Notices
 
Search: Posts Made By: Phildo916
Showing results 1 to 25 of 98
Search took 0.73 seconds.
Forum: Honda Prelude
04-25-2013, 01:28 AM
Replies: 17
Views: 1,422
Posted By Phildo916

Re: Is a cello compatible with a prelude?

Ive moved all kinds of things in my preludes. Take out the passenger and rear seats and there is all kinds of room. If 5th gens are like my 4th gens, only 4 bolts hold the front seats in. Easy and...
Forum: Honda Prelude
01-16-2012, 10:24 AM
Replies: 6
Views: 7,991
Posted By Phildo916

Re: H23 vtec swap in 2000 accord from F23

Swapping it doesnt break the crank, bearings, or timing belts. Driving and Revving the engine like a B series or H22 is what kills them.
Forum: Honda Prelude
01-13-2012, 08:19 PM
Replies: 13
Views: 9,157
Posted By Phildo916

Re: "overheating" but thermostat doesn't open and fans don't come on?

Get a small wire, pull the connector on ECT switch A and bridge the connection in the plug. Both fans should come on. If they dont come on you have a bad relay, fuse, or control module. If they do...
Forum: Honda Prelude
01-13-2012, 05:12 PM
Forum: Honda Prelude
07-14-2011, 11:40 PM
Replies: 3,242
Views: 471,719
Posted By Phildo916

Re: What Have you done to your Prelude today?

I used a 97-01 ebrake on my 94-96 console swap. I hate the ebrake boot on the 94-96 ebrakes.
Forum: Honda Prelude
05-22-2011, 10:16 AM
Replies: 17
Views: 1,540
Posted By Phildo916

Re: crank bolt issues

A special tool can be picked up from the internet or if you are lucky, local auto part stores. It stops the crank pulley from rotating when you are attempting to loosen the crank bolt. I bought...
Forum: Honda Prelude
05-20-2011, 10:04 PM
Replies: 19
Views: 4,450
Posted By Phildo916

Re: Pistons back in my block question.

As long as the rings are within spec and there is no visible scarring of the walls what raised doubts it wouldnt hold compression?
Forum: Honda Prelude
05-10-2011, 12:01 PM
Replies: 2
Views: 986
Posted By Phildo916

Re: Electrical Issues

Yeah it definitely sounds like a short leading to a voltage drain somewhere on your car. I have a buddy who has the same problem with his 90 Mitsu GSX. Goes through alternators and batteries like...
Forum: Honda Prelude
05-10-2011, 11:59 AM
Replies: 12
Views: 8,292
Posted By Phildo916

Re: hit a curb... need help!

Im not sure if you have Firestone tire shops in Texas, but out here in California they offer lifetime alignments for ~$150 or so for any one vehicle under one owner. Its a hell of a deal if your car...
Forum: Honda Prelude
04-27-2011, 09:30 PM
Replies: 20
Views: 1,982
Posted By Phildo916

Re: crack crankcase lsd tranny

How exactly does one crack the bell-housing?
Forum: Honda Prelude
04-22-2011, 12:55 PM
Replies: 14
Views: 1,586
Posted By Phildo916

Re: I'd like to know what I'm doing wrong...

Did you open the brake master cylinder to allow the system to decompress and allow the movement of the pistons back into the calipers?
Forum: Honda Prelude
04-20-2011, 04:34 PM
Replies: 9
Views: 3,018
Posted By Phildo916

Re: New rebuilt H23a1 overheating

I also have used the heater method for short spurts to get her pulled over safe. The AC thing makes sense too, triggering both fans.

As far as the OP goes, thermostat or radiator is likely the...
Forum: Honda Prelude
04-14-2011, 03:40 PM
Replies: 5
Views: 12,823
Posted By Phildo916

Re: B series swap in 92-95 prelude?

Absolutely no b-series engines belong in a 92-2001 prelude. Period. IF you absolutely MUST decrease displacement look into the f20b.

The 4th and 5th gen prelude have bigger, torquier engines...
Forum: Honda Prelude
03-31-2011, 12:04 PM
Replies: 10
Views: 1,032
Posted By Phildo916

Re: bad wiring please heeelp

Buying a new/used in tact harness and doing the job yourself will be FAR less than $1k. Not only that, but the bast way of learning most anything is hands on doing. Wiring isnt as complicated as...
Forum: Honda Prelude
03-29-2011, 01:27 PM
Replies: 23
Views: 10,896
Posted By Phildo916

Re: D2 coilover install - issues with front set

I have had three different suspension setups with the spring being a bit loose when there is no load on the suspension. One of which i drove like a banshee for 3 years (18-21yo) and i have never...
Forum: Honda Prelude
03-22-2011, 12:41 PM
Replies: 4
Views: 2,230
Posted By Phildo916

Re: Radiator and ac fan problems

Ahh, there are two temperature sensors the system uses. One that turns the fans on when the car is running, and another sensor runs the fans when the car is off. The sensor on the thermostat...
Forum: Honda Prelude
03-22-2011, 12:20 PM
Replies: 4
Views: 2,230
Posted By Phildo916

Re: Radiator and ac fan problems

I recently had to change my radiator fan relay to get my fans up and cooling again. Test the relay for the fans and go from there.
Forum: Honda Prelude
03-19-2011, 09:46 PM
Replies: 23
Views: 10,896
Posted By Phildo916

Re: D2 coilover install - issues with front set

The spring should not rattle in place when the car is on the ground and load is on the coilover. When the front of my car is in the air my springs do rattle around and appear to not fit because of...
Forum: Honda Prelude
03-19-2011, 09:22 PM
Replies: 23
Views: 10,896
Posted By Phildo916

Re: D2 coilover install - issues with front set

On my skunk2 sleeve coilovers the front springs arent as tall as the rears when not under load. They appear to be the same diameter with a different number of coils and spring rates.

Im not sure...
Forum: Honda Prelude
03-19-2011, 07:43 PM
Replies: 23
Views: 10,896
Posted By Phildo916

Re: D2 coilover install - issues with front set

I just called my friend to refresh my memory on what was wrong.

It wasnt the whole coilover that was wrong, because as you pointed out, the bolts are different. The SPRINGS were mixed up.

Id...
Forum: Honda Prelude
03-19-2011, 06:39 PM
Replies: 23
Views: 10,896
Posted By Phildo916

Re: D2 coilover install - issues with front set

Are you sure you do not have the rear set of coilovers on the front and visa versa? I have a friend who mixed them up and could completely bottom out the rear, but could barely eliminate the wheel...
Forum: Honda Prelude
03-04-2011, 01:58 AM
Replies: 58
Views: 9,406
Posted By Phildo916

Re: ► WANTED TO BUY ONLY ::.. NO TRIAL USERS, NO COMMENTS, NO PICTURES - Feb/Mar 20

Im on the lookout for a full 2.5" exhaust that will bolt up to the JDM H22a w/ stock downpipe i wish to install in my 93 Prelude Si.
Forum: Honda Prelude
02-27-2011, 01:31 PM
Replies: 14
Views: 7,897
Posted By Phildo916

Re: Just did an h22 swap cant get the car to run right on the p13

Verify you actually have the H22 Injectors on the car.

To me it sounds like the H23 injectors are on the H22. Thats why the P14 runs fine, but the P13 does not.
Forum: Honda Prelude
04-15-2010, 08:33 PM
Replies: 3
Views: 572
Posted By Phildo916

Re: wiring harness?

Are you going for a wire tuck or something else of the sort, or are you just needing a replacement? If you absolutely need another one, id call wrecking yards, and if you cant find any VTEC...
Showing results 1 to 25 of 98
 


 
Forum Jump


All times are GMT -8. The time now is 11:09 AM.