Notices
 
Search: Posts Made By: Yuen001
Showing results 1 to 25 of 39
Search took 0.38 seconds.
Forum: Acura Integra
11-24-2008, 11:56 AM
Replies: 15
Views: 716
Posted By Yuen001

agree to that, i just assumed that the fan was...

agree to that, i just assumed that the fan was blowing
11-24-2008, 11:53 AM
Replies: 9
Views: 696
Posted By Yuen001

dude .. that it gonna be a lot of work and $. ...

dude .. that it gonna be a lot of work and $.

you'll need to look at the following and see if it is bent.

Rim, knuckle, hub, control arm, and strut, if unsure, replace them all ? this will be...
Forum: Tech / Misc
11-24-2008, 07:41 AM
Replies: 6
Views: 509
Posted By Yuen001

have you upgraded your fuel pump ? and what...

have you upgraded your fuel pump ? and what octane fuel are you using ?
11-24-2008, 07:36 AM
Replies: 9
Views: 696
Posted By Yuen001

agreed, you'll need to replace it. i'm gonna say...

agreed, you'll need to replace it. i'm gonna say well into the 2500 - 3500 range. it's a lot of work

is it just me or does the wheel look a little crooked too ?
Forum: Acura Integra
11-24-2008, 07:24 AM
Replies: 15
Views: 716
Posted By Yuen001

or you lines going to the core could be clogged. ...

or you lines going to the core could be clogged. not as likely, but could happen
11-24-2008, 07:19 AM
Replies: 3
Views: 975
Posted By Yuen001

sounds like to me it could be a faulty fan...

sounds like to me it could be a faulty fan controller, coolant temp sensor, or fan relay.

wouldn't be your thermostat, because, if it were, it would over heat all the time. same with too much air...
11-24-2008, 07:14 AM
Replies: 13
Views: 3,308
Posted By Yuen001

if you can snap a pic of your engine bay, i'll be...

if you can snap a pic of your engine bay, i'll be able to tell you.. you are basically looking for the ABS pump which looks like a box with hard brake lines coming out of it.

and the only...
11-24-2008, 07:00 AM
Replies: 14
Views: 6,025
Posted By Yuen001

are you getting a CEL ? i worked on an 03...

are you getting a CEL ?

i worked on an 03 RSX before that had a similar problem. once it warmed up, the idle would start hunting. rpms going from 750 to 2k. at first i didn't get a code. but got...
11-21-2008, 12:11 PM
Replies: 14
Views: 6,025
Posted By Yuen001

yup, you'll have to enter the security code. ...

yup, you'll have to enter the security code. should be on a card in your glovebox. if not you'll have to call the dealer.
11-21-2008, 12:01 PM
Replies: 19
Views: 1,156
Posted By Yuen001

definitely could be the CV, replaced a few of...

definitely could be the CV, replaced a few of those before at the shop. or could be a bad wheel bearing. mine went bad and did the same thing. thought it was the CV but ended up being the bearing.
11-21-2008, 11:53 AM
Replies: 4
Views: 713
Posted By Yuen001

nothing duct tape won't fix

nothing duct tape won't fix
11-21-2008, 11:29 AM
Replies: 35
Views: 55,717
Posted By Yuen001

i was thinking about seafoaming the car. i'll...

i was thinking about seafoaming the car. i'll give it a shot.
11-20-2008, 05:15 PM
Replies: 35
Views: 55,717
Posted By Yuen001

taking off the intake manifold is gonna be a...

taking off the intake manifold is gonna be a serious pain. why would it not throw a code for insufficient egr flow if the holes are clogged ?
Forum: Acura TSX
11-20-2008, 04:57 PM
Replies: 20
Views: 18,323
Posted By Yuen001

i thought that if the immobilizer didn't...

i thought that if the immobilizer didn't recognize the key it wouldn't even turn over. as in the starter won't get juice. i remember messing with the immobilizer on a car that i was doing an auto...
11-20-2008, 04:49 PM
Replies: 35
Views: 55,717
Posted By Yuen001

yea, i replaced the downstream o2 and tested the...

yea, i replaced the downstream o2 and tested the upstream one. didn't help the situation. i was so sure it would be the o2's too.

the only thing i haven't swapped out is the ecu. those are a...
11-20-2008, 04:15 AM
Replies: 17
Views: 1,604
Posted By Yuen001

i just wish i had a spare lift that i could use...

i just wish i had a spare lift that i could use to store a car
11-20-2008, 04:13 AM
Replies: 35
Views: 55,717
Posted By Yuen001

if they were clogged, i would get an insufficient...

if they were clogged, i would get an insufficient egr flow code. but i did it anyway when i replaced my egr valve.
11-19-2008, 12:52 PM
Replies: 9
Views: 11,115
Posted By Yuen001

that's not many miles on the tensioner. i would...

that's not many miles on the tensioner. i would check the bearing on the tensioner and if that is good, i wouldn't bother replacing it.

i would wait till the next timing belt change and replace...
11-19-2008, 12:47 PM
Replies: 3
Views: 358
Posted By Yuen001

i haven't taken apart an ignition cylinder in a...

i haven't taken apart an ignition cylinder in a while, but if i remember correctly, there is a lock pin on the key cylinder that pops through a small hole in the key cylinder housing.

what...
11-19-2008, 12:37 PM
Replies: 9
Views: 11,115
Posted By Yuen001

how many miles on the tensioner ? and how much...

how many miles on the tensioner ? and how much is a tensioner ?

you can also test it out by seeing what kind of the shape the tensioner is in. see if there is any play on the bearing. spin...
11-19-2008, 12:32 PM
Replies: 35
Views: 55,717
Posted By Yuen001

did you get any codes before you replaced the CAT...

did you get any codes before you replaced the CAT ?

a test that i did was i bypassed the cat by simulating the correct voltages on the doenstream o2. i hooked a scope up to the up stream o2 and...
11-19-2008, 12:24 PM
Replies: 2
Views: 430
Posted By Yuen001

it shouldn't as long as your total over all...

it shouldn't as long as your total over all circumfrence is the same (wheels and tires) and the same weight or lighter, it shouldn't use more gas.

but there are a lot of things that affect this...
11-19-2008, 12:20 PM
Replies: 3
Views: 462
Posted By Yuen001

what voltage are you getting on the battery...

what voltage are you getting on the battery terminals with the car running ? you should get about 13.5 - 14.5 Volts. if you are getting less than 13.5 your alternator is weak. than you want to turn...
11-19-2008, 12:13 PM
Replies: 9
Views: 11,115
Posted By Yuen001

if you plan on keeping the car for a while, i'd...

if you plan on keeping the car for a while, i'd go with OEM, the price difference usually isn't that much either.
11-19-2008, 12:09 PM
Replies: 17
Views: 1,604
Posted By Yuen001

how long do you plan on storing your car on a...

how long do you plan on storing your car on a lift ?

from a mechanical stand point, as long the lift is hitting the mount points or directly to the frame. and the lift is some what level, i...
Showing results 1 to 25 of 39
 


 
Forum Jump


All times are GMT -8. The time now is 10:41 PM.