24-2012, 04:34 AM
Replies: 34
Views: 31,438
Posted By Todhunter

Re: Manual Pedal Cluster in Auto Car?

SEE PICTURE #1
This is where the throttle cable connects to the pedal. This is different from the accelerator pedal that comes with the manual cluster. Unless you want to buy a new throttle cable,...
02-24-2012, 04:33 AM
Replies: 34
Views: 31,438
Posted By Todhunter

Re: Manual Pedal Cluster in Auto Car?

SEE PICTURE #1
The last wire to get out of the way is the radio antenna. Just pull it out of the back of your stereo head unit. Now all your wires are cleared and you're ready to drop the steering...
02-24-2012, 04:25 AM
Replies: 34
Views: 31,438
Posted By Todhunter

Re: Manual Pedal Cluster in Auto Car?

I've been asked to put the pictures back up for this article - so here is the updated post:

The pedal cluster is in the car. It took me about 3 hours beginning to end, a good chunk of which was...
01-07-2011, 03:53 AM
Replies: 11
Views: 45,207
Posted By Todhunter

Re: Troubleshooting P1457 Code

I ended up having to replace the battery, and after that, no more CEL.
12-20-2010, 08:19 AM
Replies: 9
Views: 3,558
Posted By Todhunter

Re: Crx Pedal Swap

I have heard from others this is good to have. But I have had my 5-speed conversion for nearly 5 years with no issues. I didn't know this weld-in piece existed until recently. I did have to make a...
12-07-2010, 12:45 PM
Replies: 6
Views: 597
Posted By Todhunter

Re: tranny question

Nope, that just holds the wires for the reverse light switch. This is what he needs:
...
11-30-2010, 12:03 PM
Replies: 9
Views: 1,169
Posted By Todhunter

Re: crx compressor or water pump? help needed fast

The AC compressor is on the front *driver* side of the engine. Water pump is driven by the timing belt - your car would not run if this belt broke.
11-30-2010, 11:22 AM
Replies: 10
Views: 6,795
Posted By Todhunter

Re: 89 CRX DX. DPFI-MPFI?

Correct - just to clarify even further, the YEL/BLK wires are +12V switched, NOT grounds!
11-30-2010, 11:14 AM
Replies: 25
Views: 4,709
Posted By Todhunter

Re: My '91 Wagon RT4WD Score and Build Thread

mruneek - no disrespect meant. I just wasn't sure if you were seeing something I wasn't. I used to have three N600's for a restoration project but got out of them to get into something else.
...
11-30-2010, 03:39 AM
Replies: 34
Views: 31,438
Posted By Todhunter

Re: Manual Pedal Cluster in Auto Car?

Did you get all the plugs back in their correct place? Did you undo any grounds?
11-29-2010, 11:32 AM
Replies: 25
Views: 4,709
Posted By Todhunter

Re: My '91 Wagon RT4WD Score and Build Thread

I don't see any other cars but the RT4WD in the first pic, but in the second pic I do see two N600's.
11-29-2010, 10:48 AM
Replies: 10
Views: 893
Posted By Todhunter

Re: wire tuck set back.. high rev.. help!

Then you have a vacuum leak somewhere - IACV, brake booster, vacuum lines, intake manifold gasket, bent throttle plate, etc. You have a simple problem with a few potential causes - just methodically...
11-29-2010, 10:44 AM
Replies: 25
Views: 4,709
Posted By Todhunter

Re: My '91 Wagon RT4WD Score and Build Thread

What a steal - I've wanted one of these cars for over 10 years and have yet to find one for a good deal.
11-29-2010, 10:40 AM
Replies: 6
Views: 1,053
Posted By Todhunter

Re: crx blower

Are there coolant lines running from the engine to the heater core, or is the heater core bypassed? Is the coolant valve on the firewall opening when you turn the climate control knob to hot?
11-29-2010, 10:37 AM
Replies: 10
Views: 893
Posted By Todhunter

Re: wire tuck set back.. high rev.. help!

Unplug your IACV to see if it corrects the issue. Possible you wired it up incorrectly?
11-29-2010, 03:52 AM
Replies: 34
Views: 31,438
Posted By Todhunter

Re: Manual Pedal Cluster in Auto Car?

Attica - not sure if it is or not, though I can't imagine it being very different.

Rease - I made a plate to cover the hole that the auto shifter cables pass through (the narrow hole closer to the...
11-24-2010, 11:47 AM
Replies: 6
Views: 6,016
Posted By Todhunter

Re: Are these crx heads interchangeable; pm3-5 pm3-6?

Just use Hondabond / Permetex Ultra Grey.
11-23-2010, 12:55 PM
Replies: 3
Views: 843
Posted By Todhunter

Re: Another idle problem

Just an update for closure - the IACV I used as a replacement had the same problem as the original one. I replaced it with ANOTHER junkyard IACV and now my car idles great.
11-23-2010, 12:46 PM
Replies: 15
Views: 3,213
Posted By Todhunter

Re: IACV Idle issues

A high idle can also be caused by a vacuum leak. Actually, the IACV malfunction creates a vacuum leak.

Look in other areas for the vacuum leak.

Another way to check the IACV - (I have a DPFI,...
11-23-2010, 12:32 PM
Replies: 15
Views: 3,213
Posted By Todhunter

Re: IACV Idle issues

I just replaced my IACV, and the second one I put on was bad. Third one was the charm. Go to a junk yard - they had 8 IACV's when I went last weekend, and they were $7 each.

Check the resistance...
11-23-2010, 12:20 PM
Replies: 2
Views: 370
Posted By Todhunter

Re: EF sedan needs help!!!!!

Check mechanical timing.

After that, take a breath, relax, and think about it. Air, fuel, spark, and compression (and timing) are all an engine needs to run. Confirm that you are getting spark. ...
11-23-2010, 12:15 PM
Replies: 110
Views: 26,423
Posted By Todhunter

Re: (pgpbubble)

Wow, thanks a ton John for the clarification...and from the man himself who came up with the circuit!
11-04-2010, 01:01 PM
Replies: 110
Views: 26,423
Posted By Todhunter

Re: Crazy Tach Needle, Breaking Up, Ignitor or Coil?

Cool. Again, I am no EE, but I always wondered why that resistor was there. I know transistors work as amplifiers, but do you know why there are two transistors, and why they are different? Why...
11-04-2010, 12:40 PM
Replies: 110
Views: 26,423
Posted By Todhunter

Re: (pgpbubble)

Don't get me wrong, I'm not trying to take credit at all for coming up with the cricuit - look at the picture I posted - it still says created by J&S, and modified by me. Actually I don't think John...
11-04-2010, 11:27 AM
Replies: 110
Views: 26,423
Posted By Todhunter

Re: (pgpbubble)

You're right - I clearly don't...which is why I asked for you to explain. I am an ME, and did just well enough in my EE classes to get by.

Fair enough if you don't want to post the circuit - I...
Showing results 1 to 25 of 68
 


 
Forum Jump


All times are GMT -8. The time now is 02:25 PM.