Honda-Tech - Honda Forum Discussion

Notices
 
Page 1 of 3
1
2
3
Search: Posts Made By: reg_lus
Showing results 1 to 25 of 58
Search took 0.54 seconds.
Forum: Tech / Misc
12-19-2014, 05:55 PM
Replies: 5
Views: 890
Posted By reg_lus

Re: b20v over heating

compression test all and it reads 230 240 240 250... 4 3 2 1
Forum: Tech / Misc
12-17-2014, 05:47 PM
Replies: 5
Views: 890
Posted By reg_lus

b20v over heating

Sometimes when I drive, my CEL would throw for Engine Over Heating Temp.
I would open up my s300 v3, and temperature would read at 200-219
but sometimes my needle would stays the same even when...
Forum: Tech / Misc
12-11-2014, 11:11 PM
Replies: 2
Views: 683
Posted By reg_lus

different header affect tune?

Since my small tube tri y header is all beat up and dented and leaking....and if i switch over to a big tube tri y, would this affect my afr or tune setup?
Forum: Suspension & Brakes
11-17-2014, 07:25 PM
Replies: 12
Views: 1,358
Posted By reg_lus

Re: Skunk 2 pro s 2 full coil over

I am currently running the pro 2 full coil over.
I like them but if only they were a bit stiffer. But they ride very nice.
It dont sit as low. The rear is almost maxed out. The front's got about...
Forum: Group Threads
10-29-2014, 11:15 PM
Replies: 42,033
Views: 6,085,961
Posted By reg_lus

Re: ==== The EG Ferio Squad ==== New & Improved!

Ass shot is always the best tho
https://cimg1.ibsrv.net/gimg/honda-tech.com-vbulletin/960x423/80-10606300_859766924056503_4633745823642939305_n_6c9c56fc8d2a141e327e85e016fd6cf3ec819845.jpg
Forum: Group Threads
10-24-2014, 07:35 PM
Replies: 42,033
Views: 6,085,961
Posted By reg_lus

Re: ==== The EG Ferio Squad ==== New & Improved!

How my car currently sits.


https://cimg8.ibsrv.net/gimg/honda-tech.com-vbulletin/960x539/80-1958235_853680541331808_8801356128167474049_n_c8bd87da2bb030377433fb6f8da7554a2b53d66a.jpg


...
Forum: Tech / Misc
10-15-2014, 10:54 PM
Replies: 11
Views: 626
Posted By reg_lus

Re: The Car Game! Lets play!

Distributor
Forum: Tech / Misc
10-06-2014, 10:15 PM
Replies: 7
Views: 2,867
Posted By reg_lus

Re: battery light flashes sometimes

^ i bought alternator from autozone and tested over at autozone too. yeah sorry its a remanu...i told them what happen and they replaced it for me again.r....so i dont see why 2 alternator should...
Forum: Tech / Misc
10-05-2014, 10:23 PM
Replies: 7
Views: 2,867
Posted By reg_lus

battery light flashes sometimes

Battery light flashes sometimes here and there.
new alternator (tested good) new battery (tested good)
i've check the power wire that goes to alternator and it seems goods

can it be my + battery...
Forum: Suspension & Brakes
09-14-2014, 09:40 PM
Replies: 2
Views: 438
Posted By reg_lus

Re: Help me with my coilovers

^ what he said.
Forum: Suspension & Brakes
09-13-2014, 10:11 PM
Replies: 3,590
Views: 1,579,868
Posted By reg_lus

Re: SLAMMED... Suspension Setups.

Skunk2 Pro-S II. Not a lowlife driver, dd & track.
Never slammed it before so don't know how low these go
although I still have plenty of space left to adjust for lowering.

437859...
Forum: Suspension & Brakes
09-13-2014, 09:31 PM
Replies: 1
Views: 949
Posted By reg_lus

Skunk2 Pro Series Camber kit Noise

It's making a squeaky noise when I go over bumps.
Could it be the Skunk2 anchorage??

Or can it be my Skunk2 Pro-S II Suspension?
(Forgot it if it was making that squeaky noise before)
Forum: Drag Racing
07-26-2014, 08:17 PM
Replies: 1
Views: 876
Posted By reg_lus

preload vs dumped clutch

Does preload give you a better time or dumping the clutch?
Forum: Tech / Misc
07-19-2014, 05:55 PM
Replies: 1
Views: 646
Posted By reg_lus

hondata s300 sTrim

all b20-v s2p2 cams

on a cruise my afr reads in the 14.7 which is good.
and sometimes after a while i come to a stop or shift into neutral,
my Short Trim would be stuck at 1.56 and would not...
Forum: Tech / Misc
07-17-2014, 11:51 AM
Replies: 2
Views: 989
Posted By reg_lus

greddy sp2 or mugen twin loop?

buddy has a authentic mugen twin loop. he wants a sp2 and he wants to straight trade me for my sp2......does the twin loop really run 400 used?
Forum: All Motor / Naturally Aspirated
07-17-2014, 11:13 AM
Replies: 1,506
Views: 1,302,594
Posted By reg_lus

Re: ►Official All Motor Dyno Thread!

Tuned by Shawn Church (CHURCH AUTOMOTIVE)

B20V
1999 B16 Head
Standard 84mm RS Machine ITR Pistons
Hondata S300
91 Octane
Skunk2 Pro 2 Cams
Rocket SL Valve Springs/Retainer
Walbaro 255
Forum: Tech / Misc
07-11-2014, 01:10 PM
Replies: 2
Views: 928
Posted By reg_lus

small crack on header affect wideband?

my tri y has a minor crack on my down pipe, i was wondering if my afr would be off?
-crack before o2 from tri y sitting too low.
Forum: Tech / Misc
06-18-2014, 08:54 PM
Replies: 4
Views: 5,555
Posted By reg_lus

Honda Primo Windshield Banner?

Anyone know where I can find this Honda Primo Windsheild banner for 92-95 civics?

http://site.icbmotorsport.com/New3/Js_Racing_Primo_Banner_Red.jpg
Forum: All Motor / Naturally Aspirated
05-16-2014, 09:17 PM
Replies: 8
Views: 8,336
Posted By reg_lus

skunk2 pro series vs edelbrock victor x

which is better?

my setup
itr rs machine 84mm
b16 head b16 trans
skunk2 pro 2 cams aem cg
skunk2 billet 70mm
stock intake manifold
hondata s300 v3
Forum: Tech / Misc
05-16-2014, 09:14 PM
Replies: 3
Views: 2,158
Posted By reg_lus

Re: b series skunk2 intake manifold opening size mm?

i message them and they said no more than a 68. -_-
was suppose to buy a 70mm victor x today but dude wasnt a serious seller.
Forum: Tech / Misc
05-15-2014, 09:49 PM
Replies: 3
Views: 2,158
Posted By reg_lus

Re: b series skunk2 intake manifold opening size mm?

bump, i kinda want to make a purchase tonight so maybe an answer will help me out lol
Forum: Tech / Misc
05-15-2014, 07:19 PM
Replies: 3
Views: 570
Posted By reg_lus

Re: why no fire?

blown ecu fuse 15amp?
Forum: Tech / Misc
05-15-2014, 07:12 PM
Replies: 3
Views: 2,158
Posted By reg_lus

b series skunk2 intake manifold opening size mm?

anyone know's the skunk2 intake manifold opening size? is it 70mm?
thanks!
Forum: Tech / Misc
05-15-2014, 05:19 PM
Replies: 5
Views: 2,251
Posted By reg_lus

Re: victor x vs skunk2 all motor setup?

Thanks Gagnar. Maybe when they see this they can help move it.
But trying to buy used manifold so that way i dont to spend that extra for new ones.
Forum: Tech / Misc
05-15-2014, 05:08 PM
Replies: 5
Views: 2,251
Posted By reg_lus

Re: victor x vs skunk2 all motor setup?

sorry as you can see i hardly ever post on h-t so still very new to all this.
-i'm talking about the skunk2 pro series vs the edelbrock victor x

looking to push 210+whp

b20v b16 head
84 itr...
Showing results 1 to 25 of 58
 
Page 1 of 3
1
2
3


 
Forum Jump


All times are GMT -8. The time now is 10:10 AM.