Honda-Tech - Honda Forum Discussion

Notices
Search: Posts Made By: odo53
Showing results 1 to 8 of 8
Search took 0.41 seconds.
Forum: Honda Accord (1990 - 2002)
05-21-2008, 06:48 PM
Replies: 5
Views: 883
Posted By odo53

Re: wheel bearing, 96 Accord LX (accord_raffi)

Stupid me, bought the bearing and not the hub assembly. I banged out the bearing with a hammer, the inner race is attached to the hub that has the splined input and the studs for the wheel. I see...
Forum: Honda Accord (1990 - 2002)
05-17-2008, 05:01 PM
Replies: 5
Views: 883
Posted By odo53

wheel bearing, 96 Accord LX

Last week I noticed an unpleasant noise while taking a sharp corner. In the last week I have put 500+ miles on the car and I hear the noise getting louder. I notice it most in highway on or off...
Forum: Honda Accord (1990 - 2002)
04-07-2008, 06:45 PM
Replies: 5
Views: 1,228
Posted By odo53

Re: CEL (maybe Oxygen Sensor) on 96 Accord LX 2.2L (odo53)

Car has 185,000 miles and I am the 3rd owner, I'm sure there is no warranty of any kind left.

I have reset the ecm, we'll see what it complains about next. I think I may pull the plug on some...
Forum: Honda Accord (1990 - 2002)
04-07-2008, 04:27 PM
Replies: 5
Views: 1,228
Posted By odo53

CEL (maybe Oxygen Sensor) on 96 Accord LX 2.2L

Check Engine Light came on so I jumpered the "service check connector" and turned the key. The CEL comes on for maybe 1 or 2 seconds along with all the other dash lights that come on, flashes off...
Forum: Honda Accord (1990 - 2002)
03-15-2008, 03:20 PM
Replies: 39
Views: 128,277
Posted By odo53

Re: timing of balance shafts 96 Accord 2.2L (hondadude)

Thanks TouringAccord, that picture was worth a thousand words, exactly addresses my dilemma even if I didn't state it very well.

And thanks hondadude. I see your point about the oil pump seal...
Forum: Honda Accord (1990 - 2002)
03-13-2008, 06:30 PM
Replies: 39
Views: 128,277
Posted By odo53

Re: timing of balance shafts 96 Accord 2.2L (billyrusa)

Yes, that is a great write up and I appreciate the work that went into it. But it says the same thing as my manual, put a 6mm by 100mm bolt through the rear balance shaft. My question remains, how...
Forum: Honda Accord (1990 - 2002)
03-13-2008, 04:50 PM
Replies: 39
Views: 128,277
Posted By odo53

timing of balance shafts 96 Accord 2.2L

Doing the timing belt on my 96 Accord LX 2.2L (not VTEC) and I pulled the "balancer timing belt" off. The balance shafts both rotated away from the position they were in, so I have no idea how to...
Forum: Honda Accord (1990 - 2002)
03-06-2008, 05:01 PM
Replies: 1
Views: 749
Posted By odo53

96 Accord LX crank pulley

Doing the timing belt on a 96 Accord LX with the 2.2L. I have the crank pulley bolt off, that wasn't easy but I see lots of advice on that here in the forum. Now that the bolt is off, how do I get...
Showing results 1 to 8 of 8


 
Forum Jump


All times are GMT -8. The time now is 03:21 PM.