Honda-Tech - Honda Forum Discussion

Notices
 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: JasonST
Showing results 1 to 25 of 497
Search took 1.16 seconds.
Forum: Honda Prelude
03-21-2013, 05:48 PM
Replies: 11
Views: 4,852
Posted By JasonST

Re: What would cause no spark and no fuel pulse?

Thanks to all who helped. I wanted to wait until I knew for sure what the fix was. It ended up being the distributor. I ended up doing so much electrical diagnosing I didn't do much visual...
Forum: Acura Integra
03-21-2013, 05:46 PM
Replies: 13
Views: 30,145
Posted By JasonST

Re: Help! No spark and no injector pulse

Thanks to all who helped. I wanted to wait until I knew for sure what the fix was. It ended up being the distributor. I ended up doing so much electrical diagnosing I didn't do much visual...
Forum: Acura Integra
03-12-2013, 06:20 AM
Replies: 13
Views: 30,145
Posted By JasonST

Re: Help! No spark and no injector pulse

Hmm, thanks man. Ya my digital multimeter isn't fast enough to tell the pulses in the CPS sensor and other ones, it just read a steady 0.3 volts. And the test light woulkdn't even light up. As far as...
Forum: Honda Prelude
03-11-2013, 06:37 PM
Replies: 11
Views: 4,852
Posted By JasonST

Re: What would cause no spark and no fuel pulse?

The ecu fuse is good, and has voltage to it...

Ok so I checked the crank sensor, camshaft sensor, and TDC sensor, all have 350 ohms which is in specs, and when I crank, I get about 0.3 to 0.4...
Forum: Acura Integra
03-11-2013, 06:35 PM
Replies: 13
Views: 30,145
Posted By JasonST

Re: Help! No spark and no injector pulse

Ok so I checked the crank sensor, camshaft sensor, and TDC sensor, all have 350 ohms which is in specs, and when I crank, I get about 0.3 to 0.4 volts. I couldn't get the test light to light up since...
Forum: Honda Prelude
03-10-2013, 09:26 AM
Replies: 11
Views: 4,852
Posted By JasonST

Re: What would cause no spark and no fuel pulse?

I downloaded the factory service manual and went through the step by step instructions on what to check. Mainly it had me check ecu grounds, power wires, and the main relay and wires, and everything...
Forum: Acura Integra
03-10-2013, 09:25 AM
Replies: 13
Views: 30,145
Posted By JasonST

Re: Help! No spark and no injector pulse

It was pin 1, and it works fine. I forgot to check the voltage while cranking for it to have a signal, and it seams to check out. I downloaded the factory service manual and went through the step by...
Forum: Acura Integra
03-05-2013, 06:38 AM
Replies: 13
Views: 30,145
Posted By JasonST

Re: Help! No spark and no injector pulse

Thanks for the replies. Yes the fuel pump primes, I checked a24 is receiving power from the main relay, and the main relay clicks like it's suppose to. It seams to be working. I finally may have come...
Forum: Honda Prelude
03-05-2013, 06:21 AM
Replies: 11
Views: 4,852
Posted By JasonST

Re: What would cause no spark and no fuel pulse?

K test turned out alright. 5V to map and TPS sensor. I may have found something finally. I checked the other connector on the distributor. I believe it has 7 wires going to it. Do these sensors have...
Forum: Honda Prelude
03-03-2013, 09:57 AM
Replies: 11
Views: 4,852
Posted By JasonST

What would cause no spark and no fuel pulse?

Hey everyone, it's been years since I've posted but I've recently ran into a huge dilema. I've got a 98 teg with an obd1 h22a in it and using stock p13 ecu. It's been reliable and working for 7 years...
Forum: Acura Integra
03-03-2013, 09:54 AM
Replies: 13
Views: 30,145
Posted By JasonST

Help! No spark and no injector pulse

Hey everyone, it's been years since I've posted but I've recently ran into a huge dilema. I've got a 98 teg with an obd1 h22a in it. It's been reliable and working for 7 years now. Just a few days...
Forum: Acura Integra
04-30-2012, 09:04 PM
Replies: 4
Views: 4,124
Posted By JasonST

Re: Alignment off after new wheel bearings. Stumped.

Haha. Alright, thanks guys. I just didn't think that the front knuckles would change the alignment. I suppose I should though, because I can see slight toe in the front wheels and the steering wheel...
Forum: Acura Integra
04-30-2012, 04:51 PM
Replies: 4
Views: 4,124
Posted By JasonST

Alignment off after new wheel bearings. Stumped.

Hey guys. I'm a little stumped on this one. So I had an extra set of front knuckles, I ordered new wheel bearings and got them pressed in by a reputable shop. After swapping out the old knuckles with...
Forum: Want to Buy
06-18-2010, 06:03 AM
Replies: 2
Views: 351
Posted By JasonST

WTB 1 rays black lug nut

I need just 1 rays black lug nut I'm missing 1. I will take a couple if need be but really only need 1. Need really badly!
Forum: Honda S2000
09-27-2009, 02:23 PM
Replies: 2
Views: 1,035
Posted By JasonST

replacing Softop, what is grey foam on rubber trim?

Hey guys I'm in the middle of replacing my 00 soft top with a glass ez on top. I had a question. I'm taking off the window trim pieces and the pieces below it, and there's this sticky foam to help...
Forum: Honda Accord (1990 - 2002)
08-22-2009, 08:05 PM
Replies: 14
Views: 68,707
Posted By JasonST

Re: Alternator belt squeak on startup

Yeah I didn't think there was much that could go wrong. I'll get a new belt and clean the pulleys tomorrow and keep ya posted. Thanks.
-Jason
Forum: Honda Accord (1990 - 2002)
08-22-2009, 07:05 PM
Replies: 14
Views: 68,707
Posted By JasonST

Alternator belt squeak on startup

Hey Guys, I recently changed the timing belt in my friends 98 LX f23a1. Everything went well but when I was all done the alternator belt quickly chirps on startup then goes away. It's been annoying...
Forum: Acura Integra
08-16-2009, 11:42 AM
Replies: 5
Views: 539
Posted By JasonST

Re: H22 swaps

If he used the h series transmission then the center console is cut an extra couple inches (expanded) to be able to use the shifter cables.
Forum: Honda Accord (1990 - 2002)
08-12-2009, 11:56 AM
Replies: 4
Views: 4,536
Posted By JasonST

Re: F23a1 timing belt write up?

Thank you TouringAccord for clarifying that up for me!
Forum: Honda Accord (1990 - 2002)
08-10-2009, 09:20 PM
Replies: 4
Views: 4,536
Posted By JasonST

F23a1 timing belt write up?

Hey guys, I'm doing a timing belt job on a friends cars very soon.I looked through the FAQ's and couldn't find a write up and searched with no luck. I'm not able to get a helms for it in time, I was...
Forum: Honda Accord (1990 - 2002)
06-29-2009, 09:47 PM
Replies: 2
Views: 541
Posted By JasonST

Re: Help! dizzy shaft not lining up with housing

I don't see how it could have skipped a tooth. I never touched the timing components or the camshaft. Just took the dizzy out to replace the ignitor and put it back in. I don't think I can time it...
Forum: Honda Accord (1990 - 2002)
06-29-2009, 08:09 PM
Replies: 2
Views: 541
Posted By JasonST

Help! dizzy shaft not lining up with housing

So I've got an odd problem. I've got a 95 Ex with the v6, and the ignitor started to go out on me when the car would warm up. So I just replaced it, but now I've got a strange problem. The car...
Forum: Honda Prelude
05-18-2009, 08:24 PM
Replies: 91
Views: 6,842
Posted By JasonST

Re: h22a too slow!! v6!!!!

If you want more torque, why not stroke the h22 or an h23 out, then put a supercharger on it. That'l give you plenty of torque plus be more cost effective and save you the headaches of trying to put...
Forum: Honda CRX / EF Civic (1988 - 1991)
05-15-2009, 11:33 AM
Replies: 7
Views: 485
Posted By JasonST

Re: Electrical issue with guage cluster after taking out dash

Wow thanks prettymicky for the help. That's exactly what it was. those 2 connectors going to the fuse box underneath the dash were swtiched, and they had the same number of pins. Switched em around...
Forum: Honda CRX / EF Civic (1988 - 1991)
05-14-2009, 10:01 PM
Replies: 7
Views: 485
Posted By JasonST

Re: Electrical issue with guage cluster after taking out dash

Thanks, I'll check this out tomorrow morning! I'll keep you updated.
Showing results 1 to 25 of 497
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump


All times are GMT -8. The time now is 07:05 AM.