Honda-Tech - Honda Forum Discussion

Notices
 
Page 1 of 3
1
2
3
Search: Posts Made By: chibiko
Showing results 1 to 25 of 55
Search took 0.77 seconds.
Forum: Honda Accord (1990 - 2002)
08-05-2007, 07:36 PM
Replies: 7
Views: 1,235
Posted By chibiko

Re: oxygen sensor! (accord99power)

Is it possible that it is something else broken instead of the oxygen sensor? Could it be the cat converter?
Forum: Honda Accord (1990 - 2002)
08-05-2007, 12:18 PM
Replies: 7
Views: 1,235
Posted By chibiko

Re: oxygen sensor! (tech8)

Thanks, I will buy the Denso one.

BTW, my car has more than 170,000 miles on it. Is there any further extended emission warranty on it?
Forum: Honda Accord (1990 - 2002)
08-05-2007, 12:04 PM
Replies: 7
Views: 1,235
Posted By chibiko

oxygen sensor!

Got engine light on yestoday and was told by Autozone that it is an oxygen sensor gone which is "Bank 1 Sensor 2". Is it the one near the catalyst converter under the car?

My car is 97 Accord...
Forum: Honda Accord (1990 - 2002)
06-10-2007, 08:15 PM
Replies: 9
Views: 871
Posted By chibiko

Re: (stinker504)

haha, similar as mine.
Forum: Honda Accord (1990 - 2002)
05-27-2007, 11:02 AM
Replies: 3
Views: 860
Posted By chibiko

Re: Distributor? (TAINO)

when you take off your distributor, don't forget to make marker of its position relative to the engine. The position of it determines the fire timing.
Forum: Honda Accord (1990 - 2002)
05-21-2007, 07:08 AM
Replies: 3
Views: 796
Posted By chibiko

Re: Do I need to make marks for inner CV joint? (chibiko)

No people do this before?
Forum: Honda Accord (1990 - 2002)
05-20-2007, 08:37 PM
Replies: 3
Views: 796
Posted By chibiko

Do I need to make marks for inner CV joint?

I forgot to do this when I disassembled my 97 accord AT inner cv joint. And found that I can install the rollers along any directions to the inboard joint. So my question is what is the reason of...
Forum: Honda Accord (1990 - 2002)
05-15-2007, 04:02 PM
Replies: 18
Views: 6,850
Posted By chibiko

Re: (lowered94accord)

My car 97 accord F22b2. Do I need to remove the damper fork before I separate the lower arm from the ball joint? The service manual (both the hynes and the shop manual) said that, but another DIY...
Forum: Honda Accord (1990 - 2002)
05-13-2007, 06:35 PM
Replies: 18
Views: 6,850
Posted By chibiko

Re: (Evil Monkey)

Am I right to tap the ball joint tip with the nut on it? The problem using hammer is that the space is too tight and the hammer cannot fly enough to get the moment.
Forum: Honda Accord (1990 - 2002)
05-13-2007, 03:59 PM
Replies: 18
Views: 6,850
Posted By chibiko

Need a puller to separate front lower arm and ball joint.

I tried to replace the inner CV boot but cannot separate the front lower arm and the ball joint. Tried a two arms puller bought from harbor freight and supprisingly, the puller broke. Also tried to...
Forum: Honda Accord (1990 - 2002)
05-11-2007, 10:08 PM
Replies: 4
Views: 11,834
Posted By chibiko

Re: EVAP Purge Congrol Solenoid Valve clicking? (JimBlake)

I can hear it by ear. But since there are multiple components in that area, I need to use a stethoscope to locate which one is clicking.
Forum: Honda Accord (1990 - 2002)
05-11-2007, 07:17 AM
Replies: 4
Views: 11,834
Posted By chibiko

EVAP Purge Congrol Solenoid Valve clicking?

Found that my 97 accord EVAP valve clicking (louder than the cylinder valves) after the car is turned on. I found this using a stethoscope. Is its clicking normal? or I need to replace it?
...
Forum: Honda Accord (1990 - 2002)
05-11-2007, 06:19 AM
Replies: 1
Views: 372
Posted By chibiko

anyone used turpentine to clean joints?

I heard that someone using turpentine to clean CV joints. I have a question here - how and where to despose the used solution?
Forum: Honda Accord (1990 - 2002)
05-07-2007, 07:29 PM
Replies: 0
Views: 331
Posted By chibiko

engine mount installation?

on my shop manual of 97 accord (the one with thousands of pages), in the engine mount installation section, there is using of a 6 X 100 mm bolt in the front and side mounts. It said "Tighten the...
Forum: Honda Accord (1990 - 2002)
05-02-2007, 08:41 PM
Replies: 163
Views: 223,544
Posted By chibiko

Re: (TouringAccord)

I am new. Do I have to change the rotor? Why to remove the old rotor?
Forum: Honda Accord (1990 - 2002)
04-25-2007, 12:31 PM
Replies: 3
Views: 1,168
Posted By chibiko

Re: about floor jack (gosu08)

the problem is that I need to have wheels in air. whenever I release the pressure of the floor jack, the wheels come back to ground first and then touch the jack stands. I cannot use a higher level...
Forum: Honda Accord (1990 - 2002)
04-25-2007, 10:44 AM
Replies: 5
Views: 752
Posted By chibiko

Re: Can the front tie down hooks be replaced? (Turbowa)

Thanks very much. I didn't realize it is tid down hooks when I saw it yestody. The picture is so small and it looks not like what is installed underneath my car.
Forum: Honda Accord (1990 - 2002)
04-24-2007, 09:52 PM
Replies: 3
Views: 1,168
Posted By chibiko

about floor jack

bought a floor jack with range of 5" to 13" to jack my 97 accord. It cannot lift the car high enough for me to insert the jack stands to have front wheels in air. Any recommendations about floor...
Forum: Honda Accord (1990 - 2002)
04-24-2007, 07:55 PM
Replies: 5
Views: 752
Posted By chibiko

Re: Can the front tie down hooks be replaced? (chibiko)

I think it doesn't matter, but want to know if it can be replaced or belongs to the body.


Modified by chibiko at 9:25 PM 4/24/2007
Forum: Honda Accord (1990 - 2002)
04-24-2007, 05:54 PM
Replies: 5
Views: 752
Posted By chibiko

Can the front tie down hooks be replaced?

Cannot find tie down hooks from Majestic honda. One of mine was bend when I tried to jack beneath it. Can they be replaced?

My car is 97 accord. the hooks are just besides the splash shield and...
Forum: Honda Accord (1990 - 2002)
04-21-2007, 07:59 PM
Replies: 1
Views: 799
Posted By chibiko

what kind grease I can use for this?

I went to dealer today asking them for the steering grease and was told that they dont have the specfic grease. The guy told me the grease can be found in any auto store. I appreciate that anyone...
Forum: Honda Accord (1990 - 2002)
04-18-2007, 04:33 PM
Replies: 6
Views: 1,839
Posted By chibiko

Re: Running fan after turning the car off (tech8)

Maybe when this happens your radiator will die soon. This happened on my Accord 97.
Forum: Honda Accord (1990 - 2002)
04-17-2007, 10:28 AM
Replies: 264
Views: 275,262
Posted By chibiko

Re: Cleaning IACV, FITV and TB (GhostAccord)

Thanks for the information. Things are exactly as you said. I have cleaned my IACV and FITV. It took my car several minutes to adjust to the change and after that it works great. A question is...
Forum: Honda Accord (1990 - 2002)
04-13-2007, 05:32 AM
Replies: 264
Views: 275,262
Posted By chibiko

Re: Cleaning IACV, FITV and TB (mtnwkr)

Do I need to drain the coolent first? Another question is the IACV is behind my intake manifold, so the space to loose it is really tight and I cannot put a socket wrentch there. How do you guys do?
Forum: Honda Accord (1990 - 2002)
02-21-2007, 06:28 PM
Replies: 6
Views: 670
Posted By chibiko

Re: (The-Kid)

my timing belt was changed in a honda dealer, special enough, but they still don't know what they are doing i think. ever since the change, my car becomes noisy and vibrates a lot. and nobody in...
Showing results 1 to 25 of 55
 
Page 1 of 3
1
2
3


 
Forum Jump


All times are GMT -8. The time now is 01:23 AM.