Honda-Tech - Honda Forum Discussion

Notices
 
Page 1 of 4
1
2
3
Last »
Search: Posts Made By: static-x
Showing results 1 to 25 of 94
Search took 0.90 seconds.
Forum: Honda Civic / Del Sol (1992 - 2000)
09-27-2015, 04:43 AM
Replies: 3
Views: 884
Posted By static-x

Re: D15b p28 auto to D16y8?

well upon futher reading it seems i need the P2P auto ecu
Forum: Honda Civic / Del Sol (1992 - 2000)
09-27-2015, 02:33 AM
Replies: 3
Views: 884
Posted By static-x

Icon5 D15b p28 auto to D16y8?

So my brother just found a d16y8 out of a year 2000 civic mounted in a '95 manual civic (not sure the ecu). He wants to know if its an easy swap into his '92 d15b AUTO (p28 ecu). He's about 200 miles...
Forum: Suspension & Brakes
05-31-2014, 09:58 PM
Replies: 6
Views: 2,541
Posted By static-x

Re: 1990 honda crx brake squeal.

Check the brake dust shield it may be bent just a tad bit when installing the brake pads. My front right was actually tweaked just a little bit and it would make a loud squeel when I turned left.
Forum: Suspension & Brakes
05-30-2014, 05:27 PM
Replies: 6
Views: 3,239
Posted By static-x

Re: Diagnose dent/bend in upper control arm

No marks on the springs. What im starting to think is you know that stud on the inside of the knuckle a couple inches or so below the upper ball joint is the only thing that could smack from...
Forum: Suspension & Brakes
05-29-2014, 11:34 PM
Replies: 6
Views: 3,239
Posted By static-x

Re: Diagnose dent/bend in upper control arm

They're tein-ss with the 450lbs up front and 220lbs in rear. Front is a little higher than that, just uneveness of driveway there makes it look lower
...
Forum: Suspension & Brakes
05-28-2014, 07:17 PM
Replies: 6
Views: 3,239
Posted By static-x

Diagnose dent/bend in upper control arm

In the middle of diagnosing ball joints and bushings due to my saw tooth tire wear and i stumbled across this.... Any idea what caused those bends or something to bang there? Both control arms are...
Forum: Honda CRX / EF Civic (1988 - 1991)
07-19-2013, 04:52 PM
Replies: 7
Views: 3,929
Posted By static-x

Re: B16A idle

I'm actually having this same issue at the moment on a stock HF and im stumped after checking for cracks in hoses and cleaning the IACV and bleeding air out of coolant.
Forum: Suspension & Brakes
01-15-2012, 03:07 PM
Replies: 8
Views: 1,461
Posted By static-x

Re: Bad booster or what?

I just did my brothers master cylinder because his was showing the exact same symptoms as yours. Sinks to floor right after you start. Also hoping for an answer
Forum: Honda CRX / EF Civic (1988 - 1991)
10-15-2010, 11:22 PM
Replies: 18
Views: 2,661
Posted By static-x

Re: Stubborn Axle nut

I've always used socket breaker bar with a pipe slipped over it to get that torque. Also had someone step on brakes due to being in a gravel driveway.
Forum: Honda CRX / EF Civic (1988 - 1991)
08-13-2010, 04:20 AM
Replies: 10
Views: 1,060
Posted By static-x

Re: Body Kit Help?

Ya just use the provided tape on the door caps. I've had same kit with the tape holding them on for 10yrs. Never had any probs.
Forum: Suspension & Brakes
08-01-2010, 02:41 PM
Replies: 3
Views: 995
Posted By static-x

Re: Tops hats with tein supersports?

they are shorter and larger they just feel really underdamped and feels like its hitting the bumpstop constantly. I think i might take them off and put my prokit koni back on.
Forum: Suspension & Brakes
08-01-2010, 12:05 PM
Replies: 3
Views: 995
Posted By static-x

Icon2 Tops hats with tein supersports?

Are you able to extend the stock top hat to accompany the larger diameter of the tein supersports shock body without hitting the studs? Ive noticed the shock body of koni's or tokico etc have much...
Forum: Honda CRX / EF Civic (1988 - 1991)
07-02-2010, 01:56 PM
Replies: 1
Views: 1,517
Posted By static-x

91 crx hf, no crank

Trying to help get my moms hf running here. was working fine yesterday. Main relay is good even swapped in mine to double check. Fuses all good only engine code im gettin and have been getting for...
Forum: Honda CRX / EF Civic (1988 - 1991)
06-29-2010, 07:49 AM
Replies: 36
Views: 5,666
Posted By static-x

Re: My Northwest EF Build

I've just been on a cruise with them before and signed up to their site im not part of any car club. I can't do that car club shit i get annoyed to easily by todays youth. I met bruce once at...
Forum: Honda CRX / EF Civic (1988 - 1991)
06-28-2010, 02:35 AM
Replies: 36
Views: 5,666
Posted By static-x

Re: My Northwest EF Build

well hello fellow bend person.
Forum: Suspension & Brakes
06-12-2010, 06:52 PM
Replies: 3
Views: 867
Posted By static-x

Re: Can unproperly seated springs cause this? (pics included)

The bottom (where the coil ends) of the spring should be setting against that part marked with the red arrow. Also make sure your mechanic didnt put the rear springs on the front and vice versa....
Forum: Suspension & Brakes
05-19-2010, 10:22 AM
Replies: 2
Views: 1,687
Posted By static-x

Re: Wheel noise. thoughts?

Certainly sounds like a bad CV joint. Go do some tight left hand circles and if you hear clack clack clack thats def your axle.
Forum: Suspension & Brakes
04-25-2010, 01:00 PM
Replies: 7
Views: 2,775
Posted By static-x

Re: koni shocks...adjustment?

2 full turns clockwise from stiff to soft. Sounds like yours were defective out of the box which is very unlike koni.
Forum: Suspension & Brakes
03-20-2010, 06:54 PM
Replies: 3
Views: 567
Posted By static-x

Re: Question about front subframe and handling

Ya i just checked them. I remember hitting those with an impact gun before. Also just took a torque bar to it and they didnt budge. I think im going to try and find a subframe from a parts car
Forum: Suspension & Brakes
03-19-2010, 08:55 PM
Replies: 3
Views: 567
Posted By static-x

Icon2 Question about front subframe and handling

Is that the name of the part in which the steering rack and lower control arms all bolt to? Also is that fixed into the car not bolted. Reason im asking is ive owned this car for 11yrs. Ive been...
Forum: Suspension & Brakes
01-07-2010, 02:31 PM
Replies: 2
Views: 1,155
Posted By static-x

Re: Recommend a good rear toe adjuster

Nothing is bent actually. Could it be those energy suspension bushings in the trailing arms throwing the toe off? Or is something being bent the only possible cause. Ive had this car for 11yrs now...
Forum: Suspension & Brakes
01-07-2010, 02:21 PM
Replies: 2
Views: 1,155
Posted By static-x

Recommend a good rear toe adjuster

Im needing to get my rear toe fixed since the factory could only adjust to 0.25 on the left and -0.13 on the right. Car is a 91 crx. You guys recommend a good brand to use? Also if my rear toe was...
Forum: Honda Civic / Del Sol (1992 - 2000)
07-22-2009, 07:25 PM
Replies: 0
Views: 385
Posted By static-x

Question aligning new upper balljoint

I just did my bros upper balljoint by pressing out the old one and installing a new. The new one had a dimple on the outside that i assume your suppose to align with something on the control arm. ...
Forum: Honda CRX / EF Civic (1988 - 1991)
07-13-2009, 05:58 PM
Replies: 3
Views: 384
Posted By static-x

Re: HF wont start now...

I got it going. I needed to rotate the distributor 360, had it aligned wrong when i put it back on. Still confused about that tach tho. thx tho
Forum: Honda CRX / EF Civic (1988 - 1991)
07-13-2009, 05:46 PM
Replies: 3
Views: 384
Posted By static-x

Re: HF wont start now...

ya just checked number 1 plug and getting spark and fuel. Im still not understanding why that tach moves up to 250rpm and stays when the key is in the on position before i even try to start the car.
Showing results 1 to 25 of 94
 
Page 1 of 4
1
2
3
Last »


 
Forum Jump


All times are GMT -8. The time now is 03:25 PM.