Honda-Tech - Honda Forum Discussion

Notices
 
Page 1 of 2
1
2
Search: Posts Made By: Shehzada
Showing results 1 to 25 of 30
Search took 0.90 seconds.
Forum: Tech / Misc
12-07-2010, 04:37 PM
Replies: 45
Views: 343,370
Posted By Shehzada

Re: Civic door won't open from inside or outside FIX (no drilling)

Hey guys,

I have a 1992 Accord Coupe. The issue is the driver's side door and I already have the door panel off.

I'm looking at the lock mechanism and it looks similar to the photos Mibignu...
Forum: Honda Accord (1990 - 2002)
12-01-2009, 12:42 PM
Replies: 23
Views: 8,938
Posted By Shehzada

Re: Hunting Idle. Cleaned IACV and FITV.

Good job on fixing your car. Feels good right? I'm been fixing my CB7 for the past 5 years. :)
Forum: Honda Accord (1990 - 2002)
11-29-2009, 03:25 PM
Replies: 10
Views: 1,600
Posted By Shehzada

Re: 1992 Accord No start/spark! Help!

civicboisi,

Your ignitor needs to be replaced ($70-$80). Hopefully its been repaired by now.
Forum: Honda Accord (1990 - 2002)
11-29-2009, 09:25 AM
Replies: 23
Views: 8,938
Posted By Shehzada

Re: Hunting Idle. Cleaned IACV and FITV.

http://www.cb7tuner.com/vbb/showthread.php?t=52454

I took a small spray bottle, filled it with water, and spray at all the vacuum lines while the car was running. As soon as I got to where the...
Forum: Honda Accord (1990 - 2002)
11-28-2009, 11:12 PM
Replies: 1
Views: 944
Posted By Shehzada

Re: having problem with RPM

Open up your carb and spray some carb cleaner down the throat. Make sure your air filter is new and clean.
Forum: Honda Accord (1990 - 2002)
11-28-2009, 11:08 PM
Replies: 23
Views: 8,938
Posted By Shehzada

Re: Hunting Idle. Cleaned IACV and FITV.

I had this issue a while back. I replaced my IACV and adjusted the FITV. No change.

It turned out my IM gasket was bad and creating a vacuum leak.
Forum: Honda Accord (1990 - 2002)
11-28-2009, 07:54 PM
Replies: 0
Views: 688
Posted By Shehzada

[Solved]: Cranks Fine....But Doesn't Start - Ignition Troubleshooting

My 1992 CB7 5-Speed was running fine until Tuesday. I started it up and drove it about a half mile and as I was parking it in the lot, it stalled. It cranked fine but would not fire. I opened the...
Forum: Suspension & Brakes
04-09-2009, 07:28 AM
Replies: 105
Views: 70,909
Posted By Shehzada

Re: How To: Replace Rear Trailing Arm Bushing- Cool Tool I found Saves Allot of time

The drive shaft idea is a good one and probably would work for taking out the bushings. However to drive them back in (evenly and properly)......I think that tool is a must.

They have an updated...
Forum: Honda Accord (1990 - 2002)
08-05-2008, 05:04 PM
Replies: 9
Views: 3,869
Posted By Shehzada

Re: Things for a T-belt replacement (tpot90)

I'm getting my T-Belt done in a few days also. I have an F22A1 and its going to be my second T-Belt service. I am replacing everthing including the springs. They are only a few bucks and not worth...
Forum: Honda Accord (1990 - 2002)
05-27-2006, 09:10 PM
Replies: 13
Views: 20,015
Posted By Shehzada

Re: (BLKFLSH)

Can I please ask you where did you purchase your "cam tower o-rings" https://honda-tech.com/forums/images/smilies/emsmile.gif ?
Forum: Honda Accord (1990 - 2002)
02-10-2005, 06:33 PM
Replies: 29
Views: 9,565
Posted By Shehzada

Re: Flushing Radiator With Garden Hose (blueaccord90)

How many mechanics and radiator specialty shops do you think use distilled water? I agree with you 100% (I recently used nothing but distilled) but u have wonder whether or not tap water is that bad.
Forum: Honda Accord (1990 - 2002)
02-09-2005, 11:46 AM
Replies: 29
Views: 9,565
Posted By Shehzada

Re: Flushing Radiator With Garden Hose (GuyverZen)

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by GuyverZen &raquo;</TD></TR><TR><TD CLASS="quote">Which year and model of Accord is it that you were...
Forum: Honda Accord (1990 - 2002)
02-07-2005, 07:16 PM
Replies: 29
Views: 9,565
Posted By Shehzada

Re: Flushing Radiator With Garden Hose (JimBlake)

Jim, you are right. That bolt I suspected does have a big flange around it. Doing it in my driveway, I could not get good leverage to get at that bolt. Is it even worth it to remove that drain...
Forum: Honda Accord (1990 - 2002)
02-06-2005, 05:10 PM
Replies: 29
Views: 9,565
Posted By Shehzada

Re: Flushing Radiator With Garden Hose (iam7head)

Yes. I did thoroughly bleed the system.

As for the engine block coolant drain plug, I got confused because some say that it just takes a 3/8 rachet <U>and no socket </U>and say that it is inches...
Forum: Honda Accord (1990 - 2002)
02-06-2005, 04:52 PM
Replies: 29
Views: 9,565
Posted By Shehzada

Re: Flushing Radiator With Garden Hose (Schmitey)

After pressure testing my old radiator, it turns out there was a hairline leak at the top. Since it was the original Denso factory installed, I purchased a replacement one.

I drained the coolant...
Forum: Honda Accord (1990 - 2002)
01-22-2005, 06:10 AM
Replies: 15
Views: 2,022
Posted By Shehzada

Re: (pnut)

Currently the torque rod mount on my car does have heat shields. But the mount looks like an aftermarket mount and I wanted to replace it with a Honda mount. I bought the car 2 weeks ago and the...
Forum: Honda Accord (1990 - 2002)
01-20-2005, 04:23 PM
Replies: 15
Views: 2,022
Posted By Shehzada

Re: (project95gsr)

http://www.rockauto.com/catalo...up=20...
Forum: Honda Accord (1990 - 2002)
01-20-2005, 04:02 PM
Replies: 15
Views: 2,022
Posted By Shehzada

Re: (v4lu3s)

According to the exploded diagrams at Majestic Honda, it says that it is supposed to come with 2 heat shields. Shouldn't the bolt hole be supported by more than just the blue area. It seems like...
Forum: Honda Accord (1990 - 2002)
01-20-2005, 02:49 PM
Replies: 15
Views: 2,022
Posted By Shehzada

Re: Honda Part #50830-SM4-020 question (pnut)

Okay. Now here is a picture of what I received. There are no rubber heat shields included.

http://home.earthlink.net/~shehzada/images/100-0093_IMG.JPG...
Forum: Honda Accord (1990 - 2002)
01-19-2005, 05:29 PM
Replies: 15
Views: 2,022
Posted By Shehzada

Re: Honda Part #50830-SM4-020 question (pnut)

Thanks Bro. I will appreciate it.
Forum: Honda Accord (1990 - 2002)
01-19-2005, 03:53 PM
Replies: 6
Views: 1,365
Posted By Shehzada

Re: where to buy online for a starter for 91 accord ex? (91accordwagon)

Try this place: http://www.rockauto.com They have some of the best prices anywhere and they do carry some HONDA OEM parts.
Forum: Honda Accord (1990 - 2002)
01-19-2005, 03:29 PM
Replies: 15
Views: 2,022
Posted By Shehzada

Honda Part #50830-SM4-020 question

The above part number is for the front engine mount (also known as torque rod) for a 1992 LX Coupe Manual Tranny.

My question is that is it supposed to come with the 2 rubber heat shields that go...
Forum: Honda Prelude
01-12-2005, 07:00 PM
Replies: 6
Views: 310
Posted By Shehzada

Re: Clutch/Tranny Fluid (eK9aT10pSi)

I have a 92 LX that is difficult to get into 1st gear and grinds when put into 3rd. All the other gears are very smooth to get into. I bought it 2 weeks ago and wanted to know if switching to...
Forum: Honda Accord (1990 - 2002)
01-10-2005, 08:40 PM
Replies: 29
Views: 9,565
Posted By Shehzada

Re: Flushing Radiator With Garden Hose (Schmitey)

Schmitey, thanks so much for your tips. I will be sure to follow them.
However, do I shoot water through the lower radiator hose or the upper? Which way does the coolant circulate? Does it...
Forum: Honda Accord (1990 - 2002)
01-10-2005, 06:54 PM
Replies: 29
Views: 9,565
Posted By Shehzada

Flushing Radiator With Garden Hose

I want to flush the radiator in my 92 LX. I have read the threads that say to drain and refill a couple times to get everything out

However, I want to spray a steady stream of water down the...
Showing results 1 to 25 of 30
 
Page 1 of 2
1
2


 
Forum Jump


All times are GMT -8. The time now is 06:13 AM.