Honda-Tech - Honda Forum Discussion

Notices
 
Page 1 of 13
1
2
3
11
Last »
Search: Posts Made By: fleetw00d
Showing results 1 to 25 of 306
Search took 0.71 seconds.
Forum: Paint and Body
01-31-2014, 06:40 PM
Replies: 2
Views: 1,440
Posted By fleetw00d

Re: $675 for rear quarter panel

Depending on the extent of damage, you might check with a paintless dent repair guy.
Forum: Paint and Body
01-31-2014, 06:26 PM
Replies: 11
Views: 7,502
Posted By fleetw00d

Re: Removing entire quarter panels

As above, I have used a sawzall to remove quarters from CB7s. I needed two batteries or had to charge it part way through.
Forum: Honda Accord (1990 - 2002)
11-18-2010, 04:02 PM
Replies: 7
Views: 1,963
Posted By fleetw00d

Re: Speed Sensor

Bad VSS will also cause cruise control and odometer not to work. If either of those work, VSS is ok and problem is elsewhere (I had a problem with corrosion on the printed circuit board in the...
Forum: Honda Accord (1990 - 2002)
11-18-2010, 03:51 PM
Replies: 4
Views: 2,005
Posted By fleetw00d

Re: How Do You Put Lower Timing Cover On

Goes in from below. Easier if the drive side motor mount is removed and the engine allowed to sag down (like when changing the timing belt).
Forum: Honda Accord & Crosstour (2003 - 2012)
11-18-2010, 03:46 PM
Replies: 0
Views: 3,052
Posted By fleetw00d

08+ Accord V6 Exhaust Tip Inside Diameter?

Can any one tell me the inside diameter (or what size pipes it will fit) of the oval shaped factory exhaust tip used on 2008+ Accord V6's? (may also be used on 4's??)
Forum: Honda Accord (1990 - 2002)
10-04-2010, 05:14 PM
Replies: 2
Views: 12,707
Posted By fleetw00d

Re: Headlight removal 90-93

He is making it a lot harder than it is. Do not remove the bumper skin from the beam; the bumper can be removed easily as an assembly. What he didn't show you is that there are plastic retainers...
Forum: Honda Accord (1990 - 2002)
07-31-2010, 04:52 PM
Replies: 1
Views: 539
Posted By fleetw00d

Re: Help I have been Vandalized

There is a black plastic triangle on the inside of the door where the mirror is mounted. Pull at the lower rear corner of this cover and it should just pop off. If similar to my 4th gens, there...
Forum: Honda Accord (1990 - 2002)
07-17-2010, 07:57 PM
Replies: 31
Views: 30,450
Posted By fleetw00d

Re: Replacing/removing front bulkhead 95 Accord

It doesn't look damaged enough to replace. A body shop could probably pull it back into shape. If you're creative and patient, you could probably rig something up to push or pull it back into...
Forum: Honda Accord (1990 - 2002)
07-17-2010, 07:39 PM
Replies: 15
Views: 7,183
Posted By fleetw00d

Re: 1990 Honda Accord smells like fuel while driving, shitty mileage, and idles rough

On my 90, the main supply line from the tank rusted out at the rear end of the cluster of five lines that run under the car. There is a cover over all the fuel connections on the left side of the...
Forum: Honda Accord (1990 - 2002)
07-09-2010, 06:44 PM
Replies: 9
Views: 15,855
Posted By fleetw00d

Re: Exhaust manifold/downpipe bolt sheared off...i need advice

Ditto on taking the manifold off. The stud has to come out from the bottom. If the stud broke instead of the nut coming off, you're not going to get it out grabbing it with a pair of pliers. If...
Forum: Honda Accord (1990 - 2002)
06-13-2010, 04:39 PM
Replies: 1
Views: 1,718
Posted By fleetw00d

Re: 91 honda accord tensioner quewstions

You do not have to take off the timing belt or camshaft. Remove the valve cover, back off all the adjusting screws for the valves, loosen the cam/rocker retainers a few turns at a time, remove the...
Forum: Honda Accord (1990 - 2002)
06-06-2010, 06:02 PM
Replies: 1
Views: 6,863
Posted By fleetw00d

Re: Installing new distributor.....need to reset timing???

The shaft in the distributor will only enage the slot in the end of the camshaft one way, but you will have to set the base timing. If you haven't removed the old one, make a mark across the boss at...
Forum: Honda Accord (1990 - 2002)
06-06-2010, 05:57 PM
Replies: 11
Views: 2,247
Posted By fleetw00d

Re: 90 Accord PS pump seal kit or new pump?

Not much to completely resealing it. Simply disassembly, clean, reassemble with new seals. If you're going to take it off, might as well do it right. Take the opportunity to replace as much of the...
Forum: Honda Accord (1990 - 2002)
05-28-2010, 05:17 PM
Replies: 6
Views: 2,105
Posted By fleetw00d

Re: 93 Wagon Auto Idle Vibration, Rear Mount Test?

As stated above, better than it was when I started, but still more vibration than my 93 EX auto. Haven't found a strobe light yet. Tried a timing light on the coil wire (should yield pulses 2x...
Forum: Honda Accord (1990 - 2002)
05-24-2010, 08:07 PM
Replies: 15
Views: 24,077
Posted By fleetw00d

Re: 96 Accord LX Oil Leak - F22B2 Engine

If similar to the 4th gens, the oil cooler is only used on some models, EX and SE, I think.

For those above with this problem, do the oil sending unit first, then clean the back of the engine and...
Forum: Honda Accord (1990 - 2002)
05-24-2010, 08:03 PM
Replies: 5
Views: 6,217
Posted By fleetw00d

Re: 97 Accord STOLEN :(

Bethel? What state? I know there is a Bethel, OH, but somehow I don't think that's what you are talking about. Good luck.
Forum: Honda Accord (1990 - 2002)
05-24-2010, 07:07 PM
Replies: 6
Views: 2,105
Posted By fleetw00d

Re: 93 Wagon Auto Idle Vibration, Rear Mount Test?

Checked ignition timing last night, about 14 degrees BTDC. Tweaked it up to about 16. Found a slight leak from #3 injector this morning when I started it (upper o-ring). Seemed to run a little...
Forum: Honda Accord (1990 - 2002)
05-23-2010, 06:29 PM
Replies: 15
Views: 24,077
Posted By fleetw00d

Re: 96 Accord LX Oil Leak - F22B2 Engine

Rear main seal is actually on the right end of the engine, it is usually manifested by oil dripping from the cover on the bottom of the transmission where it meets the engine block. The oil pressure...
Forum: Honda Accord (1990 - 2002)
05-23-2010, 06:22 PM
Replies: 4
Views: 7,216
Posted By fleetw00d

Re: Humming noise when driving

How many miles? You may have damaged the wheel bearing.
Forum: Honda Accord (1990 - 2002)
05-23-2010, 06:07 PM
Replies: 3
Views: 1,970
Posted By fleetw00d

Re: Anti Freeze issue

Sounds like the overflow system isn't working correctly. With a properly functioning system, the radiator will be full to the top when you remove the cap. As the coolant and entrained air heat up,...
Forum: Honda Accord (1990 - 2002)
05-23-2010, 05:55 PM
Replies: 3
Views: 3,155
Posted By fleetw00d

Re: Battery cable replacement

Get a set of OEM cables from Majestic Honda.
Forum: Honda Accord (1990 - 2002)
05-23-2010, 05:05 PM
Replies: 5
Views: 2,777
Posted By fleetw00d

Re: 91 Accord LX needs some guru help!

Check the fuel pressure. Just because you're getting some fuel doesn't mean you're getting enough. Without digging out my manuals, pressure at the rail should be somewhere around 30 - 40 psi; lower...
Forum: Honda Accord (1990 - 2002)
05-23-2010, 01:23 PM
Replies: 6
Views: 2,105
Posted By fleetw00d

Re: 93 Wagon Auto Idle Vibration, Rear Mount Test?

Balance shaft timing is OK (reset it, but I had it on TDC #1 exhaust, then redid it at TDC #1 compression). Doesn't appear to have improved any. Thought of a strobe light to determine vibration...
Forum: Honda Accord (1990 - 2002)
05-21-2010, 07:01 PM
Replies: 3
Views: 2,563
Posted By fleetw00d

Re: New Brake Pads Dragging

I don't think it is the master cylinder. Sounds like it would be a good idea to rebuild both calipers; it is not very hard. Remove the calipers, remove the pads, use a little air pressure at the...
Forum: Honda Accord (1990 - 2002)
05-21-2010, 06:52 PM
Replies: 16
Views: 1,890
Posted By fleetw00d

Re: Pedal goes to floor

If air got into the ABS control, I don't think you can get it out by manually bleeding. You may need to take it to a dealer or service shop that can properly activate and bleed the ABS control.
Showing results 1 to 25 of 306
 
Page 1 of 13
1
2
3
11
Last »


 
Forum Jump


All times are GMT -8. The time now is 07:30 AM.