Honda-Tech - Honda Forum Discussion

Notices
 
Page 1 of 3
1
2
3
Search: Posts Made By: superex87
Showing results 1 to 25 of 57
Search took 0.55 seconds.
Forum: Honda CRX / EF Civic (1988 - 1991)
03-03-2010, 08:40 AM
Replies: 26
Views: 11,707
Posted By superex87

Re: B18 missfire when rad fan is on????

If there is red/purple dust inside the distributr then it is failing. When the bearing in the distributor dies it throws dust everywhere inside the distributor, it also gets VERY hot causeing all the...
Forum: Honda Civic (2001 - 2005)
06-11-2009, 07:14 PM
Replies: 37
Views: 2,266
Posted By superex87

Re: Shifter Issue

Its 60$ and change shipped from...
Forum: Honda Civic (2001 - 2005)
06-10-2009, 09:49 AM
Replies: 3
Views: 578
Posted By superex87

Re: problems with tranny

Make sure the trans has fluid!!!!!!, could also be the bearings but with such low millage i dunno (or someone cut a zero off of the millage estimate......)
Forum: Honda Civic (2001 - 2005)
06-10-2009, 09:47 AM
Replies: 37
Views: 2,266
Posted By superex87

Re: Shifter Issue

I just did this with my brothers 01 ex 4dr, whats happened is the plastic ball at the bottom of the shifter (thingy in your hand lol) has broken in half. It is a two piece plastic ball from the...
Forum: Honda CRX / EF Civic (1988 - 1991)
10-04-2008, 07:55 AM
Replies: 5
Views: 1,110
Posted By superex87

Re: FV-QR (honda.lioness)

alos chech to make sure your rear drums are properly adjusted, the best way to do this is by using the e-brake ....how many clicks of the e-brake handle till the rear drums start draging? should be...
Forum: Honda CRX / EF Civic (1988 - 1991)
05-04-2008, 04:23 PM
Replies: 1
Views: 353
Posted By superex87

Re: help with my CRX (civicxxman)

well if the valve lash was wack then it was probly not firing in those cylinders (2-3), also check to make sure your getting fuel in those cylinders, when you get it back together check the...
Forum: Honda CRX / EF Civic (1988 - 1991)
05-02-2008, 12:43 PM
Replies: 6
Views: 601
Posted By superex87

Re: 1.5 parts on a 1.6 (bh92374)

on the tranny question you need an 90 or 91 clutch/pressure plate and a 90-91 flywheel, the clutch/flywheel setup from your hf will work toobut the 89 crx/civic used a slightly smaller...
Forum: Honda CRX / EF Civic (1988 - 1991)
04-30-2008, 05:15 PM
Replies: 49
Views: 15,075
Posted By superex87

Re: 91 CRX Crank Pulley Removal details inside..... (UfoTofU)

if the car is jacked up with both wheels off, you can put a large screw driver in the rotor cooling vents (this will cause the rotor to not turn forward anymore (do to both sides, and make sure the...
Forum: Honda CRX / EF Civic (1988 - 1991)
04-27-2008, 06:21 PM
Replies: 12
Views: 17,642
Posted By superex87

Re: (KhmerdudeSiR)

search through all of the faq.......someone has to have done it befor, also DO NOT SLICE, just repin the plugs sooo much eaiser and neater
Forum: Classic Hondas
04-18-2008, 04:19 AM
Replies: 2
Views: 1,120
Posted By superex87

Re: Honda CRX Si 87 FUEL PROBLEM (gonzalezjk)

sounds like a dead fuel pump, check to make sure the pump is getting power when the key is turned to the on position, it will come on for 2 seconds then turn off, do you hear the pump prime when you...
Forum: Honda CRX / EF Civic (1988 - 1991)
03-24-2008, 04:15 PM
Replies: 6
Views: 329
Posted By superex87

Re: Need help, car is having problems staying on after install. (FastEg6)

sounds like the key cylinder (grr forgo the name of it, thing you put the key into to start the car)
is bad, exactly what you describe happens when it goes bad.
If you hold the key in the start...
Forum: Honda CRX / EF Civic (1988 - 1991)
03-24-2008, 12:32 PM
Replies: 3
Views: 923
Posted By superex87

Re: edm-crx si with d16z5 (edm_ef8)

I believe with the high compression pistons that you have to retard? or advance? the timing with an adjustable cam gear, Im pretty sure it has to be retarded but I could be wrong about that.

I...
Forum: Appearance Build Threads
03-22-2008, 05:10 AM
Replies: 30
Views: 2,581
Posted By superex87

Re: My turn for a build thread...just something small (primetimeracing)

They are somewhat interchangable.
First check to see if the y8 IM has the manual trans idle valve or the auto one (manual one will be on back of IM, auto on will be on bottom of throttle body.
If...
Forum: Honda CRX / EF Civic (1988 - 1991)
03-11-2008, 12:06 PM
Replies: 4
Views: 4,353
Posted By superex87

Re: Transmission Rebuild (eda6)

Thanks for the reply and the info.

Ill try to blue print the trans if I have enough time to when I pull it from my rex.
Are there any other parts in the transmission that tend to wear?
Forum: Honda CRX / EF Civic (1988 - 1991)
03-10-2008, 05:35 PM
Replies: 4
Views: 4,353
Posted By superex87

Transmission Rebuild

Hey

I am planning to rebuild my HF transmission soon and was looking at replacing the syncro's too.

I plan to replace all the bearings/ seals and then the syncro's, but buying new synco's from...
Forum: Honda CRX / EF Civic (1988 - 1991)
03-09-2008, 02:56 PM
Replies: 3,148
Views: 415,173
Posted By superex87

Re: (tacorunner87)

I have a set of elibach lowering springs, the sportline kit.
1.5 inch drop in the front 1.7 inch drop in the back, I used them for about 5,000 miles.
They in perfect condition.
Im looking to get...
Forum: Honda CRX / EF Civic (1988 - 1991)
03-08-2008, 04:16 AM
Replies: 28
Views: 1,699
Posted By superex87

Re: (p10hlm)

The best way to remove a stuck ball joint or in this case a tie rod end is to use a ball joint puller tool, should be able to find one sorta like this on at your local auto store.
...
Forum: Vehicles for sale
02-22-2008, 04:24 PM
Replies: 3
Views: 557
Posted By superex87

Re: 91 CRX DX Northern MD (SCRATCH)

Hey yea I still have it..
Forum: Honda CRX / EF Civic (1988 - 1991)
02-11-2008, 04:56 PM
Replies: 25
Views: 4,800
Posted By superex87

Re: TPS modification 88crx DX 1.5l (inegma29)

The dx crx uses a different tps than all the other honda tps!!!!!!! because of the dual point fuel injection, a tps from any other honda won't work. unless you converted to mpfi. but if you still...
Forum: Honda CRX / EF Civic (1988 - 1991)
02-11-2008, 04:55 PM
Replies: 25
Views: 4,800
Posted By superex87

Re: TPS modification 88crx DX 1.5l (inegma29)

The dx crx uses a different tps than all the other honda tps!!!!!!! because of the dual point fuel injection, a tps from any other honda won't work.
Forum: Vehicles for sale
02-10-2008, 04:25 PM
Replies: 3
Views: 557
Posted By superex87

91 CRX DX Northern MD

Hey guys Im selling my 91 CRX DX, she's served me well but tis time to move on.

Details- It has 350,000 miles, cluster reads 151,000 (I broke the old one but still have the odometer from it. I...
Forum: Honda CRX / EF Civic (1988 - 1991)
01-29-2008, 04:48 AM
Replies: 4
Views: 506
Posted By superex87

Re: Engine problem with D16Z6 (onesikgsr)

Check the timing, if the timing is off it will do what you described, more so at lower rpm's
Forum: Honda CRX / EF Civic (1988 - 1991)
01-26-2008, 01:54 PM
Replies: 120
Views: 10,423
Posted By superex87

Re: (4DRmafia)

So will the storage place let you work on the car there?
I never thought of something like this...
<really wants a garage
Forum: Honda CRX / EF Civic (1988 - 1991)
01-13-2008, 05:14 AM
Replies: 2
Views: 539
Posted By superex87

woodruff key for adjustible cam gear

Hey guys
The cam timing on my 91 crx dx has always been half a tooth off, no matter what I tried I could not get it perfect.

So I purchased an adjustable cam gear, and went to put it on and...
Forum: Honda CRX / EF Civic (1988 - 1991)
12-08-2007, 10:33 AM
Replies: 65
Views: 5,029
Posted By superex87

Re: Todays Tech Tip... and Fram Oil Filters (Targa250R)

while where on the subject of oil filters, are those magnete things that attach to the oil filter any good/ do they do anything/ would you use one?...
Showing results 1 to 25 of 57
 
Page 1 of 3
1
2
3


 
Forum Jump


All times are GMT -8. The time now is 02:54 PM.