Notices
 
Search: Posts Made By: freakasis
Showing results 1 to 25 of 493
Search took 2.12 seconds.
02-24-2014, 11:11 AM
Replies: 5
Views: 576
Posted By freakasis

Re: z6 trans internals fit in b7 casing?

OK. Thanks guys. I guess helicoils it is.
02-24-2014, 08:47 AM
Replies: 5
Views: 576
Posted By freakasis

z6 trans internals fit in b7 casing?

I have a z6 trans with good gears and a bad bearing, so I'm going to have to open it. Also, every single damn bolt hole on the outside of the casing is stripped out. can I put all of the internals in...
09-03-2012, 06:17 AM
Replies: 5
Views: 3,140
Posted By freakasis

Re: How to fix EG manual mirrors?

Ok, so is there now way to fix them? Thinking about putting on the power ones and just moving them by hand since the power ones don't seem to have this problem.
09-03-2012, 06:07 AM
Replies: 443
Views: 52,880
Posted By freakasis

Re: Tell Us Your Story: How Did You Get Into This Honda Stuff?

Helped my friend Jorge put in some work on his EG Hatch SOHC VTEC turbo. I kinda liked how the car was engineered. It was like the designers knew we would be working on them and made the car...
09-03-2012, 05:52 AM
Replies: 5
Views: 3,140
Posted By freakasis

How to fix EG manual mirrors that are loose and fold in while driving?

My mirrors have the all too common problem of being loose and folding in while driving. I searched but could not find any real fixes. Just screws put through the plastic and whatnot. Does anyone know...
02-13-2010, 07:25 AM
Replies: 7
Views: 2,545
Posted By freakasis

Re: Integra calipers on ek knuckles

finally someone who knew.....thank you.
02-01-2010, 05:12 PM
Replies: 2
Views: 465
Posted By freakasis

Re: What does this mean? Help

popped a head gasket or worse...youre gonna have to take the engine apart. good luck.
02-01-2010, 05:09 PM
Replies: 4
Views: 1,017
Posted By freakasis

Re: M/T Bseries Swap: Which Rear mount for Dx chassis?

if your talking about the mount part that has the rubber in it, theyre all the same. it doesnt matter

if youre talking about the mount bracket you must use a b-series one. on a side note, you will...
02-01-2010, 03:03 PM
Replies: 7
Views: 2,545
Posted By freakasis

Integra calipers on ek knuckles

is it possible with the integra caliper brackets? or do i need integra spindles as well? the brakes i have the integra sized rotor but have a smaller caliper piston (2000 civic ex) so i would assume...
02-01-2010, 03:00 PM
Replies: 9
Views: 19,593
Posted By freakasis

Re: Ek brake conversion with integra one questions???

dont try an use the integra brake hoses up front. they will rub....get ones from a 99-00SI because the location of the hard line is differant on an ek, which makes the hose a differant length.
01-31-2010, 06:36 PM
Replies: 2
Views: 675
Posted By freakasis

Re: vtec head on non-v block

i figured, but didnt want to pull it out and get stuck 1/2 way through
01-31-2010, 05:48 PM
Replies: 2
Views: 675
Posted By freakasis

vtec head on non-v block

my engine started knocking in my 95 accord ex. there are a few wrecked non-vtec accords at my local junk yard. was wondering if i can use the short block from any of these with my head, similar to...
01-04-2010, 08:05 PM
Replies: 20
Views: 2,857
Posted By freakasis

Re: d16z6 and d15b issue

think of it this way. if you had the d15 manifold on there and it had an extra barb for an extra hose, what would you do with it? cap it off, right? because you couldnt do anything else with it. so...
01-03-2010, 09:35 AM
Replies: 18
Views: 4,633
Posted By freakasis

Re: throttle body sticks closed sometimes

yes the throttle plate is screwed on tight. i will try and adjust the stop later and let you know what happens
01-03-2010, 05:08 AM
Replies: 18
Views: 4,633
Posted By freakasis

Re: throttle body sticks closed sometimes

you mean the whole circumfrance where its getting stuck at? i dont have a problem adjusting the stop, if you think that will fix it.
01-02-2010, 07:44 PM
Replies: 15
Views: 2,719
Posted By freakasis

Re: WOT Rev Issues

did you set it at TDC with the mark on the crank pulley? because the timing looks off, but if you set it with the crank pulley off its hard to get it lined up perfectly. put the crank pulley and...
12-30-2009, 04:36 PM
Replies: 15
Views: 2,719
Posted By freakasis

Re: WOT Rev Issues

also your TPS readings are off, should be 0.5 closed and 4.5 open.
12-30-2009, 04:33 PM
Replies: 15
Views: 2,719
Posted By freakasis

Re: WOT Rev Issues

did you do the vx o2 sensor fix? does your check engine light work? did you check the timing? how to you know its running too rich? does the exhaust smell like gas? leaky injector(s)?
12-30-2009, 05:46 AM
Replies: 17
Views: 16,159
Posted By freakasis

Re: does any one know the part # for civic hood insulator????

nice, and thanks for looking that up. but all they did was test the flamibility of the insulators themselves, not whether or not they can put out a fire. and the people conducting the tests knew that...
Showing results 1 to 25 of 493
 


 
Forum Jump


All times are GMT -8. The time now is 07:21 AM.